A two-stage cascode class F CMOS power amplifier for Bluetooth

In this paper, a two-stage cascode class F power amplifier (PA) intended for class 1 Bluetooth application is presented using standard 0.18-μm CMOS technology. In the proposed PA, a cascode schematic is used not only to avoid from overflow current but also to have a good isolation. Furthermore, the class F power amplifier is designed to improve the power efficiency using the operating mode in either triode or cut-off region. The simulation results present that the output power is larger than 20 dBm and the power added efficiency (PAE) is roughly 49%. Moreover, the multiple bonding wires are added to eliminate the parasitic capacitance of input stage (first) and to save the power dissipation.

[1]  S. C. Cripps,et al.  RF Power Amplifiers for Wireless Communications , 1999 .

[2]  Hani Ragai,et al.  Design of power-controlled Class1 Bluetooth CMOS power amplifier , 2006 .

[3]  Behzad Razavi,et al.  RF Microelectronics , 1997 .

[4]  Howard C. Luong,et al.  A 1V CMOS power amplifier for Bluetooth applications , 2002, The 2002 45th Midwest Symposium on Circuits and Systems, 2002. MWSCAS-2002..

[5]  M. Steyaert,et al.  A Fully Integrated Class 1 Bluetooth 0.25 μm CMOS PA , 2002, Proceedings of the 28th European Solid-State Circuits Conference.

[6]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[7]  Atila Alvandpour,et al.  Low Voltage Class-E Power Amplifiers for DECT and Bluetooth in 130nm CMOS , 2009, 2009 IEEE Topical Meeting on Silicon Monolithic Integrated Circuits in RF Systems.

[8]  Frederick H. Raab,et al.  Transistor power losses in the class E tuned power amplifier , 1978 .