Solar energy assisted direct contact membrane distillation (DCMD) process for seawater desalination

Development of a solar assisted direct contact membrane distillation (DCMD) system for seawater desalination and an improved mathematical model to predict the permeate flux for unsteady state conditions were investigated. Different types of commercially available polytetrafluoroethylene (PTFE) membranes were used in a solar-DCMD system for seawater desalination. Membrane properties, such as the liquid entry pressure (LEP), pore diameter, effective porosity and pore size distribution, were characterized for each membrane. A two dimensional (2D) flat-plate dynamic model with heat and mass transfer mechanisms was used to predict the permeate flux under different operating conditions. Good agreement between the numerical simulation and experimental results were found. Long-term fouling phenomenon in the DCMD system was experimentally and theoretically examined. The experimental heat energy consumption ranged from 896 kW h/m3 to 1433 kW h/m3, and the gained output ratio (GOR) ranged from 0.44 to 0.70. The solar-DCMD system was run continually for more than 150 days for seawater desalination in Korea. During day time, more than 77.3% of the heating energy was supplied by solar energy. In particular, in the month of September, 95.3% of the heating energy was supplied by solar energy.

[1]  Hojung Hwang,et al.  Air gap membrane distillation on the different types of membrane , 2011 .

[2]  Matthias Rommel,et al.  Solar thermal-driven desalination plants based on membrane distillation☆ , 2003 .

[3]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[4]  C. Dosoretz,et al.  Heat transfer in vacuum membrane distillation: Effect of velocity slip , 2009 .

[5]  Xing Yang,et al.  Numerical simulation of heat and mass transfer in direct membrane distillation in a hollow fiber module with laminar flow , 2011 .

[6]  Noam Lior,et al.  Heat and mass transfer resistance analysis of membrane distillation , 2006 .

[7]  Zhongwei Ding,et al.  The use of intermittent gas bubbling to control membrane fouling in concentrating TCM extract by mem , 2011 .

[8]  P. V. Danckwerts.  Continuous flow systems , 1953 .

[9]  Mohamed Khayet,et al.  Possibility of nuclear desalination through various membrane distillation configurations: a comparative study , 2003 .

[10]  L. Martinez-diez,et al.  Study of evaporation efficiency in membrane distillation , 1999 .

[11]  Anthony G. Fane,et al.  Gas and vapour transport through microporous membranes. I. Knudsen-Poiseuille transition , 1990 .

[12]  Fawzi Banat,et al.  Exploitation of solar energy collected by solar stills for desalination by membrane distillation , 2002 .

[13]  Fawzi Banat,et al.  Performance evaluation of the “large SMADES” autonomous desalination solar-driven membrane distillation plant in Aqaba, Jordan , 2007 .

[14]  Wolfgang Marquardt,et al.  Dynamic modeling of direct contact membrane distillation processes , 2012 .

[15]  Stephen R Gray,et al.  Direct contact membrane distillation (DCMD): Experimental study on the commercial PTFE membrane and , 2011 .

[16]  Michael L. Michelsen,et al.  The axial dispersion model and orthogonal collocation , 1994 .

[17]  Linh T. T. Vu,et al.  Modelling the simultaneous heat and mass transfer of direct contact membrane distillation in hollow fibre modules , 2010 .

[18]  R. Chouikh,et al.  Numerical study of the coupled heat and mass transfer in membrane distillation , 2003 .

[19]  Andrew L. Zydney,et al.  Analysis of humic acid fouling during microfiltration using a pore blockage-cake filtration model , 2002 .

[20]  G. D. Byrne,et al.  VODE: a variable-coefficient ODE solver , 1989 .

[21]  Noam Lior,et al.  Membrane-distillation desalination: Status and potential , 2005 .

[22]  José M. Rodríguez-Maroto,et al.  Bulk and measured temperatures in direct contact membrane distillation , 2005 .

[23]  H. Ngo,et al.  Effect of operating parameters in a submerged membrane adsorption hybrid system: experiments and mathematical modeling , 2005 .

[24]  M. Qtaishat,et al.  Heat and mass transfer analysis in direct contact membrane distillation , 2008 .

[25]  Vicki Chen,et al.  Fouling and crystallisation behaviour of superhydrophobic nano-composite PVDF membranes in direct contact membrane distillation , 2014 .

[26]  In S. Kim,et al.  Organic fouling behavior in direct contact membrane distillation , 2014 .

[27]  J. Hermia,et al.  Constant Pressure Blocking Filtration Laws - Application To Power-law Non-newtonian Fluids , 1982 .

[28]  Hassan E.S. Fath,et al.  PV and thermally driven small-scale, stand-alone solar desalination systems with very low maintenance needs , 2008 .

[30]  Ho Jung Hwang,et al.  Production of drinking water from saline water by direct contact membrane distillation (DCMD) , 2011 .

[31]  R. Field,et al.  Critical flux concept for microfiltration fouling , 1995 .

[32]  Soon Huat Tan,et al.  Cytocompatibility and Mechanical Properties of Hydroxyapatite Composite Reinforced with Multi-Walled Carbon Nanotubes and Bovine Serum Albumin , 2013 .

[33]  Ho-Ming Yeh,et al.  Theoretical modeling and experimental analysis of direct contact membrane distillation , 2009 .

[34]  Guangzhi Zuo,et al.  Energy efficiency evaluation and economic analyses of direct contact membrane distillation system using Aspen Plus , 2011 .

[35]  P. V. Danckwerts.  Continuous flow systems. Distribution of residence times , 1995 .

[36]  J. Villadsen,et al.  Solution of differential equation models by polynomial approximation , 1978 .

[37]  E. Drioli,et al.  Potential of membrane distillation in seawater desalination: Thermal efficiency, sensitivity study and cost estimation , 2008 .

[38]  M. Khayet,et al.  Heat and mass transfer in vacuum membrane distillation , 2004 .

[39]  Fawzi Banat,et al.  Desalination by a “compact SMADES” autonomous solarpowered membrane distillation unit , 2007 .

[40]  Anthony G. Fane,et al.  Effects of net-type spacers on heat and mass transfer in direct contact membrane distillation and comparison with ultrafiltration studies , 2003 .

[41]  Takeshi Matsuura,et al.  Simulation of heat and mass transfer in direct contact membrane distillation (MD): The effect of membrane physical properties , 2005 .

[42]  Mohamed Khayet,et al.  Numerical simulation and experimental studies on heat and mass transfer using sweeping gas membrane distillation , 2010 .

[43]  P. Prádanos,et al.  Fouling kinetics and associated dynamics of structural modifications , 1998 .

[44]  N. Vlachakis,et al.  Energy consumption and membrane replacement cost for seawater RO desalination plants , 2003 .

[45]  Michael G. Lorenz,et al.  Flow rate influence on direct contact membrane distillation experiments: Different empirical correlations for Nusselt number , 2008 .