Potential health risk for residents around a typical e-waste recycling zone via inhalation of size-fractionated particle-bound heavy metals.

Health risk of residents dwelling around e-waste recycling zones has been a global concern, but has not been adequately examined. The present study was intended to evaluate the potential health risk of residents through inhalation exposure to size-fractionated particle-bound heavy metals in a typical e-waste recycling zone, South China. Anthropogenic metals (Zn, Se, Pb, Sb, As, and Cd) were predominantly enriched in fine particles (Dp<1.8μm), whereas the crustal elements (Ti, Fe, and Co) tended to accumulate in coarse particles (Dp>1.8μm). Although the daily inhalation intakes of the target metals were significantly lower than those through food consumption and ingestion of house dust, the hazard quotients of total metals for adults (95% CI: 1.0-5.5) and children (95% CI: 3.0-17) were greater than 1. Moreover, the incremental lifetime cancer risks of five carcinogenic metals (Cr, Co, Ni, As, and Cd) for adults and children were 1.3×10(-3) (95% CI: 4.1×10(-4)-3.0×10(-3)) and 3.9×10(-3) (95% CI: 1.3×10(-3)-8.6×10(-3)), respectively, substantially higher than the acceptable cancer risk range of 10(-6)-10(-4). All these findings suggested that health risks were high for local residents dwelling around the e-waste recycling zone through inhalation exposure to particle-bound heavy metals, for both adults and children.

[1]  M Matti Maricq,et al.  Airborne brake wear debris: size distributions, composition, and a comparison of dynamometer and vehicle tests. , 2003, Environmental science & technology.

[2]  L. Daniele,et al.  Analysis of raw soils and their re-suspended PM10 fractions: Characterisation of source profiles and enrichment factors , 2012 .

[3]  Changjiang Huang,et al.  Heavy metal contamination from electronic waste recycling at Guiyu, Southeastern China. , 2009, Journal of environmental quality.

[4]  R. Balasubramanian,et al.  PM2.5 Emissions from Hand-Held Sparklers: Chemical Characterization and Health Risk Assessment , 2014 .

[5]  Zhenming Xu,et al.  Assessment of noise and heavy metals (Cr, Cu, Cd, Pb) in the ambience of the production line for recycling waste printed circuit boards. , 2012, Environmental science & technology.

[6]  Jiamo Fu,et al.  Atmospheric levels and cytotoxicity of PAHs and heavy metals in TSP and PM2.5 at an electronic waste recycling site in southeast China , 2006 .

[7]  Shirong Liu,et al.  Characteristics and Sources of Metals in TSP and PM2.5 in an Urban Forest Park at Guangzhou , 2014 .

[8]  Fei Song,et al.  Size distributions of trace elements associated with ambient particular matter in the affinity of a major highway in the New Jersey–New York metropolitan area , 2011 .

[9]  Shao-Meng Li,et al.  Size-dependent atmospheric deposition and inhalation exposure of particle-bound organophosphate flame retardants. , 2016, Journal of hazardous materials.

[10]  Ruediger Kuehr,et al.  The Global E-waste Monitor 2017: Quantities, Flows and Resources , 2015 .

[11]  Quan Zhang,et al.  Risk assessment of polychlorinated biphenyls and heavy metals in soils of an abandoned e-waste site in China. , 2014, Environmental pollution.

[12]  Zhenming Xu,et al.  Disposing and recycling waste printed circuit boards: disconnecting, resource recovery, and pollution control. , 2015, Environmental science & technology.

[13]  Guoying Sheng,et al.  The major components of particles emitted during recycling of waste printed circuit boards in a typical e-waste workshop of South China , 2010 .

[14]  Shao-Meng Li,et al.  Size-dependent dry deposition of airborne polybrominated diphenyl ethers in urban Guangzhou, China. , 2012, Environmental science & technology.

[15]  Jinhui Li,et al.  A review on human health consequences of metals exposure to e-waste in China. , 2015, Environmental pollution.

[16]  Icrp.  Human Respiratory Tract Model for Radiological Protection , 1994 .

[17]  R. Vincent,et al.  Concentration Distribution and Bioaccessibility of Trace Elements in Nano and Fine Urban Airborne Particulate Matter: Influence of Particle Size , 2010 .

[18]  Adnan Aydin,et al.  Evidence of excessive releases of metals from primitive e-waste processing in Guiyu, China. , 2007, Environmental pollution.

[19]  Rajasekhar Balasubramanian,et al.  2013 Southeast Asian smoke haze: fractionation of particulate-bound elements and associated health risk. , 2014, Environmental science & technology.

[20]  Leiming Zhang,et al.  A size-segregated particle dry deposition scheme for an atmospheric aerosol module , 2001 .

[21]  M. L. Laucks,et al.  Aerosol Technology Properties, Behavior, and Measurement of Airborne Particles , 2000 .

[22]  J. Schnoor,et al.  E-waste recycling: where does it go from here? , 2012, Environmental science & technology.

[23]  F. Zereini,et al.  Characterizing metal(loid) solubility in airborne PM10, PM2.5 and PM1 in Frankfurt, Germany using simulated lung fluids , 2014 .

[24]  J. Schauer,et al.  Particle size distributions of metal and non-metal elements in an urban near-highway environment , 2011 .

[25]  A. Turner,et al.  Bioaccessibility of metals in dust from the indoor environment: application of a physiologically based extraction test. , 2007, Environmental science & technology.

[26]  R. Hillamo,et al.  Size distributions of mass and chemical components in street-level and rooftop PM1 particles in Helsinki , 2003 .

[27]  L. Ma,et al.  Correlation of in vivo relative bioavailability to in vitro bioaccessibility for arsenic in household dust from China and its implication for human exposure assessment. , 2014, Environmental science & technology.

[28]  Martin Goosey,et al.  Recycling technologies for the treatment of end of life printed circuit boards (PCBs) , 2003 .

[29]  Xijin Xu,et al.  Decreased blood hepatitis B surface antibody levels linked to e-waste lead exposure in preschool children. , 2015, Journal of hazardous materials.

[30]  S. Gialanella,et al.  Present knowledge and perspectives on the role of copper in brake materials and related environmental issues: A critical assessment. , 2015, Environmental pollution.

[31]  Tiina Reponen,et al.  Heavy metals in PM2.5 and in blood, and children's respiratory symptoms and asthma from an e-waste recycling area. , 2016, Environmental pollution.

[32]  Qingbin Song,et al.  Environmental effects of heavy metals derived from the e-waste recycling activities in China: a systematic review. , 2014, Waste management.

[33]  Xianlai Zeng,et al.  Perspective of electronic waste management in China based on a legislation comparison between China and the EU , 2013 .

[34]  Shao-Meng Li,et al.  Health risk characterization for resident inhalation exposure to particle-bound halogenated flame retardants in a typical e-waste recycling zone. , 2014, Environmental science & technology.

[35]  Ke-hui Chen,et al.  Heavy metals in food, house dust, and water from an e-waste recycling area in South China and the potential risk to human health. , 2013, Ecotoxicology and environmental safety.

[36]  Roy M Harrison,et al.  Trace metal concentrations and water solubility in size-fractionated atmospheric particles and influence of road traffic. , 2006, Environmental science & technology.

[37]  Bo Yuan,et al.  Influence of e-waste dismantling and its regulations: temporal trend, spatial distribution of heavy metals in rice grains, and its potential health risk. , 2013, Environmental science & technology.