Heat transfer analysis of liquid piston compressor for hydrogen applications

Abstract A hydrogen compression technology using liquid as the compression piston is investigated from heat transfer point of view. A thermodynamic model, simulating a single compression stroke, is developed to investigate the heat transfer phenomena inside the compression chamber. The model is developed based on the mass and energy balance of the hydrogen, liquid, and the wall of the compression chamber at each time step and positional node with various compression ratios, to calculate the temperature distribution of the system. The amount of heat extracted from hydrogen, directly at the interface and through the walls, is investigated and compared with the adiabatic case. The results show that depending on heat transfer correlation, the hydrogen temperature reduces slightly between 0.2% and 0.4% compared to the adiabatic case, at 500 bar, due to the large wall resistance and small contact area at the interface. Moreover, the results of the sensitivity analysis illustrates that increasing the total heat transfer coefficients at the interface and the wall, together with compression time, play key roles in reducing the hydrogen temperature. Increasing the total heat transfer coefficient at the interface (10,000 times) or at the wall (200 times), leads to 22% or 33% reduction of hydrogen, compared to the adiabatic case, at 500 bar, during 3.5 s compression, respectively.

[1]  Perry Y. Li,et al.  Optimal trajectories for a liquid piston compressor/expander in a Compressed Air Energy Storage system with consideration of heat transfer and friction , 2012, 2012 American Control Conference (ACC).

[2]  Herbert A. Humphrey.  An Internal-Combustion Pump, and other Applications of a New Principle , 1909 .

[3]  W. Marsden.  I and J , 2012 .

[4]  Cecil Piya,et al.  Numerical Modeling of Liquid Piston Gas Compression , 2009 .

[5]  Alvaro T. Prata,et al.  Heat Transfer Modeling in a Reciprocating Compressor , 1994 .

[6]  Perry Y. Li,et al.  Optimal efficiency-power relationship for an air motor-compressor in an energy storage and regeneration system , 2009 .

[7]  F. Dittus,et al.  Heat transfer in automobile radiators of the tubular type , 1930 .

[8]  Bo Yan,et al.  Iterative optimal and adaptive control of a near isothermal liquid piston air compressor in a compressed air energy storage system , 2013, 2013 American Control Conference.

[9]  Perry Y. Li,et al.  Liquid piston gas compression , 2009 .

[10]  E. N. Sieder,et al.  Heat Transfer and Pressure Drop of Liquids in Tubes , 1936 .

[11]  W. J. D. Annand,et al.  Heat Transfer in the Cylinders of Reciprocating Internal Combustion Engines , 1963 .

[12]  L. Schwartz.  Handbook Of Heat Transfer , 2016 .

[13]  Y. Çengel.  Heat Transfer: A Practical Approach , 1997 .

[14]  E. B. Qvale,et al.  Instantaneous Heat Transfer to the Cylinder Wall in Reciprocating Compressors , 1972 .

[15]  Perry Y. Li,et al.  Optimal Efficiency-Power Tradeoff for an Air Motor/Compressor With Volume Varying Heat Transfer Capability , 2011 .

[16]  W. Hsieh,et al.  Experimental investigation of heat transfer in a high-pressure reciprocating gas compressor , 1996 .

[17]  R. Liu,et al.  Heat Transfer Between Gas and Cylinder Wall of Refrigerating Reciprocating Compressor , 1984 .

[18]  Grace Ordaz,et al.  The U.S. Department of Energy's National Hydrogen Storage Project: Progress towards meeting hydrogen-powered vehicle requirements , 2007 .