Effect of contaminants on mass transfer coefficients in bubble column and airlift contactors

Abstract In this work, the effects of surface-active contaminants on mass transfer coefficients k L a and k L were studied in two different bubble contactors. The oxygen transfer coefficient, k L , was obtained from the volumetric oxygen transfer coefficient, k L a , since the specific interfacial area, a , could be determined from the fractional gas holdup, e , and the average bubble diameter, d 32 . Water at different heights and antifoam solutions of 0.5– 100 ppm were used as working media, under varying gas sparging conditions, in small-scale bubble column and rectangular airlift contactors of 6.7 and 0.85×10 −3 m 3 capacity, respectively. Both the antifoam concentration and the bubble residence time were shown to control k L a and k L values over a span of almost 400%. A theoretical interpretation is proposed based on modelling the kinetics of single bubble contamination, followed by sudden surface transition from mobile to rigid condition, in accordance with the stagnant cap model. Model results match experimental k L data within ±30%.

[1]  K. Koide,et al.  Mass transfer from single bubbles in Newtonian liquids , 1974 .

[2]  C. Maia,et al.  Effect of antifoam addition on gas-liquid mass transfer in stirred fermenters , 1999 .

[3]  Alain Liné,et al.  Modelling of mass transfer coefficient KL in bubble columns , 1995 .

[4]  S. Iwamoto,et al.  Mass transfer from single bubbles in aqueous solutions of surfactants , 1976 .

[5]  M. Moo-Young,et al.  The effect of antifoam agents on mass transfer in bioreactors , 1990 .

[6]  G. Jameson,et al.  Mass transfer from very small bubbles—the optimum bubble size for aeration , 1978 .

[7]  M. Moo-young,et al.  The continuous phase heat and mass transfer properties of dispersions , 1961 .

[8]  A. Adamson.  Physical chemistry of surfaces , 1960 .

[9]  Kiyomi Akita,et al.  Bubble Size, Interfacial Area, and Liquid-Phase Mass Transfer Coefficient in Bubble Columns , 1974 .

[10]  P. Calderbank,et al.  Mass transfer in the continuous phase around axisymmetric bodies of revolution , 1964 .

[11]  Yanru Wang,et al.  Comparison of the hydrodynamics and mass transfer characteristics of a modified square airlift reactor with common airlift reactors , 2000 .

[12]  R. M. Griffith.  Mass transfer from drops and bubbles , 1960 .

[13]  J. Heijnen,et al.  Mass transfer, mixing and heat transfer phenomena in low viscosity bubble column reactors , 1984 .

[14]  Donald Nelson Miller,et al.  Interfacial area, bubble coalescence and mass transfer in bubble column reactors , 1983 .

[15]  E. Schlünder,et al.  Physical absorption of single gas bubbles in degassed and preloaded water , 1985 .

[16]  Donald G. Mercer,et al.  Flow characteristics of a pilot‐scale airlift fermentor , 1981 .

[17]  Stefan A. Zieminski,et al.  Mass transfer and drag coefficients of bubbles rising in dilute aqueous solutions , 1971 .

[18]  M. Moo-Young,et al.  AIRLIFT REACTORS: CHARACTERISTICS, APPLICATIONS AND DESIGN CONSIDERATIONS , 1987 .

[19]  A. Humphrey,et al.  Mass Transfer from Individual Gas Bubbles , 1961 .

[20]  K. Koide,et al.  EFFECTS OF SURFACE-ACTIVE SUBSTANCES ON GAS HOLDUP AND GAS-LIQUID MASS TRANSFER IN BUBBLE COLUMN , 1985 .

[21]  G. Houghton,et al.  Mass transfer and velocity of rise phenomena for single bubbles , 1963 .

[22]  P. Calderbank,et al.  Mass transfer coefficients, velocities and shapes of carbon dioxide bubbles in free rise through distilled water , 1964 .

[23]  M. Baird,et al.  Gas absorption by large rising bubbles , 1962 .

[24]  S. A. Zieminski,et al.  Experimental study of the behavior of single bubbles , 1968 .

[25]  R. Clift,et al.  Bubbles, Drops, and Particles , 1978 .

[26]  Yoshinori Kawase,et al.  Correlations for liquid-phase mass transfer coefficients in bubble column reactors with newtonian and non-newtonian fluids , 1992 .

[27]  A. Yabe,et al.  Rising speed and dissolution rate of a carbon dioxide bubble in slightly contaminated water , 1999, Journal of Fluid Mechanics.

[28]  Johannes Tramper,et al.  Basic Bioreactor Design , 1991 .

[29]  I. G. Currie,et al.  Laser‐Doppler measurements of bubble dynamics , 1984 .

[30]  R. M. Griffith.  The effect of surfactants on the terminal velocity of drops and bubbles , 1962 .

[31]  F. Durst,et al.  The determination of mass transfer rates from individual small bubbles , 1991 .

[32]  Michel Roustan,et al.  A comparative study of gas hold-up, bubble size, interfacial area and mass transfer coefficients in stirred gas–liquid reactors and bubble columns , 2001 .

[33]  Y. Yang,et al.  Surface effects and mass transfer in bubble column , 1986 .

[34]  R. Rowell,et al.  Physical Chemistry of Surfaces, 6th ed. , 1998 .

[35]  J. Vasconcelos,et al.  Gas–liquid mass transfer to single bubbles: Effect of surface contamination , 2002 .

[36]  A. Prokop,et al.  Review of Methods for the Measurement of Oxygen Transfer in Microbial Systems , 1982 .

[37]  Yatish T. Shah,et al.  Design parameters estimations for bubble column reactors , 1982 .

[38]  E. Barnhart,et al.  The effect of organic substances on the transfer of oxygen from air bubbles in water , 1961 .

[39]  M. Baird,et al.  Characteristics of a countercurrent reciprocating plate bubble column. II. Axial mixing and mass transfer , 1988 .