Fast relaxation of stresses in solid oxide cells through reduction. Part I: Macro-stresses in the cell layers

[1]  H. Frandsen,et al.  Reversible solid-oxide cells for clean and sustainable energy , 2019, Clean Energy.

[2]  F. Iguchi,et al.  Influence of NiO Reduction on Residual Strain in NiO/Ni-YSZ , 2018 .

[3]  M. Radovic,et al.  Thermal expansion and elastic moduli of electrolyte materials for high and intermediate temperature solid oxide fuel cell , 2017 .

[4]  P. Trtik,et al.  Coupling between creep and redox behavior in nickel - yttria stabilized zirconia observed in-situ by monochromatic neutron imaging , 2017 .

[5]  Luise Theil Kuhn,et al.  In situ time-of-flight neutron imaging of NiO-YSZ anode support reduction under influence of stress , 2016 .

[6]  P. Hendriksen,et al.  Accelerated creep in solid oxide fuel cell anode supports during reduction , 2016 .

[7]  H. Frandsen,et al.  Residual stresses and strength of multilayer tape cast solid oxide fuel and electrolysis half-cells , 2015 .

[8]  H. Frandsen,et al.  Effect of stress on NiO reduction in solid oxide fuel cells: a new application of energy-resolved neutron imaging , 2015 .

[9]  Jan Van herle,et al.  Modelling the impact of creep on the probability of failure of a solid oxide fuel cell stack , 2014 .

[10]  H. Frandsen,et al.  Residual stresses in a co-sintered SOC half-cell during post-sintering cooling , 2014 .

[11]  D. Favrat,et al.  Mechanical reliability and durability of SOFC stacks. Part I: Modelling of the effect of operating conditions and design alternatives on the reliability , 2012 .

[12]  Henrik Lund Frandsen,et al.  Optimization of the strength of SOFC anode supports , 2012 .

[13]  H. Frandsen,et al.  Strength of Anode‐Supported Solid Oxide Fuel Cells , 2011 .

[14]  D. Favrat,et al.  Electrochemical Model of Solid Oxide Fuel Cell for Simulation at the Stack Scale II: Implementation of Degradation Processes , 2011 .

[15]  D. Favrat,et al.  Electrochemical Model of Solid Oxide Fuel Cell for Simulation at the Stack Scale I. Calibration Procedure on Experimental Data , 2011 .

[16]  D. Favrat,et al.  Sensitivity of Stresses and Failure Mechanisms in SOFCs to the Mechanical Properties and Geometry of the Constitutive Layers , 2011 .

[17]  Jodi Liu,et al.  Calculation of effective penetration depth in X-ray diffraction for pharmaceutical solids. , 2010, Journal of pharmaceutical sciences.

[18]  Alan Atkinson,et al.  Effect of Thermal Cycling on Residual Stress and Curvature of Anode‐Supported SOFCs , 2009 .

[19]  M. Mogensen,et al.  Mechanical properties of NiO/Ni–YSZ composites depending on temperature, porosity and redox cycling , 2009 .

[20]  H. Frandsen,et al.  Curvature and Strength of Ni-YSZ Solid Oxide Half-Cells After Redox Treatments , 2009 .

[21]  J. Malzbender,et al.  Studies of residual stresses in planar solid oxide fuel cells , 2008 .

[22]  E. Lara‐Curzio,et al.  Effect of Thermal Cycling and Thermal Aging on the Mechanical Properties of, and Residual Stresses in, Ni‐YSZ/YSZ Bi‐Layers , 2008 .

[23]  P. Larsen,et al.  Manufacturing of Anode-Supported SOFC's: Processing Parameters and their Influence , 2007 .

[24]  J. Malzbender,et al.  Curvature of Planar Solid Oxide Fuel Cells during Sealing and Cooling of Stacks , 2006 .

[25]  J. Malzbender,et al.  Residual stresses in planar solid oxide fuel cells , 2005 .

[26]  M. Mori,et al.  Thermal expansion coefficient of yttria stabilized zirconia for various yttria contents , 2005 .

[27]  H. Yakabe,et al.  Evaluation of the residual stress for anode-supported SOFCs , 2004 .

[28]  Jiangyu Li,et al.  X-ray diffraction measurement of residual stress in PZT thin films prepared by pulsed laser deposition , 2004 .

[29]  T. Ohji,et al.  Effect of Agglomeration on Mechanical Properties of Porous Zirconia Fabricated by Partial Sintering , 2002 .

[30]  A. Atkinson,et al.  Mechanical behaviour of ceramic oxygen ion-conducting membranes , 2000 .

[31]  A. Selçuk,et al.  Residual stress and fracture of laminated ceramic membranes , 1999 .

[32]  A. Selçuk,et al.  Elastic properties of ceramic oxides used in solid oxide fuel cells (SOFC) , 1997 .

[33]  N. Ramakrishnan,et al.  Effective elastic moduli of porous solids , 1990 .

[34]  H. Schubert.  Anisotropic Thermal Expansion Coefficients of Y2O3‐Stabilized Tetragonal Zirconia , 1986 .

[35]  Paul S. Prevéy,et al.  X-RAY DIFFRACTION RESIDUAL STRESS TECHNIQUES , 1986 .

[36]  Naoya Uchida,et al.  Elastic Constants and Acoustic Absorption Coefficients in MnO, CoO, and NiO Single Crystals at Room Temperature , 1972 .

[37]  G. A. Alers,et al.  Temperature dependent magnetic contributions to the high field elastic constants of nickel and an Fe-Ni alloy , 1960 .