Performance Evaluation of the T6 Ion Engine

*† * ‡ § ** The T6 ion engine is a 22-cm diameter, 4.5-kW Kaufman-type ion thruster produced by QinetiQ, Ltd., and is baselined for the European Space Agency BepiColombo mission to Mercury and is being qualified under ESA sponsorship for the extended range AlphaBus communications satellite platform. The heritage of the T6 includes the T5 ion thruster now successfully operating on the ESA GOCE spacecraft. As a part of the T6 development program, an engineering model thruster was subjected to a suite of performance tests and plume diagnostics at the Jet Propulsion Laboratory. The engine was mounted on a thrust stand and operated over its nominal throttle range of 2.5 to 4.5 kW. In addition to the typical electrical and flow measurements, an EB mass analyzer, scanning Faraday probe, thrust vector probe, and several near-field probes were utilized. Thrust, beam divergence, double ion content, and thrust vector movement were all measured at four separate throttle points. The engine performance agreed well with published data on this thruster. At full power the T6 produced 143 mN of thrust at a specific impulse of 4120 seconds and an efficiency of 64%; optimization of the neutralizer for lower flow rates increased the specific impulse to 4300 seconds and the efficiency to nearly 66%. Measured beam divergence was less than, and double ion content was greater than, the ring-cusp-design NSTAR thruster that has flown on NASA missions. The measured thrust vector offset depended slightly on throttle level and was found to increase with time as the thruster approached thermal equilibrium.

[1]  Rohit Shastry,et al.  Method for analyzing E x B probe spectra from Hall thruster plumes. , 2009, The Review of scientific instruments.

[2]  Steven Robert Owens,et al.  Analogy to bi-elliptic transfers incorporating high- and low-thrust , 2013 .

[3]  John R. Brophy,et al.  Behavior of the thrust vector in the NSTAR ion thruster , 1998 .

[4]  John R. Anderson,et al.  Environmental Testing of NASA's Evolutionary Xenon Thruster Prototype Model 1 Reworked Ion Engine , 2009 .

[5]  Dan M. Goebel,et al.  Keeper Wear Mechanisms in the XIPS © 25-cm Neutralizer Cathode Assembly , 2009 .

[6]  Dan M. Goebel,et al.  Simplified Ion Thruster Xenon Feed System for NASA Science Missions , 2009 .

[7]  John R. Anderson,et al.  Performance characteristics of the deep space 1 flight spare ion thruster long duration test, the first 21,300 hours of operation , 2002 .

[8]  N. Wallace,et al.  An Overview of the T6 Gridded Ion Propulsion System Pre-Development Activities for Alpha-Bus , 2004 .

[9]  I. Katz,et al.  Fundamentals of Electric Propulsion: Ion and Hall Thrusters , 2008 .

[10]  John Steven Snyder,et al.  Evaluation of a 4.5 kW Commercial Hall Thruster System for NASA Science Missions , 2006 .

[11]  David Mundy,et al.  Evaluation of the Performance of the T6 Ion Thruster , 1999 .

[12]  David Y. Oh.  Evaluation of Solar Electric Propulsion Technologies for Discovery Class Missions , 2007 .

[13]  Nm Wallace.  Testing of the Qinetiq T6 Thruster in Support of the ESA BepiColombo Mercury Mission for the ESA BepiColombo Mission , 2004 .

[14]  John R. Anderson,et al.  Qualification of commercial XIPS® ion thrusters for NASA Deep Space missions , 2008 .

[15]  Dan M. Goebel,et al.  Potential Fluctuations and Energetic Ion Production in Hollow Cathode Discharges , 2007 .

[16]  John R. Brophy,et al.  Dawn ion propulsion system – initial checkout after launch , 2009 .