A smart 2-D wind sensor with self-test function

A 2-D smart wind sensor with self-testing function was designed, fabricated and tested in this paper. It is composed of cross-structure heaters and four symmetrically located sensing parts. When the flow angle changes clockwise, the temperature differences among the four parts, namely T13 (T24) and T12 (T14) will be sine (cosine) functions of wind direction. Further study shows that the amplitudes of T13 and T24 are radic2 times of T12 and T14, and the phases are 45 degree before the latter. Then two wind direction values can be obtained for self-test without additional components. In order to achieve moderate sensitivity without post-MEMS etching, thermal insulated substrate was introduced to fabricate calorimetric flow sensor instead of silicon wafer. The proposed sensor was fabricated on the low thermal conduction substrate Pyrex7740 using single lift-off process. Finally, wind tunnel test was carried out in constant power (CP) mode, and the test results show reasonable agreement with the simulation results.

[1]  Mona E. Zaghloul,et al.  In the flow with MEMS , 1998 .

[2]  Neil Genzlinger.  A. and Q , 2006 .

[3]  Miko Elwenspoek,et al.  Thermal flow micro sensors , 1999, CAS '99 Proceedings. 1999 International Semiconductor Conference (Cat. No.99TH8389).

[4]  G. Wachutka,et al.  Fabrication and modelling of CMOS microbridge gas-flow sensors , 1992 .

[5]  Nam-Trung Nguyen,et al.  Micromachined flow sensors—a review , 1997, Flow Measurement and Instrumentation.

[6]  Henry Baltes,et al.  A high sensitivity CMOS gas flow sensor on a thin dielectric membrane , 1993 .

[7]  Ming Qin,et al.  Flip-Chip Packaging for a Two-Dimensional Thermal Flow Sensor Using a Copper Pillar Bump Technology , 2007, IEEE Sensors Journal.

[8]  Qin Ming,et al.  Design of a 2D Thermal Wind Sensor Based on MEMS Process , 2007 .

[9]  O. Paul,et al.  Single-chip CMOS anemometer , 1997, International Electron Devices Meeting. IEDM Technical Digest.

[10]  Qing-An Huang,et al.  SPICE Model with Lumped Circuits for A Thermal Flow Sensor , 2006, 2006 5th IEEE Conference on Sensors.

[11]  B. W. Oudheusden,et al.  Silicon thermal flow sensor with a two-dimensional direction sensitivity , 1990 .

[12]  B. W. Oudheusden,et al.  Silicon flow sensors , 1988 .

[13]  Henry Baltes,et al.  Two-dimensional integrated gas flow sensors by CMOS IC technology , 1995 .

[14]  Kofi A. A. Makinwa,et al.  A wind sensor with an integrated low-offset instrumentation amplifier , 2001, ICECS 2001. 8th IEEE International Conference on Electronics, Circuits and Systems (Cat. No.01EX483).

[15]  Louis Vessot King,et al.  On the Convection of Heat from Small Cylinders in a Stream of Fluid: Determination of the Convection Constants of Small Platinum Wires with Applications to Hot-Wire Anemometry , 1914 .

[16]  Sekwang Park,et al.  Measurement of flow direction and velocity using a micromachined flow sensor , 2004 .