Annular multiphase flow behavior during deep water drilling and the effect of hydrate phase transition

It is very important to understand the annular multiphase flow behavior and the effect of hydrate phase transition during deep water drilling. The basic hydrodynamic models, including mass, momentum, and energy conservation equations, were established for annular flow with gas hydrate phase transition during gas kick. The behavior of annular multiphase flow with hydrate phase transition was investigated by analyzing the hydrate-forming region, the gas fraction in the fluid flowing in the annulus, pit gain, bottom hole pressure, and shut-in casing pressure. The simulation shows that it is possible to move the hydrate-forming region away from sea floor by increasing the circulation rate. The decrease in gas volume fraction in the annulus due to hydrate formation reduces pit gain, which can delay the detection of well kick and increase the risk of hydrate plugging in lines. Caution is needed when a well is monitored for gas kick at a relatively low gas production rate, because the possibility of hydrate presence is much greater than that at a relatively high production rate. The shut-in casing pressure cannot reflect the gas kick due to hydrate formation, which increases with time.

[1]  E. Dendy Sloan,et al.  Heat capacity and heat of dissociation of methane hydrates , 1988 .

[2]  M. Yousif,et al.  Hydrate control during deep water drilling : Overview and new drilling fluids formulations , 1997 .

[3]  R. J. Martin,et al.  Development of an automated, high pressure heat flux calorimeter and its application to measure the heat of dissociation and hydrate numbers of methane hydrate , 1990 .

[4]  Yash Paul Handa,et al.  Compositions, enthalpies of dissociation, and heat capacities in the range 85 to 270 K for clathrate hydrates of methane, ethane, and propane, and enthalpy of dissociation of isobutane hydrate, as determined by a heat-flow calorimeter , 1986 .

[5]  Nicolas Kalogerakis,et al.  Kinetics of methane hydrate formation in aqueous electrolyte solutions , 1993 .

[6]  Sigbjørn Sangesland,et al.  Managed Pressure Drilling for Subsea Applications; Well Control Challenges in Deep Waters , 2004 .

[7]  Syed S. H. Rizvi,et al.  Kinetics of methane hydrate decomposition , 1987 .

[8]  H. V. Nickens,et al.  A Dynamic Computer Model of a Kicking Well , 1987 .

[9]  J. L. Leblanc,et al.  A Mathematical Model of a Gas Kick , 1968 .

[10]  Paulo Roberto Ribeiro,et al.  Mathematical Modeling of Gas Kicks in Deep Water Scenario , 2002 .

[11]  Nicolas Kalogerakis,et al.  Modelling of decomposition of a synthetic core of methane gas hydrate by coupling intrinsic kinetics with heat transfer rates , 1989 .

[12]  C. S. Kabir,et al.  Aspects of Wellbore Heat Transfer During Two-Phase Flow (includes associated papers 30226 and 30970 ) , 1994 .

[13]  P. Bishnoi,et al.  A kinetic study of methane hydrate formation , 1983 .

[14]  J. W. Barker,et al.  Formation of hydrates during deepwater drilling operations , 1989 .