Simplified explicit calculation algorithms for determining the performance of refrigerant coils in vapour-compression systems

Abstract Simplified explicit calculation algorithms were proposed for determining the performance of the condenser, evaporator and air cooler in a vapour-compression system based on a zone-model approach. It was assumed that the fluid temperature changes in the sub-cooled and superheated portions were small and that the wet portion of an air cooler only occurred in the entire saturated portion if it was not fully-dry. With R134a employed as the refrigerant, the simulated coil capacity based on the present modelling approach were compared with those based on a multi-node numerical approach at different refrigerant mass flow rates. It was found that the errors in the simulated specific enthalpy change of the refrigerant across the coil did not exceed 3.6% in all cases. In particular, the errors incurred by employing the present modelling approach in simulating the capacity and compressor power input of a sample water-cooled chiller at different condenser and evaporator fluid entering temperatures were less than 2.7% and 3.1% respectively. This showed that the present approach could be a good choice for improving the computation efficiency of a vapour-compression system significantly while the accuracy of the simulation could still be maintained at an acceptable level.

[1]  C. K. Lee,et al.  Computer simulation of ground-coupled liquid desiccant air conditioner for sub-tropical regions , 2009 .

[2]  Adlane Bendaoud,et al.  A new modeling procedure for circuit design and performance prediction of evaporator coils using CO2 as refrigerant , 2010 .

[3]  Daniel Favrat,et al.  Prototype of a thermally driven heat pump based on integrated Organic Rankine Cycles (ORC) , 2012 .

[4]  Giacomo Salvadori,et al.  Performance of an air-cooled steam condenser for a waste-to-energy plant over its whole operating range , 2011 .

[5]  Guoliang Ding,et al.  Recent developments in simulation techniques for vapour-compression refrigeration systems , 2007 .

[6]  Jeffrey D. Spitler,et al.  A Parameter Estimation Based Model of Water-to-Water Heat Pumps for Use in Energy Calculation Programs , 2002 .

[7]  Yunting Ge,et al.  Performance evaluations of air-cooled condensers using pure and mixture refrigerants by four-section lumped modelling methods , 2005 .

[8]  J. Chato,et al.  Condensation in Smooth Horizontal Tubes , 1998 .

[9]  Rui Pitanga Marques,et al.  Steady‐state simulation of vapour‐compression heat pumps , 1993 .

[10]  F. W. Yu,et al.  Part load performance of air-cooled centrifugal chillers with variable speed condenser fan control , 2007 .

[11]  Ming-yin Chan,et al.  Dehumidification effects in the superheated region (SPR) of a direct expansion (DX) air cooling coil , 2009 .

[12]  Chun Kwong Lee,et al.  An Equivalent-Capacitance Approach for Determining the Performance of a Refrigerant Coil , 2014 .

[13]  R. Shah.  Laminar Flow Forced convection in ducts , 1978 .

[14]  Teck Neng Wong,et al.  Experimental validation of model predictions on evaporator coils with an emphasis on fin efficiency , 2010 .

[15]  J.A.R. Parise,et al.  A three-zone simulation model for a air-cooled condensers , 1993 .

[16]  Jerald D. Parker,et al.  Heating, Ventilating, and Air Conditioning: Analysis and Design , 1977 .

[18]  Chun-Lu Zhang,et al.  A general steady state mathematical model for fin-and-tube heat exchanger based on graph theory , 2004 .

[19]  Piotr A. Domanski,et al.  Mathematical model of an air-to-air heat pump equipped with a capillary tube , 1984 .

[20]  K. Gungor,et al.  A general correlation for flow boiling in tubes and annuli , 1986 .

[21]  P. Gupta,et al.  Experimental research on heat transfer coefficients for cryogenic cross-counter-flow coiled finned-tube heat exchangers , 2009 .

[22]  Refrigerating.  ASHRAE handbook of fundamentals , 1967 .

[23]  Eiji Hihara,et al.  Prediction of air coil performance under partially wet and totally wet cooling conditions using equivalent dry-bulb temperature method , 2002 .

[24]  V. Gnielinski.  New equations for heat and mass transfer in turbulent pipe and channel flow , 1976 .

[25]  Per Fahlén,et al.  Capacity-controlled ground source heat pumps in hydronic heating systems , 2007 .