A smart approach for design of digitally controlled multiple-output dc-dc converter

This paper presents a smart approach for digital control forward type multiple-output dc-dc converter. In this case, the central problem of design is how to decide the integral coefficient. Since the decision of integral coefficient depends on the static characteristics, the selected integral coefficient is not suitable to perform the superior dynamic characteristics. Then, it is important to set the suitable the integral coefficient for not only static characteristics but also dynamic characteristics. As a result, in the proposed design approach, the convergence time of the output voltage and the overshoot of reactor current are improved 20% and 11%.

[1]  O. Ichinokura,et al.  Digital PI controller for high frequency switching DC/DC converters based on FPGA , 2003, The 25th International Telecommunications Energy Conference, 2003. INTELEC '03..

[2]  Miro Milanovic,et al.  FPGA implementation of digital controller for DC-DC buck converter , 2005, Fifth International Workshop on System-on-Chip for Real-Time Applications (IWSOC'05).

[3]  Wei-Lun Chen,et al.  A novel two-switch forward configuration for wide input-voltage range applications: RCD-clamped forward converter with ripple reduction (RCDFRR) , 2008, 2008 IEEE Power Electronics Specialists Conference.

[4]  Gun-Woo Moon,et al.  Multi-level active clamp forward converter with reduced voltage stress , 2008, 2008 IEEE Power Electronics Specialists Conference.

[5]  D. Maksimovic,et al.  Impact of digital control in power electronics , 2004, 2004 Proceedings of the 16th International Symposium on Power Semiconductor Devices and ICs.

[6]  Hayashi Masanori,et al.  Analysis of Cross-Regulation in Multiple-Output DC/DC Converters , 2004 .

[7]  Hirofumi Matsuo,et al.  A comparison of steady‐state characteristics of buck‐type DC‐DC converter using DSP , 2007 .