Damage assessment and refurbishment of steam turbine blade/rotor attachment holes

Abstract This paper presents a case study dealing with the assessment of cracking observed at steam turbine blade attachment holes, and subsequent use of an innovative repair solution based on a friction processing technique, friction hydro-pillar processing (FHPP). This was performed with a bespoke welding platform developed specifically for repair of radially cracked or incorrectly drilled blade attachment holes in LP turbine rotors. The paper initially outlines a fracture mechanics analysis of observed in-service cracking aimed at assessing critical defect sizes to support repair or replacement scenarios. It then briefly discusses development of the FHPP process before focusing on characterisation of the residual stresses resulting from the welding process and their amelioration by heat treatment; a necessary part of the procedure approval for turbine refurbishment.

[1]  Sanjeev Saxena,et al.  Coupled mechanical, metallurgical and FEM based failure investigation of steam turbine blade , 2015 .

[2]  F. C. Mund.  Steam turbine upgrades for power plant life management and performance improvement , 2011 .

[3]  A. K. Bhaduri.  Repair welding of cracked steam turbine blades using austenitic and martensitic stainless-steel consumables , 2001 .

[4]  Jong-Po Park,et al.  Failure analysis and retrofit design of low pressure 1st stage blades for a steam turbine , 2007 .

[5]  M. N. James,et al.  The Use of Combs for Evaluation of Strain-free References for Residual Strain Measurements by Neutron and Synchrotron X-ray Diffraction , 2003 .

[6]  Steven Chatterton,et al.  Analysis of LP steam turbine blade vibrations: experimental results and numerical simulations , 2012 .

[7]  Chun-ming Lin,et al.  Parameter optimization of laser cladding process and resulting microstructure for the repair of tenon on steam turbine blade , 2015 .

[8]  H. Jing,et al.  Numerical simulation of the effects of various stud and hole configurations on friction hydro-pillar processing , 2015 .

[9]  J. Kubiak Sz.,et al.  Failure analysis of steam turbine last stage blade tenon and shroud , 2007 .

[10]  F. M. Burdekin,et al.  Engineering critical analyses to BS 7910 — the UK guide on methods for assessing the acceptability of flaws in metallic structures , 2000 .

[11]  Thomas H. McCloskey.  Troubleshooting Turbine Steam Path Damage Mechanisms. , 2002 .

[12]  Tung-Liang Chen.  Real-time turbine maintenance system , 2009, Expert Syst. Appl..