Investigation of plate geometry on the crushing of flat composite plates

The aim of this work was to identify the energy absorbing capabilities of fibre reinforced composites manufactured using glass-fibre multiaxial warp-knit non-crimp fabrics (NCF) for use in low-cost, weight-critical energy absorbing structures. A variety of layups, using polyester and epoxy matrices, were evaluated using a plate crush rig. The plates were tested at varying unsupported widths to identify the stability of the different orientations. It was found that the energy absorbed was dependent upon the stability of the laminates and possible delamination of outer plies during the crush. The different resins appeared to have little influence in the specific crushing stresses (SSCS). Additionally, comparison of the results with the literature for tubes showed that the trends observed for the crushing of plates were comparable.

[1]  D. Hull,et al.  A unified approach to progressive crushing of fibre-reinforced composite tubes , 1991 .

[2]  P. H. Thornton.  The crush behavior of glass fiber reinforced plastic sections , 1986 .

[3]  Hiroyuki Hamada,et al.  Energy Absorption Behavior of Carbon-Fiber-Reinforced Thermoplastic Composite Tubes , 1995 .

[4]  Gary L. Farley,et al.  Effect of Fiber and Matrix Maximum Strain on the Energy Absorption of Composite Materials , 1985 .

[5]  M. Jiménez,et al.  Effect of trigger geometry on energy absorption in composite profiles , 2000 .

[6]  Anthony J. Vizzini,et al.  Off-Axis Energy Absorption Characterization of Composites for Crashworthy Rotorcraft Design , 1996 .

[7]  Chris D. Rudd,et al.  Effect of resin properties and processing parameters on crash energy absorbing composite structures made by RTM , 2003 .

[8]  Karen E. Jackson,et al.  Scaling of Energy Absorbing Composite Plates , 1994 .

[9]  The Energy Absorption of Composite Plates under Off-Axis Loads , 1996 .

[10]  J A. Lavoie,et al.  A crush test fixture for investigating energy arsorption of flat composite plates , 1994 .

[11]  P. H. Thornton,et al.  Energy Absorption in Composite Structures , 1979 .

[12]  R. Velmurugan,et al.  An Analysis of Axial Crushing of Composite Tubes , 1997 .

[13]  V. Karbhari,et al.  Energy Absorption Characteristics of Hybrid Braided Composite Tubes , 1997 .

[14]  Sotiris Kellas,et al.  Dynamic crush tests of energy-absorbing laminated composite plates , 1996 .

[15]  Paul J. Hogg,et al.  The relative effects of through-thickness properties and fibre orientation on energy absorption by continuous fibre composites , 1999 .

[16]  John Morton,et al.  An Evaluation of the Energy Absorption of Laminated Composite Plates , 1995 .