Investigation of Multiple Miniature Axial Fan Cooling Solutions and Thermal Modeling Approaches
暂无分享,去创建一个
[1] S.V. Garimella,et al. Pressure and Flow Rate Performance of Piezoelectric Fans , 2009, IEEE Transactions on Components and Packaging Technologies.
[2] Sheam-Chyun Lin,et al. Blockage effect of axial-flow fans applied on heat sink assembly , 2004 .
[3] Ronan Grimes,et al. Low profile fan and heat sink thermal management solution for portable applications , 2007 .
[4] C. J. Meyer. Numerical investigation of the effect of inlet flow distortions on forced draught air-cooled heat exchanger performance , 2005 .
[5] S. Eiamsa-ard,et al. Heat transfer enhancement by multiple swirling impinging jets with twisted-tape swirl generators , 2012 .
[6] Mark Davies,et al. Modeling Electronic Cooling Axial Fan Flows , 2001 .
[7] Suresh V. Garimella,et al. Analysis and Prediction of the Thermal Performance of Piezoelectrically Actuated Fans , 2009 .
[8] Zhipeng Duan,et al. Experimental Investigation of Heat Transfer in Impingement Air Cooled Plate Fin Heat Sinks , 2005 .
[9] E. Walsh,et al. Local heat transfer performance and exit flow characteristics of a miniature axial fan , 2010 .
[10] Toru Shigemitsu,et al. Unsteady flow condition of contra-rotating small-sized axial fan , 2011 .
[11] R. Grimes,et al. The Effect of Reynolds Number on Microaxial Flow Fan Performance , 2008 .
[12] Puligandla Viswanadham. Essentials of Electronic Packaging , 2001 .
[13] Jung-Yang San,et al. Optimum jet-to-jet spacing of heat transfer for staggered arrays of impinging air jets , 2001 .
[14] E. Walsh,et al. Characterizing convective heat transfer using infrared thermography and the heated-thin-foil technique , 2009 .
[15] A. Schulz,et al. Infrared thermography as applied to film cooling of gas turbine components , 2000 .
[16] Suresh V. Garimella,et al. Local Heat Transfer Coefficients Induced by Piezoelectrically Actuated Vibrating Cantilevers , 2007 .
[17] Yijun Mao,et al. Numerical calculation of centrifugal fan noise , 2006 .
[18] Perturbation of a laminar boundary layer by a synthetic jet for heat transfer enhancement , 2010 .
[19] T. W. von Backström,et al. Effect of cross-flow on the performance of air-cooled heat exchanger fans , 2002 .
[20] M. Amitay,et al. Electronic Cooling Using Synthetic Jet Impingement , 2006 .
[21] M. Baris Dogruoz,et al. Validation of an advanced fan model with multiple reference frame approach , 2010, 2010 12th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems.
[22] A. Agrawal,et al. A numerical investigation of effects of cavity and orifice parameters on the characteristics of a synthetic jet flow , 2011 .
[23] A. Agrawal,et al. Multiple orifice synthetic jet for improvement in impingement heat transfer. , 2011 .
[24] Yingzi Jin,et al. Effects of rotor structure on performance of small size axial flow fans , 2011 .
[25] Jingzhou Zhang,et al. Convective heat transfer on a flat plate subjected to normally synthetic jet and horizontally forced flow , 2013 .
[26] Pablo D. Quinones,et al. Multiple Fan-Heat Sink Cooling System With Enhanced Evaporator Base: Design, Modeling, and Experiment , 2009 .