Effects of pin tip-clearance on the performance of an enhanced microchannel heat sink with oblique fins and phase change material slurry

Abstract The performance of an enhanced microchannel heat sink with sectional oblique fins and with a coolant that contains Nano-Encapsulated Phase Change Material (NEPCM) particles is investigated using a 3D conjugated heat transfer model. Three volume fractions from ξ  = 0 (pure water) to 0.3 are studied to investigate the effects of presence of NEPCM particles. Then the effects of introducing tip-clearance to the heat sink on thermal and hydrodynamic performance is examined at low Reynolds numbers (less than 215). Four values of tip-clearance to channel width ratio ( t / W c ) are investigated ranging from a no gap ( t / W c  = 0) to t / W c  = 0.74. On the bottom wall of the heat sink a range of uniform and fixed temperatures of 299.15 K to 340.15 K are applied. The cooling and hydrodynamic performance of the heat sink is studied using Nusselt and Euler numbers, respectively. It was observed that using of NEPCM slurry in contrast with pure water, enhanced the cooling performance of the heat sink but increased the Euler number. Furthermore, it was seen that the introduction of tip-clearance to the heat sink, if the clearance ratio is chosen properly, has the potential to enhance the cooling performance and reducing the Euler number simultaneously.

[1]  A. Abdel-azim.  Fundamentals of Heat and Mass Transfer , 2011 .

[2]  S. Kim,et al.  Effect of tip clearance on the cooling performance of a microchannel heat sink , 2004 .

[3]  Binjiao Chen,et al.  Flow and heat transfer behaviors of phase change material slurries in a horizontal circular tube , 2007 .

[4]  Siaw Kiang Chou,et al.  Numerical Study of Fluid Flow and Heat Transfer in the Enhanced Microchannel With Oblique Fins , 2013 .

[5]  J. W. Ramsey,et al.  Experiments on In-line Pin Fin Arrays and Performance Comparisons with Staggered Arrays , 1980 .

[6]  Hongbin Ma,et al.  Three dimensional numerical study of heat-transfer enhancement by nano-encapsulated phase change material slurry in microtube heat sinks with tangential impingement , 2013 .

[7]  S. Al-Hallaj,et al.  Heat Transfer Characteristics of Liquid Flow With Micro-Encapsulated Phase Change Material: Experimental Study , 2011 .

[8]  P. Charunyakorn,et al.  Forced convection heat transfer in microencapsulated phase change material slurries: flow in circular ducts , 1991 .

[9]  Yoav Peles,et al.  Convective heat transfer and mixing enhancement in a microchannel with a pillar , 2013 .

[10]  Amir Faghri,et al.  Analysis of Forced Convection Heat Transfer in Microencapsulated Phase Change Material Suspensions , 1995 .

[11]  V. Vand.  Viscosity of solutions and suspensions; experimental determination of the viscosity-concentration function of spherical suspensions. , 1948, The Journal of physical and colloid chemistry.

[12]  S. Sengupta,et al.  Laminar forced convection heat transfer in microcapsulated phase change material suspensions , 1994 .

[13]  A. Koşar,et al.  Thermal-hydraulic performance of MEMS-based pin fin heat sink , 2006 .

[14]  José M. Vega,et al.  Experimental study of heat transfer and pressure drop in micro-channel based heat sinks with tip clearance , 2011 .

[15]  Xianxu Hu,et al.  Theoretical analysis of convective heat transfer enhancement of microencapsulated phase change material slurries , 2003 .

[16]  S. G. Mason,et al.  The kinetics of flowing dispersions: I. Concentrated suspensions of rigid particles , 1966 .

[17]  S. Roy,et al.  Forced Convection Heat Transfer to Phase Change Material Slurries in Circular Ducts , 2000 .

[18]  Andreas Acrivos,et al.  Entrance region heat transfer in flowing suspensions , 1976 .

[19]  V. Vand.  Viscosity of solutions and suspensions; theory. , 1948, The Journal of physical and colloid chemistry.

[20]  S. Chou,et al.  Enhanced Thermal Transport in Microchannel Using Oblique Fins , 2012 .

[21]  S. Kandlikar,et al.  SINGLE-PHASE LIQUID HEAT TRANSFER IN PLAIN AND ENHANCED MICROCHANNELS , 2006 .

[22]  H. Fernholz.  Boundary Layer Theory , 2001 .

[23]  F. Gauthier,et al.  The kinetics of flowing dispersions , 1967 .

[24]  Yogendra Joshi,et al.  Effect of Tip Clearance on the Thermal and Hydrodynamic Performance of a Shrouded Pin Fin Array , 2003 .

[25]  Danesh K. Tafti,et al.  Effect of Pin Tip Dual Clearance on Flow and Heat Transfer at Low Reynolds Numbers , 2008 .

[26]  Yoav Peles,et al.  An Experimental Study of Passive and Active Heat Transfer Enhancement in Microchannels , 2014 .

[27]  Yildiz Bayazitoglu,et al.  Optimization of short micro pin fins in minichannels , 2012 .

[28]  N. Guan,et al.  Influence of tip clearance on heat transfer efficiency in micro-cylinders-group heat sink , 2013 .

[29]  V. VAND,et al.  Theory of Viscosity of Concentrated Suspensions , 1945, Nature.

[30]  Louis C. Chow,et al.  Numerical Investigation of Flow and Heat Transfer Performance of Nano-Encapsulated Phase Change Material Slurry in Microchannels , 2009 .