Closed-Loop Stall Control System

A closed-loop, stall sense and control system was demonstrated on a morphing airfoil. The FlexSys, Inc. Mission Adaptive Compliant Wing was modified to accept a Boeing Co. dielectric barrier discharge actuator panel in a location immediately upstream of the trailing-edge morphing flap, and hot-film sensors were installed on the model surface. A signal analysis algorithm, developed by Tao Systems, Inc., was applied to the hot-film signals to detect separation and trigger activation of the dielectric barrier discharge actuators. The system was successfully demonstrated in the U.S. Air Force Research Laboratory Phillip P. Antonatos Subsonic Aerodynamics Research Laboratory wind-tunnel facility, and an improvement in lift of about 10% was observed at Mach 0.05 (chord Reynolds number 9 x 10 5 ) under closed-loop control and a turbulent boundary-layer state. Actuator effectiveness was demonstrated up to Mach 0.1, but must be extended to Mach 0.2-0.3 to enable a practical stall control system for takeoff and approach of large aircraft. It may be possible to obtain that level of performance by optimizing the actuator locations and input waveforms.

[1]  Jamey Jacob,et al.  Flow control with plasma synthetic jet actuators , 2007 .

[2]  Nicholas J. Bisek,et al.  High-Speed Flow Control with Electrical Discharges , 2011 .

[3]  Thomas McLaughlin,et al.  Closed-Loop Plasma Active Control Technology (CLOPACT) , 2007 .

[4]  M. Samimy,et al.  Separation Control from the Flap of a High-Lift Airfoil using DBD Plasma Actuators , 2008 .

[5]  E. Moreau,et al.  Optimization of a dielectric barrier discharge actuator by stationary and non-stationary measurements of the induced flow velocity: application to airflow control , 2007 .

[6]  A. A. Sidorenko,et al.  Flight Testing of DBD Plasma Separation Control System , 2008 .

[7]  M. S. Chong,et al.  A Description of Eddying Motions and Flow Patterns Using Critical-Point Concepts , 1987 .

[8]  Arun S. Mangalam,et al.  Unsteady Aerodynamic Observable for Gust Load Alleviation and Flutter Suppression , 2008 .

[9]  Chuan He,et al.  Plasma Actuators for Hingeless Aerodynamic Control of an Unmanned Air Vehicle , 2006 .

[10]  J. Roth,et al.  Electrohydrodynamic Flow Control with a Glow-Discharge Surface Plasma , 2000 .

[11]  Thomas Corke,et al.  Plasma Flaps and Slats: An Application of Weakly Ionized Plasma Actuators , 2004 .

[12]  Harold Youngren.  Multi-Point Design and Optimization of an Natural Laminar Flow Airfoil for a Mission Adaptive Compliant Wing , 2008 .

[13]  M. Samimy,et al.  Flow Separation Control Using Nanosecond Pulse Driven DBD Plasma Actuators , 2011 .

[14]  Sridhar Kota,et al.  The Quest for Efficient Transonic Cruise , 2007 .

[15]  M. R. Malik,et al.  Ion wind drag reduction , 1983 .

[16]  Thomas McLaughlin,et al.  Time-correlated force production measurements of the dielectric barrier discharge plasma aerodynamic actuator , 2008 .

[17]  Boris V. Postnikov,et al.  Pulsed Discharge Actuators for Rectangular Wing Separation Control , 2007 .

[18]  Robert King,et al.  Adaptive Closed-Loop Separation Control on a High-Lift Configuration Using Extremum Seeking , 2006 .

[19]  Thomas Corke,et al.  Plasma Flaps and Slats: An Application of Weakly Ionized Plasma Actuators , 2004 .

[20]  Sridhar Kota,et al.  Flight testing of Mission Adaptive Compliant Wing , 2007 .

[21]  Chuan He,et al.  Autonomous Sensing and Control of Wing Stall Using a Smart Plasma Slat , 2006 .