AMTEC cells challenge energy converters

Sodium-base alkali-metal-thermal-to-electric conversion (AMTEC) cells have been receiving attention. Recently they were selected for the next generation deep-space missions, which need a converter that makes electricity from radioisotope heat. The AMTEC cell, being an electrochemical converter of heat to electricity, has no moving parts and is not limited to Carnot-cycle efficiency. However, its heat source and sink have to be near each other, so the challenge in AMTEC design is to minimize thermal losses and maximize electricity production. This required clever thermal designs. By 1991, high-temperature materials and computer modeling became available. The important AMTEC application was generating power from radioisotope heat in deep space missions. These spacecraft power needs had previously been supplied by inefficient thermoelectric converters.

[1]  Robert K. Sievers,et al.  Micro-cogen AMTEC systems for residential and transportation opportunities , 1998 .

[2]  D. V. Paramonov,et al.  Direct energy conversion bottoming cycles for solid oxide fuel cells , 1998 .

[3]  C. Huang,et al.  Performance analysis of a potassium-base AMTEC cell , 1998 .

[4]  C. A. Borkowski,et al.  Series II AMTEC cell design and development , 1997, IECEC-97 Proceedings of the Thirty-Second Intersociety Energy Conversion Engineering Conference (Cat. No.97CH6203).

[5]  R. K. Sievers,et al.  AMTEC: current status and vision , 1997, IECEC-97 Proceedings of the Thirty-Second Intersociety Energy Conversion Engineering Conference (Cat. No.97CH6203).

[6]  Alfred Schock,et al.  Effect of design variations on AMTEC cell efficiency, and of operating parameters on performance of OSC cell design , 1997, IECEC-97 Proceedings of the Thirty-Second Intersociety Energy Conversion Engineering Conference (Cat. No.97CH6203).

[7]  Ryan,et al.  Sodium Transport Modes in AMTEC Electrodes , 1998 .