Tri-dimensional eccentricity model of a rod lip seal
暂无分享,去创建一个
Josu Aguirrebeitia | Marcello Conte | Amaya Igartua | B. Pinedo | A. Igartua | J. Aguirrebeitia | M. Conte | B. Pinedo
[1] George K. Nikas,et al. Eighty years of research on hydraulic reciprocating seals: Review of tribological studies and related topics since the 1930s , 2010 .
[2] Heinz K. Müller,et al. Fluid Sealing Technology , 1998 .
[3] Josu Aguirrebeitia,et al. Theoretical calculation of general static load-carrying capacity for the design and selection of three row roller slewing bearings , 2012 .
[4] Terenziano Raparelli,et al. Test rig for rod seals contact pressure measurement , 2010 .
[5] A. Tasora,et al. A method for the characterization of static elastomeric lip seal deformation , 2013 .
[6] Josu Aguirrebeitia,et al. Calculation of General Static Load-Carrying Capacity for the Design of Four-Contact-Point Slewing Bearings , 2010 .
[7] Chao-Sung Lin,et al. Simulation and experimentation on the contact width and pressure distribution of lip seals , 2006 .
[8] Marcello Conte,et al. Frictional heating calculation based on tailored experimental measurements , 2014 .
[10] Luigi Mazza,et al. Photoelastic measurements and computation of the stress field and contact pressure in a pneumatic lip seal , 1999 .
[11] Richard F. Salant,et al. Hydrodynamic Effects of Shaft Surface Finish on Lip Seal Operation , 2002 .
[12] Gustavo Belforte,et al. Experimental and numerical evaluation of contact pressure in pneumatic seals , 2009 .
[13] Robert Flitney,et al. Seals and Sealing Handbook , 2007 .