Dynamic analysis of concentrated solar supercritical CO2-based power generation closed-loop cycle

Abstract In this study, the dynamic behavior of a concentrated solar power (CSP) supercritical CO 2 cycle is studied under different seasonal conditions. The system analyzed is composed of a central receiver, hot and cold thermal energy storage units, a heat exchanger, a recuperator, and multi-stage compression–expansion subsystems with intercoolers and reheaters between compressors and turbines respectively. Energy models for each component of the system are developed in order to optimize operating and design parameters such as mass flow rate, intermediate pressures and the effective area of the recuperator to lead to maximum efficiency. The results show that the parametric optimization leads the system to a process efficiency of about 21% and a maximum power output around 1.6 MW. The thermal energy storage allows the system to operate for several hours after sunset. This operating time is approximately increased from 220 to 480 minutes after optimization. The hot and cold thermal energy storage also lessen the temperature fluctuations by providing smooth changes of temperatures at the turbine and compressor inlets. The results obtained in this paper indicate that concentrated solar systems using supercritical CO 2 could be a viable alternative to satisfying energy needs in desert areas with scarce water and fossil fuel resources.

[1]  S. K. Tyagi,et al.  nergy and exergy analyses of thermal power plants : A review , 2011 .

[2]  Giuseppe Franchini,et al.  A comparative study between parabolic trough and solar tower technologies in Solar Rankine Cycle and Integrated Solar Combined Cycle plants , 2013 .

[3]  Jiangfeng Wang,et al.  Thermodynamic analysis of a transcritical CO2 power cycle driven by solar energy with liquified natural gas as its heat sink , 2012 .

[4]  Brian D. Iverson,et al.  Supercritical CO2 Brayton cycles for solar-thermal energy , 2013 .

[5]  R. W. Harrigan,et al.  Solar energy fundamentals and design , 1985 .

[6]  Gregory J. Kolb,et al.  Performance of the Solar One power plant as simulated by the SOLERGY computer code , 1988 .

[7]  Craig Turchi,et al.  Thermodynamic Study of Advanced Supercritical Carbon Dioxide Power Cycles for High Performance Concentrating Solar Power Systems , 2012 .

[8]  Xin-Rong Zhang,et al.  Experimental study of trans-critical and supercritical CO2 natural circulation flow in a closed loop , 2013 .

[9]  Abdallah Khellaf,et al.  A review of studies on central receiver solar thermal power plants , 2013 .

[10]  D. Yogi Goswami,et al.  Analysis of Advanced Supercritical Carbon Dioxide Power Cycles With a Bottoming Cycle for Concentrating Solar Power Applications , 2013 .

[11]  Meherwan P. Boyce,et al.  Gas turbine engineering handbook , 1981 .

[12]  Josua P. Meyer,et al.  The efficiency of an open-cavity tubular solar receiver for a small-scale solar thermal Brayton cycle , 2014 .

[13]  Juan C. Ordonez,et al.  Thermodynamic optimization of a solar system for cogeneration of water heating and absorption cooling , 2008 .

[14]  Chris Manzie,et al.  Extremum-seeking control of a supercritical carbon-dioxide closed Brayton cycle in a direct-heated solar thermal power plant , 2013 .

[15]  Wei Liu,et al.  Fighting global warming by climate engineering: Is the Earth radiation management and the solar radiation management any option for fighting climate change? , 2014 .

[16]  Yujie Xu,et al.  A solar energy storage and power generation system based on supercritical carbon dioxide , 2014 .

[17]  Stefan Grönkvist,et al.  Models for assessing net CO2 emissions applied on district heating technologies , 2003 .

[18]  Ricardo Chacartegui,et al.  Alternative cycles based on carbon dioxide for central receiver solar power plants , 2011 .

[19]  Tao Wang,et al.  High thermal energy storage density molten salts for parabolic trough solar power generation , 2011 .

[20]  Rajinesh Singh,et al.  Effects of relative volume-ratios on dynamic performance of a direct-heated supercritical carbon-dioxide closed Brayton cycle in a solar-thermal power plant , 2013 .

[21]  G. Antolín,et al.  Low temperature heat source for power generation: Exhaustive analysis of a carbon dioxide transcritical power cycle , 2011 .

[22]  Luisa F. Cabeza,et al.  Review on thermal energy storage with phase change: materials, heat transfer analysis and applications , 2003 .

[23]  Gunnar Tamm,et al.  New and emerging developments in solar energy , 2004 .

[24]  Justin Raade,et al.  Development of Molten Salt Heat Transfer Fluid With Low Melting Point and High Thermal Stability , 2011 .

[25]  Gary E Rochau,et al.  Operation and analysis of a supercritical CO2 Brayton cycle. , 2010 .

[26]  Yiping Dai,et al.  Parametric optimization design for supercritical CO2 power cycle using genetic algorithm and artificial neural network , 2010 .

[27]  Robert F. Boehm Design Analysis of Thermal Systems , 1987 .

[28]  Jostein Pettersen,et al.  Fundamental process and system design issues in CO2 vapor compression systems , 2004 .

[29]  A. Bejan Advanced Engineering Thermodynamics , 1988 .

[30]  Antonio Rovira,et al.  Thermodynamic cycles optimised for medium enthalpy units of concentrating solar power , 2014 .

[31]  C. Turchi,et al.  A Comparison of Supercritical Carbon Dioxide Power Cycle Configurations with an Emphasis on CSP Applications , 2013 .

[32]  Adrian Bejan,et al.  Power extraction from a hot stream in the presence of phase change , 2000 .

[33]  Juan C. Ordonez,et al.  Exergy analysis of discharging multi-tank thermal energy storage systems with constant heat extraction , 2015 .

[34]  Hiroshi Yamaguchi,et al.  Experimental study on the performance of solar Rankine system using supercritical CO2 , 2007 .

[35]  Jahar Sarkar,et al.  Review and future trends of supercritical CO2 Rankine cycle for low-grade heat conversion , 2015 .

[36]  Elias K. Stefanakos,et al.  Thermal energy storage technologies and systems for concentrating solar power plants , 2013 .

[37]  Josua P. Meyer,et al.  A review on the thermodynamic optimisation and modelling of the solar thermal Brayton cycle , 2013 .

[38]  Da Rosa,et al.  Fundamentals of renewable energy processes , 2005 .

[39]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[40]  M. McLinden,et al.  NIST Standard Reference Database 23: Reference Fluid Thermodynamic and Transport Properties-REFPROP, Version 8.0 , 2007 .

[41]  M. Iqbal An introduction to solar radiation , 1983 .

[42]  Julian D. Osorio,et al.  Microstructure characterization of thermal barrier coating systems after controlled exposure to a high temperature , 2014 .

[43]  Henry Cohen,et al.  Gas turbine theory , 1973 .

[44]  Freddy Jiménez,et al.  Correlations Between Microstructure and Mechanical Properties of Air Plasma‐Sprayed Thermal Barrier Coatings Exposed to a High Temperature , 2013 .

[45]  S. C. Kaushik,et al.  State-of-the-art of solar thermal power plants—A review , 2013 .

[46]  Vaclav Dostal,et al.  A supercritical carbon dioxide cycle for next generation nuclear reactors , 2004 .