Hydrophobic PVDF/graphene hybrid membrane for CO2 absorption in membrane contactor

Abstract Graphene nanosheets were incorporated into polyvinylidene fluoride (PVDF) membrane in order to improve the membrane hydrophobicity. The hybrid membrane was prepared using the non-solvent induced phase separation method, and used in a membrane contactor for CO 2 absorption. The incorporation of graphene induced the PVDF crystal transformation from γ -form to α -form, and resulted in a more open and loose sub-layer structure. The hydrophobicity of the hybrid membrane was enhanced compared to the pristine PVDF membrane. However, the increase in the contact angle values with the graphene concentration only occurred for the bottom surface (i.e., the surface of the substrate interface). The CO 2 absorption performance with water as the absorption solution was dependent on the membrane orientation. When the bottom surface of high roughness faced the absorption solution, the hybrid membrane exhibited a faster CO 2 transfer. Due to the improvement in the membrane hydrophobicity, the wetting problem was significantly mitigated, and a long term run with high CO 2 absorption efficiency could be guaranteed. Our results demonstrated that the incorporation of graphene is a promising approach to obtain hydrophobic PVDF membrane for gas membrane absorption.

[1]  A. Mansourizadeh,et al.  Structurally developed microporous polyvinylidene fluoride hollow-fiber membranes for CO2 absorption with diethanolamine solution , 2013, Journal of polymer research.

[2]  Yanji Zhu,et al.  A robust superhydrophobic PVDF composite coating with wear/corrosion-resistance properties , 2015 .

[3]  A. Ismail,et al.  Effect of SMM concentration on morphology and performance of surface modified PVDF hollow fiber membrane contactor for CO2 absorption , 2013 .

[4]  Ahmad Fauzi Ismail,et al.  A comparative study on the structure and performance of porous polyvinylidene fluoride and polysulfone hollow fiber membranes for CO2 absorption , 2010 .

[5]  Jian-Gang Lu,et al.  Wetting mechanism in mass transfer process of hydrophobic membrane gas absorption , 2008 .

[6]  P. Sukitpaneenit,et al.  Molecular elucidation of morphology and mechanical properties of PVDF hollow fiber membranes from aspects of phase inversion, crystallization and rheology , 2009 .

[7]  W. Ramli,et al.  Effect of ethanol concentration in water coagulation bath on pore geometry of PVDF membrane for Membrane Gas Absorption application in CO2 removal , 2012 .

[8]  Rong Wang,et al.  Effect of membrane structure on mass-transfer in the membrane gas–liquid contacting process using microporous PVDF hollow fibers , 2006 .

[9]  G. Versteeg,et al.  Membrane–solvent selection for CO2 removal using membrane gas–liquid contactors , 2004 .

[10]  M. Elimelech,et al.  Engineering flat sheet microporous PVDF films for membrane distillation , 2015 .

[11]  M. Al-Marzouqi,et al.  Effect of PVDF concentration on the morphology and performance of hollow fiber membrane employed as gas–liquid membrane contactor for CO2 absorption , 2012 .

[12]  A. Ismail,et al.  Development of asymmetric polysulfone hollow fiber membrane contactor for CO2 absorption , 2012 .

[13]  Hassan A. Arafat,et al.  Pore structure control of PVDF membranes using a 2-stage coagulation bath phase inversion process for application in membrane distillation (MD) , 2014 .

[14]  Eric Favre,et al.  Membrane processes and postcombustion carbon dioxide capture: Challenges and prospects , 2011 .

[15]  Huanjun Li,et al.  Superhydrophobic polyvinylidene fluoride/graphene porous materials , 2011 .

[16]  C. Batt,et al.  Dramatic Enhancements in Toughness of Polyvinylidene Fluoride Nanocomposites via Nanoclay‐Directed Crystal Structure and Morphology , 2004 .

[17]  Ahmad Fauzi Ismail,et al.  Effect of general montmorillonite and Cloisite 15A on structural parameters and performance of mixed matrix membranes contactor for CO2 absorption , 2015 .

[18]  François M. Peeters,et al.  Water on graphene: Hydrophobicity and dipole moment using density functional theory , 2009 .

[19]  Edward L Cussler,et al.  Microporous hollow fibers for gas absorption. I. Mass transfer in the liquid , 1985 .

[20]  K. Kim,et al.  Poly(vinylidene fluoride)/poly(ethylene-co-vinyl acetate) (20/80) blend. II. Crystalline structure and morphology , 2007 .

[21]  D. R. Lloyd,et al.  Microporous membrane formation via thermally induced phase separation. I. Solid-liquid phase separation , 1990 .

[22]  A. Ismail,et al.  Development of high performance surface modified polyetherimide hollow fiber membrane for gas–liquid contacting processes , 2012 .

[23]  Sina Bonyadi,et al.  Flux enhancement in membrane distillation by fabrication of dual layer hydrophilic–hydrophobic hollow fiber membranes , 2007 .

[24]  Z. H. Li,et al.  Batwing-like polymer membrane consisting of PMMA-grafted electrospun PVdF–SiO2 nanocomposite fibers for lithium-ion batteries , 2015 .

[25]  R. Czerw,et al.  Properties of Polyvinylidene Difluoride−Carbon Nanotube Blends , 2004 .

[26]  Huanting Wang,et al.  The effect of reduction degree of GO nanosheets on microstructure and performance of PVDF/GO hybrid membranes , 2016 .

[27]  A. Ismail,et al.  Porous PES and PEI hollow fiber membranes in a gas-liquid contacting process—A comparative study , 2015 .

[28]  Rong Wang,et al.  Influence of membrane wetting on CO2 capture in microporous hollow fiber membrane contactors , 2005 .

[29]  A. Rahimi,et al.  Lubricant facilitated thermo-mechanical stretching of PTFE and morphology of the resulting membranes , 2014 .

[30]  Kamalesh K. Sirkar,et al.  Gas absorption studies in microporous hollow fiber membrane modules , 1993 .

[31]  V. Bugatti,et al.  Behavior of epoxy composite resins in environments at high moisture content , 2013, Journal of Polymer Research.

[32]  Paitoon Tontiwachwuthikul,et al.  Comparing membrane resistance and absorption performance of three different membranes in a gas absorption membrane contactor , 2009 .

[33]  Ahmad Fauzi Ismail,et al.  Effect of LiCl concentration in the polymer dope on the structure and performance of hydrophobic PVDF hollow fiber membranes for CO2 absorption , 2010 .

[34]  Vicki Chen,et al.  Superhydrophobic modification of TiO2 nanocomposite PVDF membranes for applications in membrane distillation , 2012 .

[35]  George P. Sakellaropoulos,et al.  A study of mass transfer resistance in membrane gas–liquid contacting processes , 2006 .

[36]  M. Iliuta,et al.  Absorption of CO2 by AHPD–Pz aqueous blend in PTFE hollow fiber membrane contactors , 2014 .

[37]  E. Dahlquist,et al.  Fabrication and characterization of superhydrophobic polypropylene hollow fiber membranes for carbon dioxide absorption , 2012 .

[38]  John H. Lienhard,et al.  Superhydrophobic condenser surfaces for air gap membrane distillation , 2015 .

[39]  P. Pearson,et al.  Atmospheric carbon dioxide concentrations over the past 60 million years , 2000, Nature.

[40]  Paitoon Tontiwachwuthikul,et al.  Using polypropylene and polytetrafluoroethylene membranes in a membrane contactor for CO2 absorption , 2006 .

[41]  Edward L Cussler,et al.  Microporous hollow fibers for gas absorption : II. Mass transfer across the membrane , 1985 .

[42]  A. Bottino,et al.  Preparation and properties of novel organic–inorganic porous membranes , 2001 .

[43]  Min Liu,et al.  Morphological and hydrophobic modifications of PVDF flat membrane with silane coupling agent grafting via plasma flow for VMD of ethanol–water mixture , 2015 .

[44]  Takeshi Matsuura,et al.  Effects of superhydrophobic SiO2 nanoparticles on the performance of PVDF flat sheet membranes for vacuum membrane distillation , 2015 .

[45]  S. Khondaker,et al.  Graphene based materials: Past, present and future , 2011 .

[46]  Ahmad Fauzi Ismail,et al.  Preparation and characterization of PVDF-montmorillonite mixed matrix hollow fiber membrane for gas-liquid contacting process , 2014 .

[47]  Mo Song,et al.  Preparation and characterization of high performance of graphene/nylon nanocomposites , 2013 .

[48]  Xiaolong Lu,et al.  Effect of long-term operation on the performance of polypropylene and polyvinylidene fluoride membrane contactors for CO2 absorption , 2013 .

[49]  Ahmed Aboudheir,et al.  Modelling the Performance of a CO~2 Absorber Containing Structured Packing , 2006 .

[50]  Erik Dahlquist,et al.  Wetting of polypropylene hollow fiber membrane contactors , 2010 .

[51]  A. Ismail,et al.  A novel surface modified polyetherimide hollow fiber membrane for gas–liquid contacting processes , 2012 .

[52]  L. Cheng,et al.  Formation of particulate microporous poly(vinylidene fluoride) membranes by isothermal immersion precipitation from the 1-octanol/dimethylformamide/poly(vinylidene fluoride) system , 1999 .

[53]  N. Nuraje,et al.  Study of superhydrophobic electrospun nanocomposite fibers for energy systems. , 2011, Langmuir : the ACS journal of surfaces and colloids.