On the rational design of the top wind girder of large storage tanks

Abstract In this paper, simplified mechanical models for the design of the top wind girder of large storage tanks adopted in the codes SH3046 and API650 were presented to show their differences regarding the wind load magnitude and action zone. Finite element models for the tanks were built to study the strengthening effects of the bottom constraints. It is found that for a large storage tank with a small ratio of height to diameter, the strengthening effects of the bottom constraints are significant and should not be ignored. If based on two-dimensional models without considering the strengthening effects of the bottom constraints, the strength design of the top wind girder according to the present codes of SH3046 or API650 is too conservative.

[2]  R. J. Holroyd.  On the behaviour of open-topped oil storage tanks in high winds. part II. structural aspects , 1985 .

[3]  Yasushi Uematsu,et al.  Design wind force coefficients for open-topped oil storage tanks focusing on the wind-induced buckling , 2014 .

[4]  Zhou Ping-huai.  Performance under force of column-supported steel silos under wind loading , 2005 .

[5]  A. Kareem,et al.  Efficacy of Averaging Interval for Nonstationary Winds , 2014 .

[6]  Yang Zhao,et al.  Buckling of cylindrical open-topped steel tanks under wind load , 2014 .

[7]  Claudio Borri,et al.  A new type of bistable flow around circular cylinders with spanwise stiffening rings , 2013 .

[8]  D. Briassoulis,et al.  Behaviour of empty steel grain silos under wind loading: part 1: the stiffened cylindrical shell , 1986 .

[9]  Kenny C. S Kwok,et al.  Wind loads on circular storage bins, silos and tanks: I. Point pressure measurements on isolated structures , 1988 .

[10]  R F Rish.  FORCES IN CYLINDRICAL CHIMNEYS DUE TO WIND. , 1967 .

[11]  Jin Tao.  Response of Large Scale Oil Storage Tanks Subjected to Wind Load , 2013 .

[12]  Luis A. Godoy,et al.  Imperfection sensitivity to elastic buckling of wind loaded open cylindrical tanks , 2002 .

[13]  Yang Zhao,et al.  Buckling behavior of floating-roof steel tanks under measured differential settlement , 2013 .

[14]  R. Greiner,et al.  Effect of imperfections on wind-loaded cylindrical shells , 1995 .

[16]  Jian Fei Chen,et al.  Effective cross sections of asymmetric rings on cylindrical shells , 1998 .

[17]  Jianguo Gong,et al.  Effect of top stiffening rings of open top tanks on critical harmonic settlement , 2013 .

[18]  R. J. Holroyd,et al.  On the behaviour of open-topped oil storage tanks in high winds. Part I. Aerodynamic aspects , 1983 .

[19]  Cem Topkaya,et al.  Ideal Location of Intermediate Ring Stiffeners on Discretely Supported Cylindrical Shells , 2014 .