Photopolymerization of cell-encapsulating hydrogels: crosslinking efficiency versus cytotoxicity.

Cell-encapsulating hydrogels used in regenerative medicine are designed to undergo a rapid liquid-to-solid phase transition in the presence of cells and tissues so as to maximize crosslinking and minimize cell toxicity. Light-activated free-radical crosslinking (photopolymerization) is of particular interest in this regard because it can provide rapid reaction rates that result in uniform hydrogel properties with excellent temporal and spatial control features. Among the many initiator systems available for photopolymerization, only a few have been identified as suitable for cell-based hydrogel formation owing to their water solubility, crosslinking properties and non-toxic reaction conditions. In this study, three long-wave ultraviolet (UV) light-activtied photoinitiators (PIs) were comparatively tested in terms of cytotoxicity, crosslinking efficiency and crosslinking kinetics of cell-encapsulating hydrogels. The hydrogels were photopolymerized from poly(ethylene glycol) (PEG) diacrylate or PEG-fibrinogen precursors using Irgacure® PIs I2959, I184 and I651, as well as with a chemical initiator/accelerator (APS/TEMED). The study specifically evaluated the PI type, PI concentration and UV light intensity, and how these affected the mechanical properties of the hydrogel (i.e. maximum storage modulus), the crosslinking reaction times and the reaction's cytotoxicity to encapsulated cells. Only two initiators (I2959 and I184) were identified as being suitable for achieving both high cell viability and efficient crosslinking of the cell-encapsulating hydrogels during the photopolymerization reaction. Optimization of PI concentration or irradiation intensity was particularly important for achieving maximum mechanical properties; a sub-optimal choice of PI concentration or irradiation intensity resulted in a substantial reduction in hydrogel modulus. Cytocompatibility may be compromised by unnecessarily prolonging exposure to cytotoxic free radicals or inadvertently enhancing the instantaneous dose of radicals in solution, both of which are dependent on the PI type/concentration and irradiation intensity. In the absence of a radical initiator, the short exposures to long-wave UV light irradiation (up to 5 min, 20 mW cm(-2), 365 nm) did not prove to be cytotoxic to cells. Therefore, it is important to understand the relationship between PIs, light irradiation conditions and crosslinking when attempting to identify a suitable hydrogel formation process for cell encapsulating hydrogels.

[1]  M Cornelissen,et al.  Structural and rheological properties of methacrylamide modified gelatin hydrogels. , 2000, Biomacromolecules.

[2]  S. Bryant,et al.  Cell encapsulation in biodegradable hydrogels for tissue engineering applications. , 2008, Tissue engineering. Part B, Reviews.

[3]  Y. K. Cheung,et al.  Microscale control of stiffness in a cell-adhesive substrate using microfluidics-based lithography. , 2009, Angewandte Chemie.

[4]  C. Bowman,et al.  Toward an enhanced understanding and implementation of photopolymerization reactions , 2008 .

[5]  D. Kohane,et al.  HYDROGELS IN DRUG DELIVERY: PROGRESS AND CHALLENGES , 2008 .

[6]  Bianca Maria Baroli,et al.  Photopolymerization of biomaterials: issues and potentialities in drug delivery, tissue engineering, and cell encapsulation applications , 2006 .

[7]  H. Bianco-Peled,et al.  Structural investigation of PEG-fibrinogen conjugates , 2010, Journal of materials science. Materials in medicine.

[8]  Kristi S. Anseth,et al.  Photodegradable Hydrogels for Dynamic Tuning of Physical and Chemical Properties , 2009, Science.

[9]  P. Messersmith,et al.  Rational design of transglutaminase substrate peptides for rapid enzymatic formation of hydrogels. , 2003, Journal of the American Chemical Society.

[10]  A. Hoffman,et al.  Graft copolymers that exhibit temperature-induced phase transitions over a wide range of pH , 1995, Nature.

[11]  H. Iwata,et al.  Hyaluronic acid hydrogel loaded with genetically-engineered brain-derived neurotrophic factor as a neural cell carrier. , 2009, Biomaterials.

[12]  Wim E Hennink,et al.  The effect of photopolymerization on stem cells embedded in hydrogels. , 2009, Biomaterials.

[13]  Y. Yagcı,et al.  Gel formation by chain-crosslinking photopolymerization of methyl methacrylate and ethylene glycol dimethacrylate , 1997 .

[14]  Jason B Shear,et al.  Multiphoton fabrication of chemically responsive protein hydrogels for microactuation , 2008, Proceedings of the National Academy of Sciences.

[15]  Jason A Burdick,et al.  Patterning network structure to spatially control cellular remodeling and stem cell fate within 3-dimensional hydrogels. , 2010, Biomaterials.

[16]  Stephanie J Bryant,et al.  In situ forming degradable networks and their application in tissue engineering and drug delivery. , 2002, Journal of controlled release : official journal of the Controlled Release Society.

[17]  Jason A Burdick,et al.  Review: photopolymerizable and degradable biomaterials for tissue engineering applications. , 2007, Tissue engineering.

[18]  J. A. Hubbell,et al.  Interfacial photopolymerization of poly(ethylene glycol)-based hydrogels upon alginate-poly(l-lysine) microcapsules for enhanced biocompatibility. , 1993, Biomaterials.

[19]  H. Bianco-Peled,et al.  Defining the role of matrix compliance and proteolysis in three-dimensional cell spreading and remodeling. , 2008, Biophysical journal.

[20]  D. Seliktar,et al.  Compositional alterations of fibrin-based materials for regulating in vitro neural outgrowth. , 2008, Tissue engineering. Part A.

[21]  M. Peuster,et al.  Degradation of tungsten coils implanted into the subclavian artery of New Zealand white rabbits is not associated with local or systemic toxicity. , 2003, Biomaterials.

[22]  Allan S Hoffman,et al.  Hydrogels for biomedical applications. , 2002, Advanced drug delivery reviews.

[23]  Jennifer L West,et al.  Poly(ethylene glycol) hydrogel system supports preadipocyte viability, adhesion, and proliferation. , 2005, Tissue engineering.

[24]  S J Bryant,et al.  Cytocompatibility of UV and visible light photoinitiating systems on cultured NIH/3T3 fibroblasts in vitro , 2000, Journal of biomaterials science. Polymer edition.

[25]  Kristi S Anseth,et al.  Photoinitiated polymerization of PEG-diacrylate with lithium phenyl-2,4,6-trimethylbenzoylphosphinate: polymerization rate and cytocompatibility. , 2009, Biomaterials.

[26]  Kytai Truong Nguyen,et al.  Photopolymerizable hydrogels for tissue engineering applications. , 2002, Biomaterials.

[27]  D. Seliktar,et al.  Biosynthetic hydrogel scaffolds made from fibrinogen and polyethylene glycol for 3D cell cultures. , 2005, Biomaterials.

[28]  Wim E. Hennink,et al.  Novel crosslinking methods to design hydrogels , 2002 .

[29]  D. Mooney,et al.  Hydrogels for tissue engineering. , 2001, Chemical Reviews.

[30]  Alyssa Panitch,et al.  Biologically engineered protein-graft-poly(ethylene glycol) hydrogels: a cell adhesive and plasmin-degradable biosynthetic material for tissue repair. , 2002, Biomacromolecules.

[31]  Paul N Manson,et al.  Variable cytocompatibility of six cell lines with photoinitiators used for polymerizing hydrogels and cell encapsulation. , 2005, Biomaterials.

[32]  P. Ma,et al.  Ionically crosslinked alginate hydrogels as scaffolds for tissue engineering: part 1. Structure, gelation rate and mechanical properties. , 2001, Biomaterials.

[33]  S. Bryant,et al.  Photopolymerization of Hydrogel Scaffolds , 2005 .

[34]  Kristi L Kiick,et al.  Protein‐ and peptide‐modified synthetic polymeric biomaterials , 2010, Biopolymers.

[35]  Takehiko Gotoh,et al.  Novel synthesis of thermosensitive porous hydrogels , 1998 .