A novel flux-weakening control method based on single current regulator for permanent magnet synchronous motor

Traditional flux-weakening control algorithms for PMSM (permanent magnet synchronous motor) apply two independent current regulators. The two current regulators conflict with each other in high speed operation region, leading to worse system performance. Based on the d-q current cross-coupling effect, deep flux-weakening control of PMSM can be achieved by using single current regulator. Q-axis voltage given scheme is a key issue of this method, which influences PMSM's voltage utilization ratio, efficiency and load capability. This paper presents a new qaxis voltage given method. It can adjust q-axis voltage to motor operating condition. This method does not depend on motor parameters or look-up table, is easy to achieve. This method is verified by the results of simulation and experiment.

[1]  Wen Xuhui,et al.  Deep field-weakening control of PMSMs for both motion and generation operation , 2011, 2011 International Conference on Electrical Machines and Systems.

[2]  Longya Xu,et al.  A new method to optimize q-axis voltage for deep flux weakening control of IPM machines based on single current regulator , 2008, 2008 International Conference on Electrical Machines and Systems.

[3]  Xuhui Wen,et al.  A new deep field-weakening strategy of IPM machines based on single current regulator and voltage angle control , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[4]  Seung-Ki Sul,et al.  Field weakening control of interior permanent magnet machine using improved current interpolation technique , 2006 .

[5]  Longya Xu,et al.  Experimental verification of deep flux-weakening operation of a 50 kW IPM machine by using single current regulator , 2009, 2009 IEEE Energy Conversion Congress and Exposition.

[6]  Seung-Ki Sul,et al.  New field weakening technique for high saliency interior permanent magnet motor , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[7]  H. Fujimoto,et al.  A Precise Model-Based Design of Voltage Phase Controller for IPMSM , 2013, IEEE Transactions on Power Electronics.

[8]  Seung-Ki Sul,et al.  Speed control of interior permanent magnet synchronous motor drive for the flux weakening operation , 1997 .

[9]  Z. X. Fu.  Pseudo constant power times speed operation in the field weakening region of IPM synchronous machines , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[10]  Longya Xu,et al.  Efficiency-Optimized Flux-Weakening Control of PMSM Incorporating Speed Regulation , 2007, 2007 IEEE Power Electronics Specialists Conference.

[11]  Seung-Ki Sul,et al.  Speed control of interior permanent magnet synchronous motor drive for flux weakening operation , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[12]  M. Alakula,et al.  A compact field weakening controller implementation , 2006, International Symposium on Power Electronics, Electrical Drives, Automation and Motion, 2006. SPEEDAM 2006..

[13]  S.-M. Sue,et al.  A linear maximum torque per ampere control for IPMSM drives over full-speed range , 2005, IEEE Transactions on Energy Conversion.

[14]  Shigeo Morimoto,et al.  Wide-speed operation of interior permanent magnet synchronous motors with high-performance current regulator , 1994 .

[15]  Frede Blaabjerg,et al.  Wide speed range sensorless control of PM-RSM via “active flux model” , 2009, 2009 IEEE Energy Conversion Congress and Exposition.