Application of a non-thermal surface plasma discharge in wet condition for gas exhaust treatment: NOx removal

Abstract This paper deals with the NOx removal with the help of a non-thermal surface plasma discharge in wet conditions. The gas treatment device consisting of a surface discharge and a wet-type reactor, was characterized through FTIR and electrical measurements. The ability of the proposed system for the cleaning of gas exhaust was studied. NOx as gaseous pollutant was decomposed effectively. To improve the chemical conversion, a coil was inserted in the electric circuit then a catalyst was placed in the plasma area. Results showed an improvement of NOx removal by an increase in radical species produced and synergistic effect, respectively.

[1]  Decomposition of gaseous organic contaminants by surface discharge induced plasma chemical processing-SPCP , 1992 .

[2]  E. Moreau,et al.  Enhancement of the Electromechanical Performances of a Single Dielectric Barrier Discharge Actuator , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.

[3]  Akira Mizuno,et al.  Industrial applications of atmospheric non-thermal plasma in environmental remediation , 2007 .

[4]  T. Yamamoto,et al.  VOC decomposition by nonthermal plasma processing — a new approach☆ , 1997 .

[5]  Zhang Yanbin,et al.  SO2 removal from industrial flue gases using pulsed corona discharge , 1998 .

[6]  Eric Moreau,et al.  Asymmetric surface dielectric barrier discharge in air at atmospheric pressure: electrical properties and induced airflow characteristics , 2005 .

[7]  Chen-Lu Yang,et al.  Plasma-assisted chemical process for NO/sub x/ control , 2000 .

[8]  T. Takarada,et al.  Improvement of NOx removal efficiency using atomization of fine droplets into corona discharge , 2002 .

[9]  T. Corke,et al.  SDBD plasma enhanced aerodynamics: concepts, optimization and applications , 2007 .

[10]  A. Mizuno,et al.  $\hbox{NO}_{3}^{-}$ Reduction for $\hbox{NO}_{\rm x}$ Removal Using Wet-Type Plasma Reactor , 2010, IEEE Transactions on Industry Applications.

[11]  Masaaki Okubo,et al.  Towards ideal NO/sub x/ control technology using a plasma-chemical hybrid process , 2001 .

[12]  E. Moreau,et al.  Optimization of a dielectric barrier discharge actuator by stationary and non-stationary measurements of the induced flow velocity: application to airflow control , 2007 .

[13]  Stephane Pasquiers,et al.  Oxidation of 2-heptanone in air by a DBD-type plasma generated within a honeycomb monolith supported Pt-based catalyst , 2004 .

[14]  Gerhard J. Pietsch,et al.  Dielectric barrier discharges and ozone synthesis , 1998 .

[15]  Guillermo Artana,et al.  Electric wind produced by surface plasma actuators: a new dielectric barrier discharge based on a three-electrode geometry , 2008 .

[16]  Shinji Katsura,et al.  Performance evaluation of discharge plasma process for gaseous pollutant removal , 2002 .

[17]  Zhen Huang,et al.  Removal of NOx from wet flue gas by corona discharge , 2004 .

[18]  A. Rousseau,et al.  C2H2 oxidation by plasma/TiO2 combination: Influence of the porosity, and photocatalytic mechanisms under plasma exposure , 2008 .

[19]  Frank Holzer,et al.  Combination of non-thermal plasma and heterogeneous catalysis for oxidation of volatile organic compounds: Part 2. Ozone decomposition and deactivation of γ-Al2O3 , 2005 .

[20]  R. Hackam,et al.  Air pollution control by electrical discharges , 2000 .

[21]  Eric Moreau,et al.  Airflow control by non-thermal plasma actuators , 2007 .

[22]  Yukio Aoki,et al.  Removal of NOx by DC corona reactor with water , 2001 .

[23]  A. Mizuno,et al.  Reactive absorption of NOx using wet discharge plasma reactor , 1995 .

[24]  Towards ideal NO/sub x/ control technology using plasma-chemical hybrid process , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[25]  V. Mathur,et al.  Nitrogen Oxide Decomposition by Barrier Discharge , 2000 .

[26]  Binjie Dong,et al.  Experimental study of a DBD surface discharge for the active control of subsonic airflow , 2008 .

[27]  Hideo Yamamoto,et al.  A novel design of electrodes system for gas treatment integrating ceramic filter and SPCP (surface corona discharge induced plasma chemical process) method , 2007 .

[28]  Akira Mizuno,et al.  Generation of extended surface barrier discharge on dielectric surface - electrical properties , 2007 .

[29]  S. Masuda,et al.  Novel plasma chemical technologies — PPCP and SPCP for control of gaseous pollutants and air toxics , 1995 .