Wear of metals at high sliding speeds

Abstract High speed sliding wear of AISI 1020 steel, AISI 304 stainless steel and commercially pure titanium (75A) was studied using a pin-on-ring geometry. All the tests were carried out in air without any lubricant. The sliding speed was 0.5–10.0 m s−1 and the normal force was 49.0 N (5 kgf). The friction coefficient of all the materials tested decreased with the sliding speed; this appears to be a consequence of oxide formation. The wear rate of 304 stainless steel increased monotonically with speed, whereas the wear rate of 1020 steel and titanium first decreased and then increased and again decreased, with a maximum occurring at about 5 m s−1. The complex variation of the wear rate as a function of speed is explained in terms of the dependence of the friction coefficient, hardness and toughness of the materials on temperature. Microscope examinations of the wear track, the sub-surface of worn specimens and the wear particles indicate that the wear mode was predominantly by subsurface deformation, crack nucleation and growth processes, i.e. the delamination process, similar to the low speed sliding wear of metals. Oxidative and adhesion theories proposed in the past to explain the high speed sliding wear of metals are found to be incompatible with the experimental observations.