Measuring photodarkening from Yb doped fibers

OF DOCTORAL DISSERTATION HELSINKI UNIVERSITY OF TECHNOLOGY P.O. BOX 1000, FI-02015 TKK http://www.tkk.fi Author Joona Koponen Name of the dissertation Measuring photodarkening from Yb doped fibers Manuscript submitted 12.9.2008 Manuscript revised 7.11.2008 Date of the defence 12.12.2008 Monograph Article dissertation (summary + original articles) Faculty Faculty of Electronics, Communications and Automation Department Department of Micro and Nanosciences Field of research Photonics Opponent(s) Dr. Lars Norin Supervisor Prof. Seppo Honkanen Instructor Abstract Yb doped fibers are used widely in applications requiring high beam quality and efficiency. A detrimental phenomenon, photodarkening, is known to reduce the efficiency of fiber devices under some operating conditions, and in extreme cases to prevent lasing altogether. Photodarkening manifests as an incrementally increasing spectrally broad transmission loss in the Yb doped core of a fiber, and it is caused by the exposure to pumpor signal photons. This work focused on development of methods to benchmark fibers for photodarkening, and to develop methods to study the temporal and spatial characteristics of photodarkening. A measurement method for conducting benchmarking and spectral studies on single-mode fibers was developed, and a similar alternative method was developed for large-mode-area fibers. Both approaches were studied experimentally and by simulations. Additionally, an experimental setup was built to study the spatial photodarkening differences in large-mode-area fibers. Observations agreed with the simulated results. Photodarkening rate was found to have a repeatable spectral response with fibers of similar but varying compositions, and the photodarkening induced temporal transmission loss was found to follow a stretched-exponential decay rate, and a bi-exponential decay rate. Photodarkening was found to be proportional to the inversion of a fiber sample; and also to have a 7 power dependency to inversion; and more generally, to have a 7 power dependency to the excited state Yb ion density. The methodology obtained through this work enable benchmarking of Yb doped single-mode and large-mode-area fibers. The observed excited state ion density dependency to the photodarkening rate has strong implications to Yb fiber devices, as a given fiber may photodarken with a high rate in one application (having a higher inversion), and non-measurably in another application (having a lower inversion).

[1]  N. Olsson,et al.  Erbium-Doped Fiber Amplifiers: Fundamentals and Technology , 1999 .

[2]  W. H. Lowdermilk,et al.  Multiphonon relaxation of rare-earth ions in oxide glasses , 1977 .

[3]  Elias Snitzer,et al.  Amplification in a Fiber Laser , 1964 .

[4]  Parekhan M. Aljaff,et al.  Design Optimization for Efficient Erbium- Doped Fiber Amplifiers , 2008 .

[5]  I. M. Jauncey,et al.  Low-noise erbium-doped fibre amplifier operating at 1.54μm , 1987 .

[6]  Mikko Söderlund,et al.  Photodarkening rate in Yb-doped silica fibers. , 2008, Applied optics.

[7]  R. Windeler,et al.  Effect of heat and H2 gas on the photo-darkening of Yb+3 fibers , 2006, 2006 Conference on Lasers and Electro-Optics and 2006 Quantum Electronics and Laser Science Conference.

[8]  Norman Hodgson,et al.  Hybrid fiber MOPA-bulk amplifier system for frequency conversion , 2008, SPIE LASE.

[9]  P.C. Schultz,et al.  Fabrication of optical waveguides by the outside vapor deposition process , 1980, Proceedings of the IEEE.

[10]  Bertrand Morasse,et al.  Low photodarkening single cladding ytterbium fibre amplifier , 2007, SPIE LASE.

[11]  G. Atkins,et al.  Photodarkening in Tb(3+)-doped phosphosilicate and germanosilicate optical fibers. , 1994, Optics letters.

[12]  M. Nakai,et al.  Population inversion factor dependence of photodarkening of Yb-doped fibers and its suppression by highly aluminum doping , 2006, 2006 Optical Fiber Communication Conference and the National Fiber Optic Engineers Conference.

[13]  Sophie LaRochelle,et al.  Photodegradation of fluoride glass blue fiber laser , 1997, Photonics West.

[14]  Dietrich Marcuse,et al.  Field deformation and loss caused by curvature of optical fibers , 1976 .

[15]  Elias Snitzer,et al.  Fabrication of high-concentration rare-earth doped optical fibers using chelates , 1990 .

[16]  J. Archambault,et al.  Photodegradation of near-infrared-pumped Tm(3+)-doped ZBLAN fiber upconversion lasers. , 1996, Optics letters.

[17]  D. Gapontsev,et al.  2 kW CW ytterbium fiber laser with record diffraction-limited brightness , 2005, CLEO/Europe. 2005 Conference on Lasers and Electro-Optics Europe, 2005..

[18]  Takashi Handa,et al.  Aluminum or phosphorus co‐doping effects on the fluorescence and structural properties of neodymium‐doped silica glass , 1986 .

[19]  S. Tammela,et al.  Direct Nanoparticle Deposition process for manufacturing very short high gain Er-doped silica glass fibers , 2002, 2002 28TH European Conference on Optical Communication.

[20]  V. Doya,et al.  Experimental study of pump power absorption along rare-earth-doped double clad optical fibres , 2003 .

[21]  L. B. Glebov.  Linear and Nonlinear Photoionization of Silicate Glasses , 2002 .

[22]  D. Hanna,et al.  Lifetime quenching in Yb-doped fibres , 1997 .

[23]  D. Payne,et al.  Photodarkening in Yb-doped aluminosilicate fibers induced by 488 nm irradiation , 2007 .

[24]  S. Unger,et al.  Efficient Yb laser fibers with low photodarkening by optimization of the core composition. , 2008, Optics express.

[25]  H. Asonen,et al.  Precise patterning of thin films with picosecond fiber laser , 2007 .

[26]  M. K. Durkin,et al.  High peak power high rep-rate pulsed fiber laser for marking applications , 2006, SPIE LASE.

[27]  R. S. Quimby,et al.  General procedure for the analysis of Er(3+) cross sections. , 1991, Optics letters.

[28]  M. M. Broer,et al.  Highly nonlinear near-resonant photodarkening in a thulium-doped aluminosilicate glass fiber. , 1993, Optics letters.

[29]  D. Gloge.  Weakly guiding fibers. , 1971, Applied optics.

[30]  N. N. Il'ichev,et al.  Reversible photo-darkening and resonant photo-bleaching of Ytterbium-doped silica fiber at in-core 977-nm and 543-nm irradiation , 2007 .

[31]  Allen H. Cherin,et al.  An introduction to optical fibers , 1982 .

[32]  Y. Jeong,et al.  Ytterbium-doped large-core fiber laser with 1.36 kW continuous-wave output power. , 2004, Optics express.

[33]  T. Cardinal,et al.  Temporal evolution of photodarkening and successive photobleaching of an Ytterbium-doped silica double-clad LMA fiber , 2007, 2007 European Conference on Lasers and Electro-Optics and the International Quantum Electronics Conference.

[34]  L. Norin,et al.  Preventing photodarkening in ytterbium-doped high power fiber lasers; correlation to the UV-transparency of the core glass. , 2008, Optics express.

[35]  D. Mccumber,et al.  Einstein Relations Connecting Broadband Emission and Absorption Spectra , 1964 .

[36]  W. Smith,et al.  Principles of Materials Science and Engineering , 1986 .

[37]  D. Payne,et al.  Fabrication of low-loss optical fibres containing rare-earth ions , 1985 .

[38]  R L Cone,et al.  Ultraviolet-induced distributed-feedback gratings in Ce(3+) -doped silica optical fibers. , 1991, Optics letters.

[39]  Kai-Hsiu Liao,et al.  High Peak Power Pulse Amplification in Large-Core Yb-Doped Fiber Amplifiers , 2007, IEEE Journal of Selected Topics in Quantum Electronics.

[40]  Simo Tammela,et al.  Photodarkening in ytterbium-doped silica fibers , 2005, SPIE Security + Defence.

[41]  E. Desurvire,et al.  High-gain erbium-doped traveling-wave fiber amplifier. , 1997, Optics letters.

[42]  C. Burrus,et al.  Neodymium‐doped silica lasers in end‐pumped fiber geometry , 1973 .

[43]  S. Unger,et al.  Photodarkening in Yb doped fibers: experimental evidence of equilibrium states depending on the pump power. , 2007, Optics express.

[44]  B. Ainslie.  A review of the fabrication and properties of erbium-doped fibers for optical amplifiers , 1991 .

[45]  E. Vanin,et al.  Atomic Layer Deposition as a New Method for Rare-Earth Doping of Optical Fibers , 2007, 2007 Conference on Lasers and Electro-Optics (CLEO).

[46]  E. Snitzer,et al.  Yb3+–Er3+ GLASS LASER , 1965 .

[47]  David N. Payne,et al.  Role of Aluminum in Ytterbium–Erbium Codoped Phosphoaluminosilicate Optical Fibers , 1996 .

[48]  Seppo Honkanen,et al.  Mode-induced transverse photodarkening loss variations in large-mode-area ytterbium doped silica fibers. , 2008, Optics express.

[49]  D. Hanna,et al.  Yb-Doped Silica Cladding-Pumped Fiber Laser Pumped at 974 nm , 2004 .

[50]  J. Rothhardt,et al.  Extended single-mode photonic crystal fiber lasers. , 2006, Optics express.

[51]  Jeffrey P. Koplow,et al.  Efficient second, third, fourth, and fifth harmonic generation of a Yb-doped fiber amplifIer. , 2002 .

[52]  Ewan M Wright,et al.  Efficiency of pump absorption in double-clad fiber amplifiers. II. Broken circular symmetry , 2001 .

[53]  M. Hotoleanu,et al.  Inversion behavior in core- and cladding-pumped Yb-doped fiber photodarkening measurements. , 2008, Applied optics.

[54]  M. Söderlund,et al.  Measuring photodarkening from single-mode ytterbium doped silica fibers. , 2006, Optics express.

[55]  Farhad Hakimi,et al.  DOUBLE CLAD HIGH BRIGHTNESS Nd FIBER LASER PUMPED BY GaAlAs PHASED ARRAY , 1989 .

[56]  Jeff Hecht,et al.  City of Light: The Story of Fiber Optics , 1999 .

[57]  David N. Payne,et al.  Solution-doping technique for fabrication of rare-earth-doped optical fibres , 1987 .

[58]  A. V. Shubin,et al.  Photodarkening of alumosilicate and phosphosilicate Yb-doped fibers , 2007, 2007 European Conference on Lasers and Electro-Optics and the International Quantum Electronics Conference.

[59]  Mikko Söderlund,et al.  Photodarkening measurements in large mode area fibers , 2007, SPIE LASE.

[60]  Joona Koponen,et al.  Spatial Distribution of Photodarkening in Large Mode Area Ytterbium Doped Fibers , 2008 .

[61]  S. Maryashin,et al.  10-mJ pulse energy and 200 W average power Yb-doped fiber laser , 2006, SPIE LASE.

[62]  A. Méndez,et al.  Specialty optical fibers handbook , 2007 .

[63]  Nicolas Landru,et al.  Fiber-based laser with tunable repetition rate, fixed pulse duration, and multiple wavelength output , 2007, SPIE LASE.

[64]  Richard C. Powell,et al.  Characteristics of laser-induced gratings in Pr 3+ - and Eu 3+ -doped silicate glasses , 1990 .

[65]  David C. Brown,et al.  Thermal, stress, and thermo-optic effects in high average power double-clad silica fiber lasers , 2001 .

[66]  D. Åberg,et al.  Strong UV absorption and visible luminescence in ytterbium-doped aluminosilicate glass under UV excitation. , 2007, Optics letters.

[67]  Benoit Cadier,et al.  Photo darkening in ytterbium co-doped silica material , 2008, SPIE LASE.

[68]  Wolfgang Gries,et al.  High power UV q-switched and mode-locked laser comparisons for industrial processing applications , 2008, SPIE LASE.

[69]  Stephen Norman,et al.  Power scaling of high-power fiber lasers for micromachining and materials processing applications , 2006, SPIE LASE.