Performance evaluation on an air-cooled heat exchanger for alumina nanofluid under laminar flow

This study analyzes the characteristics of alumina (Al2O3)/water nanofluid to determine the feasibility of its application in an air-cooled heat exchanger for heat dissipation for PEMFC or electronic chip cooling. The experimental sample was Al2O3/water nanofluid produced by the direct synthesis method at three different concentrations (0.5, 1.0, and 1.5 wt.%). The experiments in this study measured the thermal conductivity and viscosity of nanofluid with weight fractions and sample temperatures (20-60°C), and then used the nanofluid in an actual air-cooled heat exchanger to assess its heat exchange capacity and pressure drop under laminar flow. Experimental results show that the nanofluid has a higher heat exchange capacity than water, and a higher concentration of nanoparticles provides an even better ratio of the heat exchange. The maximum enhanced ratio of heat exchange and pressure drop for all the experimental parameters in this study was about 39% and 5.6%, respectively. In addition to nanoparticle concentration, the temperature and mass flow rates of the working fluid can affect the enhanced ratio of heat exchange and pressure drop of nanofluid. The cross-section aspect ratio of tube in the heat exchanger is another important factor to be taken into consideration.

[1]  Patricia E. Gharagozloo,et al.  A Benchmark Study on the Thermal Conductivity of Nanofluids , 2009 .

[2]  Ravikanth S. Vajjha,et al.  Application of aluminum oxide nanofluids in diesel electric generator as jacket water coolant , 2008 .

[3]  G. Peterson,et al.  Experimental investigation of temperature and volume fraction variations on the effective thermal conductivity of nanoparticle suspensions (nanofluids) , 2006 .

[4]  S. Phillpot,et al.  Mechanisms of heat flow in suspensions of nano-sized particles (nanofluids) , 2002 .

[5]  Yu Feng,et al.  Nanofluid convective heat transfer in a parallel-disk system , 2010 .

[6]  S. Etemad,et al.  Heat transfer of nanofluids in a shell and tube heat exchanger , 2010 .

[7]  C. T. Nguyen,et al.  Heat transfer enhancement using Al2O3–water nanofluid for an electronic liquid cooling system , 2007 .

[8]  Ching-Jenq Ho,et al.  An experimental investigation of forced convective cooling performance of a microchannel heat sink with Al2O3/water nanofluid , 2010 .

[9]  A. Zamzamian,et al.  Experimental investigation of forced convective heat transfer coefficient in nanofluids of Al2O3/EG and CuO/EG in a double pipe and plate heat exchangers under turbulent flow , 2011 .

[10]  Huaqing Xie,et al.  Thermal conductivity enhancement of suspensions containing nanosized alumina particles , 2002 .

[11]  Qunzhi Zhu,et al.  Application of aqueous nanofluids in a horizontal mesh heat pipe , 2011 .

[12]  Ehsan Firouzfar,et al.  Energy saving in HVAC systems using nanofluid , 2011 .

[13]  G. J. McCarthy,et al.  JCPDS-International Centre for Diffraction Data , 1981 .

[14]  K. V. Sharma,et al.  Estimation of heat transfer coefficient and friction factor in the transition flow with low volume concentration of Al2O3 nanofluid flowing in a circular tube and with twisted tape insert , 2009 .

[15]  S. Paras,et al.  Effect of nanofluids on the performance of a miniature plate heat exchanger with modulated surface , 2009 .

[16]  Jason Chuang,et al.  Experimental microchannel heat sink performance studies using nanofluids , 2007 .

[17]  J. Buongiorno,et al.  Experimental Investigation of Turbulent Convective Heat Transfer and Pressure Loss of Alumina/Water and Zirconia/Water Nanoparticle Colloids (Nanofluids) in Horizontal Tubes , 2008 .

[18]  Ali J. Chamkha,et al.  Effect of nanofluid variable properties on natural convection in enclosures filled with a CuO–EG–Water nanofluid , 2010 .

[19]  Somchai Wongwises,et al.  Heat transfer enhancement and pressure drop characteristics of TiO2–water nanofluid in a double-tube counter flow heat exchanger , 2009 .

[20]  Patrick E. Phelan,et al.  Convective Heat Transfer With Nanofluids in a Single 1.02-mm Tube , 2006 .

[21]  C. T. Nguyen,et al.  Heat transfer behaviours of nanofluids in a uniformly heated tube , 2004 .

[22]  Saeed Zeinali Heris,et al.  EXPERIMENTAL INVESTIGATION OF CONVECTIVE HEAT TRANSFER OF AL2O3/WATER NANOFLUID IN CIRCULAR TUBE , 2007 .

[23]  W. Roetzel,et al.  TEMPERATURE DEPENDENCE OF THERMAL CONDUCTIVITY ENHANCEMENT FOR NANOFLUIDS , 2003 .

[24]  Chien-Chih Chen,et al.  Performance of overall heat transfer in multi-channel heat exchanger by alumina nanofluid , 2010 .

[25]  M. Chandrasekar,et al.  Experimental studies on heat transfer and friction factor characteristics of CuO/water nanofluid under turbulent flow in a helically dimpled tube , 2011 .

[26]  Jung-Yeul Jung,et al.  Forced convective heat transfer of nanofluids in microchannels , 2009 .

[27]  Y. Xuan,et al.  Heat transfer enhancement of nanofluids , 2000 .

[28]  E. Grulke,et al.  Heat transfer properties of nanoparticle-in-fluid dispersions (nanofluids) in laminar flow , 2005 .

[29]  A. Nnanna,et al.  Assessment of Thermoelectric Module With Nanofluid Heat Exchanger , 2009 .

[30]  Yulong Ding,et al.  Effective thermal conductivity of aqueous suspensions of carbon nanotubes (carbon nanotube nanofluids) , 2004 .

[31]  K. V. Sharma,et al.  Heat transfer enhancements of low volume concentration Al2O3 nanofluid and with longitudinal strip inserts in a circular tube , 2010 .

[32]  Young I Cho,et al.  HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLES , 1998 .

[33]  William W. Yu,et al.  ANOMALOUSLY INCREASED EFFECTIVE THERMAL CONDUCTIVITIES OF ETHYLENE GLYCOL-BASED NANOFLUIDS CONTAINING COPPER NANOPARTICLES , 2001 .

[34]  C. T. Nguyen,et al.  Heat transfer enhancement with the use of nanofluids in radial flow cooling systems considering temperature-dependent properties , 2006 .