Procedure to assess the role of railway pantograph components in generating the aerodynamic uplift

Abstract Aerodynamic forces play a big role in determining the value of the mean force acting between the collectors of a railway pantograph and the contact wire, especially for speed higher than 200 km/h. The contact force has to be properly calibrated in order to have a good quality collection of power and low wear of contact strips and contact wire. This paper analyses the pantograph features that mainly affect its aerodynamic behaviour, and their influence on the mean value of the contact force. Wind tunnel experimental tests on a full-scale pantograph and Computational Fluid Dynamic (CFD) simulations in a wind tunnel scenario are carried out for different pantograph configurations, and the contribution of each different part of the pantograph to the mean contact force is investigated. To this end, the feasibility of using the RANS model and steady state simulations is evaluated.

[1]  Alan Facchinetti,et al.  Computational fluid dynamics as a means of assessing the influence of aerodynamic forces on the mean contact force acting on a pantograph , 2016 .

[2]  S. Malavasi,et al.  Pressure field and wake modes analysis of an oscillating cylinder , 2016 .

[3]  Jorge Ambrósio,et al.  Influence of the aerodynamic forces on the pantograph–catenary system for high-speed trains , 2009 .

[4]  Jongsoo Lee,et al.  Prediction of low-speed aerodynamic load and aeroacoustic noise around simplified panhead section model , 2008 .

[5]  Mitsuru Ikeda,et al.  Evaluation Method of Low-Frequency Aeroacoustic Noise Source Structure Generated by Shinkansen Pantograph , 2008 .

[6]  Alan Facchinetti,et al.  Assessing Aerodynamic Effects on a Railway Pantograph by means of Computational Fluid Dynamics , 2016 .

[7]  Ferruccio Resta,et al.  Pantograph aerodynamic effects on the pantograph–catenary interaction , 2006 .

[8]  Ferruccio Resta,et al.  On the use of a hardware in the loop set-up for pantograph dynamics evaluation , 2008 .

[9]  A. Collina,et al.  Effect of collector deformable modes in pantograph—catenary dynamic interaction , 2009 .

[10]  P. Moin,et al.  NUMERICAL SIMULATION OF THE FLOW AROUND A CIRCULAR CYLINDER AT HIGH REYNOLDS NUMBER , 2003 .

[11]  Guowei Yang,et al.  The influence of pantograph aerodynamic characteristics caused by its shroud , 2012 .

[12]  F. Menter.  ZONAL TWO EQUATION k-w TURBULENCE MODELS FOR AERODYNAMIC FLOWS , 1993 .

[13]  Mitsuru Ikeda,et al.  The results of the pantograph–catenary interaction benchmark , 2015 .

[14]  Hyeok Bin Kwon,et al.  Experimental studies on the aerodynamic characteristics of a pantograph suitable for a high-speed train , 2015 .

[15]  Mitsuru Ikeda,et al.  Flow Control on Pantograph with Air Intake and Outlet , 2007 .

[16]  Mitsuru Ikeda,et al.  Experimental method for wind tunnel tests to simulate turbulent flow on the roof of high-speed trains , 2012 .

[17]  Mitsuru Ikeda,et al.  Numerical Estimation of Aerodynamic Interference between Panhead and Articulated Frame , 2009 .

[18]  Yu Chen,et al.  Numerical research on aerodynamic characteristic optimization of pantograph fixing place on high speed train , 2009, 2009 2nd International Conference on Power Electronics and Intelligent Transportation System (PEITS).

[19]  Christopher Baker,et al.  The simulation of unsteady aerodynamic cross wind forces on trains , 2010 .

[20]  Ning Zhou,et al.  Investigation on dynamic performance and parameter optimization design of pantograph and catenary system , 2011 .

[21]  Daniele Rocchi,et al.  Aerodynamic behaviour investigation of the new EMUV250 train to cross wind , 2010 .

[22]  Giuseppe Bucca,et al.  Adoption of different pantographs’ preloads to improve multiple collection and speed up existing lines , 2012 .