Al 2O 3 nanoparticles in concrete and different curing media

Abstract In the present study, the effect of limewater on strength and percentage of water absorption of Al 2 O 3 nanoparticles blended concrete has been investigated. Portland cement was partially replaced by Al 2 O 3 nanoparticles with the average particle size of 15 nm with different amount and the specimens were cured in water and saturated limewater for specific ages. Utilizing up to 2.0 wt% Al 2 O 3 nanoparticles could produce concrete with improved strength and water permeability when the specimens cured in saturated limewater while this content is 1.0 wt% for the specimens cured in tap water. The high action of fine nanoparticles substantially increases the quantity of C–S–H gel. Although the limewater reduces the strength of concrete without nanoparticles when compared with that cured in water, curing the specimens in saturated limewater results in more strengthening gel formation around Al 2 O 3 nanoparticles and causes improved permeability together with high strength. In addition, Al 2 O 3 nanoparticles are able to act as nanofillers and recover the pore structure of the specimens by decreasing harmful pores. Accelerated peak appearance in conduction calorimetry tests, more weight loss in thermogravimetric analysis and more rapid appearance of peaks related to hydrated products in X-ray diffraction results, all indicate that Al 2 O 3 nanoparticles could improve mechanical and physical properties of the specimens.

[1]  Kiyofumi Kurumisawa,et al.  Development of technique for observing pores in hardened cement paste , 2002 .

[2]  L. Torres-Martínez,et al.  Engineering of SiO 2 Nanoparticles for Optimal Performance in Nano Cement-Based Materials , 2009 .

[3]  M. Cai,et al.  Improvements of nano-SiO2 on sludge/fly ash mortar. , 2008, Waste management.

[4]  Chiara F. Ferraris,et al.  Measurement of the Rheological Properties of High Performance Concrete: State of the Art Report , 1999, Journal of Research of the National Institute of Standards and Technology.

[5]  Ye Qing,et al.  A comparative study on the pozzolanic activity between nano-SiO2 and silica fume , 2006 .

[6]  Cristina Becchio,et al.  Improving environmental sustainability of concrete products: Investigation on MWC thermal and mechanical properties , 2009 .

[7]  Jeng-Ywan Shih,et al.  Material properties of portland cement paste with nano-montmorillonite , 2007 .

[8]  Kamile Tosun,et al.  The Effect of Fly Ash and Limestone Fillers on the Viscosity and Compressive Strength of Self-compacting Repair Mortars , 2006 .

[9]  Sang‐Jin Lee,et al.  Synthesis and hydration study of Portland cement components prepared by the organic steric entrapment method , 2005 .

[10]  Phillip Frank Gower Banfill,et al.  THE RHEOLOGY OF FRESH CEMENT AND CONCRETE - A REVIEW , 2003 .

[11]  Jong-Shin Huang,et al.  Effects of organo-modified montmorillonite on strengths and permeability of cement mortars , 2006 .

[12]  S. Grzeszczyk,et al.  Effect of content and particle size distribution of high-calcium fly ash on the rheological properties of cement pastes , 1997 .

[13]  Antoni Cladera,et al.  Energy use, CO2 emissions and waste throughout the life cycle of a sample of hotels in the Balearic Islands , 2010 .

[14]  C. F. Ferraris,et al.  Connection between the rheology of concrete and rheology of cement paste , 1992 .

[15]  G. Ye,et al.  Modelling of water permeability in cementitious materials , 2006 .

[16]  L. Gustavsson,et al.  Life cycle primary energy analysis of residential buildings , 2010 .

[17]  Kae‐Long Lin,et al.  Effects of nano-SiO(2) and different ash particle sizes on sludge ash-cement mortar. , 2008, Journal of environmental management.

[18]  Giovanni Andrea Blengini,et al.  The changing role of life cycle phases, subsystems and materials in the LCA of low energy buildings , 2010 .

[19]  Moayad N. Al-Khalaf,et al.  Use of rice husk ash in concrete , 1984 .

[20]  Nasser Y. Mostafa,et al.  Heat of hydration of high reactive pozzolans in blended cements: Isothermal conduction calorimetry , 2005 .

[21]  Phillip Frank Gower Banfill,et al.  Rheology of fresh cement and concrete , 1991 .

[22]  C. Hall,et al.  Water sorptivity of mortars and concretes: a review , 1989 .

[23]  Yaw-Yauan Tyan,et al.  An assessment of optimal mixture for concrete made with recycled concrete aggregates , 2004 .

[24]  Edward J. Garboczi,et al.  Modelling of the microstructure and transport properties of concrete , 1996 .

[25]  J. Ou,et al.  Microstructure of cement mortar with nano-particles , 2004 .

[26]  A. Chatterji,et al.  Hydration of Portland Cement , 1965, Nature.

[27]  H. Mörtel,et al.  Dense packing of cement pastes and resulting consequences on mortar properties , 1997 .

[28]  Jamie Goggins,et al.  The assessment of embodied energy in typical reinforced concrete building structures in Ireland , 2010 .

[29]  Anne B. Abell,et al.  Mercury Intrusion Porosimetry and Image Analysis of Cement-Based Materials. , 1999, Journal of colloid and interface science.

[30]  G. H. Tattersall,et al.  An investigation on the effect of vibration on the workability of fresh concrete using a vertical pipe apparatus , 1989 .

[31]  J. Ou,et al.  Flexural fatigue performance of concrete containing nano-particles for pavement , 2007 .

[32]  Konstantin Sobolev,et al.  How nanotechnology can change the concrete world : Part two of a two-part series , 2005 .

[33]  Zhenhua Li,et al.  Investigations on the preparation and mechanical properties of the nano-alumina reinforced cement composite , 2006 .

[34]  Chiara F. Ferraris,et al.  The influence of mineral admixtures on the rheology of cement paste and concrete , 2001 .

[35]  M. Cyr,et al.  Study of the shear thickening effect of superplasticizers on the rheological behaviour of cement pastes containing or not mineral additives , 2000 .