A mechanics based study of crack closure measurement techniques under constant amplitude loading

Abstract An elastic–plastic finite element model was used to simulate a growing fatigue crack in a middle-crack tension specimen made of an aluminum alloy. The finite element analysis provided the load–displacement curve at various locations as is commonly done in experimental work, and the crack opening stress intensity factor (Kop) was determined with ASTM standard methods, Elber’s method, and the Adjusted Compliance Ratio (ACR) method. The performance of ACR was compared against the established standard methods. Measurement location effects on Kop and ACR were investigated. ASTM (2% offset) and ACR methods gave values that were dependent upon measurement location. Whereas, Elber’s method (0% offset) gave values that were independent of measurement location.

[1]  D. Kujawski,et al.  Methods for crack opening load and crack tip shielding determination: a review , 2003 .

[2]  Rw Bush,et al.  An Evaluation of the Adjusted Compliance Ratio Technique for Determining the Effective Stress Intensity Factor , 1999 .

[3]  J. Donald,et al.  A Procedure for Standardizing Crack Closure Levels , 1988 .

[4]  Robert H. Dodds,et al.  A numerical investigation of 3-D small-scale yielding fatigue crack growth , 2003 .

[5]  J. Donald.  Introducing the compliance ratio concept for determining effective stress intensity , 1997 .

[6]  Brigitte Weiss,et al.  Contribution of the cyclic loading portion below the opening load to fatigue crack growth , 1996 .

[7]  Brigitte Weiss,et al.  A model for crack closure , 1996 .

[8]  Kiran Solanki,et al.  Finite element modeling of plasticity-induced crack closure with emphasis on geometry and mesh refinement effects , 2003 .

[9]  James C. Newman,et al.  An Evaluation of the Plasticity-Induced Crack-Closure Concept and Measurement Methods , 1998 .

[10]  Paul C. Paris,et al.  An evaluation of ΔKeff estimation procedures on 6061-T6 and 2024-T3 aluminum alloys , 1999 .

[11]  E. Wolf.  Fatigue crack closure under cyclic tension , 1970 .

[12]  David L. Davidson,et al.  The dependence of crack closure on fatigue loading variables , 1988 .

[13]  D. L. Chen,et al.  A new evaluation procedure for crack closure , 1991 .

[14]  B. H. Thacker,et al.  Finite element visualization of fatigue crack closure in plane stress and plane strain , 1991, International Journal of Fracture.

[15]  Jk Donald,et al.  Analysis of the Second ASTM Round-Robin Program on Opening-Load Measurement Using the Adjusted Compliance Ratio Technique , 1999 .

[16]  K George,et al.  Use of ACR Method to Estimate Closure and Residual Stress Free Small Crack Growth Data , 2005 .