Optimizing Universal Ballasts Using Magnetic Regulators and Digital Control

In this paper, a digitally controlled electronic ballast is presented. The ballast corresponds to the so-called universal or multiwatt ballasts, which are intended to operate different lamps with different power ratings without performing any change in the hardware. Thus, the ballast must incorporate some kind of circuitry so that the rated power of the connected lamp can be identified. The ballast must also adjust some of its parameters in order to supply the lamp adequately, which usually means the following: 1) as close as possible to the nominal power and 2) with the best efficiency. In the proposed ballast, the parameters selected to adapt the power circuit to each lamp are the switching frequency and the resonant tank inductance. The resonant tank inductance is varied by means of a magnetic regulator whose inductance can be adjusted through a dc bias current. Due to the relatively high complexity of the proposed converter, a digital control circuit is developed to control both the resonant inverter used to drive the lamp and the dc-dc converter employed to supply the control winding of the magnetic regulator. Experimental results from a laboratory prototype for lamp powers ranging from 15 to 58 W are provided.

[1]  Marco A. Dalla Costa,et al.  Comparative Analysis and Experiments of Resonant Tanks for Magnetically Controlled Electronic Ballasts , 2008, IEEE Transactions on Industrial Electronics.

[2]  M.S. Perdigao,et al.  Using Magnetic Regulators for the Optimization of Universal Ballasts , 2008, IEEE Transactions on Power Electronics.

[3]  José Luiz de Freitas Vieira,et al.  HID Lamp Electronic Ballast With Reduced Component Number , 2009, IEEE Transactions on Industrial Electronics.

[4]  S.Y.R. Hui,et al.  An automatic lamp detection technique for electronic ballasts , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[5]  A. S. Kislovski.  Linear variable inductor (LVI) in single-phase telecom rectifiers , 1995, Proceedings of INTELEC 95. 17th International Telecommunications Energy Conference.

[6]  Jorge García,et al.  Magnetic dimming of electronic ballasts , 2005 .

[7]  C. Branas,et al.  Microcontroller Power Mode Stabilized Power Factor Correction Stage for High Intensity Discharge Lamp Electronic Ballast , 2007, IEEE Transactions on Power Electronics.

[8]  J.W. Kolar,et al.  EMI Noise Prediction for Electronic Ballasts , 2008, IEEE Transactions on Power Electronics.

[9]  S. Ben-Yaakov,et al.  Inductor-controlled current-sourcing resonant inverter and its application as a high pressure discharge lamp driver , 1994, Proceedings of 1994 IEEE Applied Power Electronics Conference and Exposition - ASPEC'94.

[10]  Ying-Chun Chuang,et al.  A Novel Single-Stage High-Power-Factor Electronic Ballast with Boost Topology for Multiple Fluorescent Lamps , 2007, 2007 IEEE Industry Applications Annual Meeting.

[11]  Mor Mordechai Peretz,et al.  Digital Control of Resonant Converters: Frequency Limit Cycles Conditions , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[12]  Muhammad H. Rashid,et al.  Power electronics handbook , 2001 .

[13]  S. Ben-Yaakov,et al.  A current-controlled variable-inductor for high frequency resonant power circuits , 1994, Proceedings of 1994 IEEE Applied Power Electronics Conference and Exposition - ASPEC'94.

[14]  Nimrod Vázquez,et al.  Electric Dynamic Modeling of HID Lamps for Electronic Ballast Design , 2010, IEEE Transactions on Industrial Electronics.

[15]  S. Borekci.  Dimming Electronic Ballasts Without Striations , 2009, IEEE Transactions on Industrial Electronics.

[16]  Paolo Mattavelli,et al.  Digital Control of Single-Inductor Multiple-Output Step-Down DC–DC Converters in CCM , 2008, IEEE Transactions on Industrial Electronics.

[17]  Xiaohui Qu,et al.  Noncascading Structure for Electronic Ballast Design for Multiple LED Lamps With Independent Brightness Control , 2010, IEEE Transactions on Power Electronics.

[18]  Wei Yan,et al.  Energy Saving of Large-Scale High-Intensity-Discharge Lamp Lighting Networks Using a Central Reactive Power Control System , 2009, IEEE Transactions on Industrial Electronics.

[19]  Aman Behal,et al.  Experimental Comparison of Digital Implementations of Single-Phase PFC Controllers , 2008, IEEE Transactions on Industrial Electronics.

[20]  Leung-Ming Lee,et al.  Automatic Lamp Detection and Operation for Warm-Start Tubular Fluorescent Lamps , 2009, IEEE Transactions on Power Electronics.

[21]  Piyasawat Navaratana Na Ayudhya,et al.  Automatic Fluorescent Lamp Detection Technique for Electronic Ballasts , 2009, 2008 IEEE International Conference on Robotics and Biomimetics.

[22]  J. Cardesin,et al.  Design and Implementation of a Microcontroller-Based High Power Factor Electronic Ballast to Supply Metal Halide Lamps , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[23]  S. Ben-Yaakov,et al.  A self-adjusting sinusoidal power source suitable for driving capacitive loads , 2004, Nineteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2004. APEC '04..

[24]  Huang-Jen Chiu,et al.  Eliminating the Temperature Effect of Piezoelectric Transformer in Backlight Electronic Ballast by Applying the Digital Phase-Locked-Loop Technique , 2007, IEEE Transactions on Industrial Electronics.

[25]  U. Boeke.  Scalable fluorescent lamp driver using magnetic amplifiers , 2005, 2005 European Conference on Power Electronics and Applications.

[26]  R. Zane,et al.  Electronic Ballast Control IC With Digital Phase Control and Lamp Current Regulation , 2008, IEEE Transactions on Power Electronics.

[27]  A. S. Kislovski.  Linear variable inductor in DC current sensors utilized in telecom solar battery chargers , 1989, Conference Proceedings., Eleventh International Telecommunications Energy Conference.

[28]  Tiago Bandeira Marchesan,et al.  Integrated Power Topologies to Supply HPS Lamps: A Comparative Study , 2010, IEEE Transactions on Power Electronics.

[29]  Li Peng,et al.  A Novel PWM Technique in Digital Control , 2007, IEEE Transactions on Industrial Electronics.

[30]  Chin-Sien Moo,et al.  Repeatedly Resonating Ignition Circuit for HID Lamp Electronic Ballasts , 2009, IEEE Transactions on Industrial Electronics.

[31]  Oscar Garcia,et al.  Power Factor Correction Without Current Sensor Based on Digital Current Rebuilding , 2010, IEEE Transactions on Power Electronics.

[32]  J.M. Alonso,et al.  Comparative Analysis and Experiments of Resonant Tanks for Magnetically-Controlled Electronic Ballasts , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[33]  Ka Wai Eric Cheng,et al.  Implementation of a Voltage Multiplier Integrated HID Ballast Circuit With Dimming Control for Automotive Application , 2009, IEEE Transactions on Industrial Electronics.

[34]  John Y. Hung,et al.  Posicast-based digital control of the buck converter , 2006, IEEE Transactions on Industrial Electronics.

[35]  Yu-Kang Lo,et al.  Design of an RGB LED Backlight Circuit for Liquid Crystal Display Panels , 2009, IEEE Transactions on Industrial Electronics.

[36]  M. Rico-Secades,et al.  A Universal-Input Single-Stage High-Power-Factor Power Supply for HB-LEDs Based on Integrated Buck-Flyback Converter , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[37]  Yi-Hwa Liu,et al.  Design and Implementation of an FPGA-Based CCFL Driving System With Digital Dimming Capability , 2007, IEEE Transactions on Industrial Electronics.

[38]  Yan Jiang,et al.  High power-density igniter with integrated LC resonator for low wattage HID ballast , 2005 .

[39]  D. Maksimovic,et al.  Small-Signal Discrete-Time Modeling of Digitally Controlled PWM Converters , 2007, IEEE Transactions on Power Electronics.

[40]  Jong-Lick Lin,et al.  Novel Single-Stage Self-Oscillating Dimmable Electronic Ballast With High Power Factor Correction , 2011, IEEE Transactions on Industrial Electronics.

[41]  Hoon Kim,et al.  Dimming Control Characteristics of Electrodeless Fluorescent Lamps , 2009, IEEE Transactions on Industrial Electronics.

[42]  Itsda Boonyaroonate,et al.  Single-Stage Electronic Ballast Using Class-DE Low-${d} \upsilon/{d}t$ Current-Source-Driven Rectifier for Power-Factor Correction , 2010, IEEE Transactions on Industrial Electronics.

[43]  Chin-Sien Moo,et al.  A Single-Stage High-Power-Factor Electronic Ballast With ZVS Buck–Boost Conversion , 2008, IEEE Transactions on Industrial Electronics.

[44]  Selim Öncü,et al.  Dimming self-oscillating ballast by variable inductor , 2007 .

[45]  D. Maksimovic,et al.  Impact of digital control in power electronics , 2004, 2004 Proceedings of the 16th International Symposium on Power Semiconductor Devices and ICs.

[46]  S.Y.R. Hui,et al.  Use of saturable inductor to improve the dimming characteristics of frequency-controlled dimmable electronic ballasts , 2003, IEEE 34th Annual Conference on Power Electronics Specialist, 2003. PESC '03..

[47]  J. M. Alonso,et al.  Magnetically-controlled dimming technique with isolated output , 2009 .

[48]  Wei Yan,et al.  Modeling of Cold Cathode Fluorescent Lamps (CCFLs) With Realistic Electrode Profile , 2010, IEEE Transactions on Power Electronics.

[49]  Huang-Jen Chiu,et al.  A High-Efficiency Dimmable LED Driver for Low-Power Lighting Applications , 2010, IEEE Transactions on Industrial Electronics.

[50]  A.S. Kislovski.  Quasi-linear controllable inductor , 1987, Proceedings of the IEEE.

[51]  Praveen K Jain,et al.  A High-Power-Factor Single-Stage Single-Switch Electronic Ballast for Compact Fluorescent Lamps , 2010, IEEE Transactions on Power Electronics.

[52]  Dariusz Czarkowski,et al.  Modeling and Digital Control of a Phase-Controlled Series–Parallel Resonant Converter , 2007, IEEE Transactions on Industrial Electronics.

[53]  Marco A. Dalla Costa,et al.  A Single-Stage High-Power-Factor Electronic Ballast Based on Integrated Buck Flyback Converter to Supply Metal Halide Lamps , 2008, IEEE Transactions on Industrial Electronics.

[54]  Marco A. Dalla Costa,et al.  Investigation of a New Control Strategy for Electronic Ballasts Based on Variable Inductor , 2008, IEEE Transactions on Industrial Electronics.