Nanocrystalline SnO2 film prepared by the aqueous sol–gel method and its application as sensing films of the resistance and SAW H2S sensor

Abstract Tin oxide (SnO 2 ) has been employed as the sensitive film of surface acoustic wave (SAW) gas sensor, which enhanced the sensor performance toward H 2 S gas. However, the conventional sol–gel method is unfit for depositing SnO 2 films on SAW devices as the sol can corrode the electrodes made of conventional metals due to its strong acidity. In this paper, a new aqueous and non-corrosive sol–gel method was adopted to deposit SnO 2 films on SAW device substrate with little corrosion of electrodes. The prepared sol is weak alkaline and noncorrosive, which prevent the contact between the electrodes and the air during the sintering process. The surface morphology and microstructure of the prepared films were investigated and the H 2 S sensing properties of the films were studied. The gas sensing results showed that the prepared SnO 2 films have the highest resistance response (the ratio of film resistance in air versus in H 2 S) 58,057 toward 13.7 ppm H 2 S at 60 °C and good selectivity for H 2 S detection. The SAW gas sensors had a good performance for detecting H 2 S at room temperature and at low relative humidity. This method can also be applied to prepare the sensing membrane of the other acoustic wave sensors.

[1]  Tsung-Tsong Wu,et al.  A room temperature surface acoustic wave hydrogen sensor with Pt coated ZnO nanorods , 2009, Nanotechnology.

[2]  Wojtek Wlodarski,et al.  Layered WO3/ZnO/36° LiTaO3 SAW gas sensor sensitive towards ethanol vapour and humidity , 2006 .

[3]  Dongxiang Zhou,et al.  Preparation of Tin Oxide Thin Films on Silicon Substrates via Sol–Gel Routes and the Prospects for the H 2 S Gas Sensor , 2011 .

[4]  Optimization of a SAW metal oxide semiconductor gas sensor , 1989, Proceedings., IEEE Ultrasonics Symposium,.

[5]  Koji Ito,et al.  H2S sensing property of porous SnO2 sputtered films coated with various doping films , 2006 .

[6]  Nicolae Barsan,et al.  Sensing of CH4, CO and ethanol with in situ nanoparticle aerosol-fabricated multilayer sensors , 2007 .

[7]  N. K. Gaur,et al.  Copper doped SnO2 nanowires as highly sensitive H2S gas sensor , 2009 .

[8]  Kengo Shimanoe,et al.  Hydrogen sulfide gas sensing properties of thin films derived from SnO2 sols different in grain size , 2005 .

[9]  T. Hong,et al.  High Performance Micro CO Sensors Based on ZnO-SnO2 Composite Nanofibers with Anti-Humidity Characteristics , 2012 .

[10]  Dongxiang Zhou,et al.  Nanocrystalline In2O3–SnO2 thick films for low-temperature hydrogen sulfide detection , 2011 .

[11]  V. V. Malyshev,et al.  Investigation of gas-sensitivity of sensor structures to carbon monoxide in a wide range of temperature, concentration and humidity of gas medium , 2007 .

[12]  Ghenadii Korotcenkov,et al.  Influence of surface Pd doping on gas sensing characteristics of SnO2 thin films deposited by spray pirolysis , 2003 .

[13]  Lauri Holappa,et al.  H2S-sensing properties of SnO2 produced by ball milling and different chemical reactions , 2006 .

[14]  D. MacDougall,et al.  Guidelines for data acquisition and data quality evaluation in environmental chemistry , 1980 .

[15]  Dongxiang Zhou,et al.  A surface acoustic wave H2S gas sensor employing nanocrystalline SnO2 thin film , 2013 .

[16]  Ikmo Park,et al.  A novel wireless, passive CO2 sensor incorporating a surface acoustic wave reflective delay line , 2007 .

[17]  Kengo Shimanoe,et al.  Theory of gas-diffusion controlled sensitivity for thin film semiconductor gas sensor , 2001 .

[18]  V. C. Sahni,et al.  Mechanism of drifts in H2S sensing properties of SnO2:CuO composite thin film sensors prepared by thermal evaporation , 2003 .

[19]  Yadong Li,et al.  High sensitivity of CuO modified SnO2 nanoribbons to H2S at room temperature , 2005 .

[20]  K. Sreenivas,et al.  Contribution of adsorbed oxygen and interfacial space charge for enhanced response of SnO2 sensors having CuO catalyst for H2S gas , 2010 .

[21]  G. Korotcenkov.  Metal oxides for solid-state gas sensors: What determines our choice? , 2007 .

[22]  G. Ozin,et al.  Making sense out of sulfated tin dioxide mesostructures , 2003 .

[23]  Zhou Dongxiang,et al.  Highly sensitive SnO2 thin film with low operating temperature prepared by sol–gel technique , 2008 .

[24]  Antonio J. Ricco,et al.  Surface acoustic wave gas sensor based on film conductivity changes , 1985 .

[25]  Shitang He,et al.  Development of a SnO2/CuO-coated surface acoustic wave-based H2S sensor with switch-like response and recovery , 2012 .

[26]  A. M. Glass,et al.  Principles and Applications of Ferroelectrics and Related Materials , 1977 .

[27]  R. S. Bauer,et al.  Oxidation of Aluminum Surfaces Studied by Synchrotron Radiation Photoelectron Spectroscopy , 1977 .

[28]  Giovanni Saggio,et al.  Advances in SAW-based gas sensors , 1997 .

[29]  Zhengguo Jin,et al.  Preparation and Process Chemistry of SnO2 Films Derived from SnC2O4 by the Aqueous Sol–Gel Method , 2008 .

[30]  W. Jakubik,et al.  Surface acoustic wave-based gas sensors , 2011 .

[31]  N. Yamazoe,et al.  Oxide Semiconductor Gas Sensors , 2003 .