Preparation and characterization of PVDF flat-sheet membranes for direct contact membrane distillation

The polyvinylidene fluoride (PVDF) flat-sheet membranes for direct contact membrane distillation (DCMD) were prepared through coating and wet phase inversion process. The effects of solvent, polymer concentration, non-solvent additive and nonwoven fabric on membrane morphology, porosity, pore size, pore size distribution, hydrophobicity and permeability were investigated. It was found that the membrane using N,N-dimethylacetamide as solvent obtained good permeability, and the polymer dope containing 20 wt.% PVDF was the most suitable for hydrophobic flat-sheet membrane preparation. The PVDF flat-sheet membranes with different non-solvent additive such as acetone, phosphoric acid, glycerine, LiCl and PEG 400 were prepared and the membrane using 5 wt.% acetone and 3 wt.% H3PO4 as mixed additive had the highest permeate flux. The nonwoven fabric could prevent membrane shrinkage, while both pore size and permeate flux of the PVDF/nonwoven fabric composite membrane were enhanced. Although the nonwoven fabric caused the membrane surface roughness decline, the contact angle only decreased slightly. The PVDF/nonwoven fabric composite membrane exhibited satisfying performance stability during the 240 h continuous desalination experiments, indicating that the resultant flat-sheet membrane may be of great potential to be utilized in DCMD process for desalination. (C) 2014 Elsevier B.V. All rights reserved.

[1]  M. Khayet.  Membranes and theoretical modeling of membrane distillation: a review. , 2011, Advances in colloid and interface science.

[2]  Baoli Shi,et al.  Preparation and properties of microporous membrane from poly(vinylidene fluoride-co-tetrafluoroethylene) (F2.4) for membrane distillation , 2004 .

[3]  Dongliang Wang,et al.  Porous PVDF asymmetric hollow fiber membranes prepared with the use of small molecular additives , 2000 .

[4]  Kai Yu Wang,et al.  Hydrophobic PVDF hollow fiber membranes with narrow pore size distribution and ultra-thin skin for the fresh water production through membrane distillation , 2008 .

[5]  Marek Gryta,et al.  Influence of morphology of PVDF capillary membranes on the performance of direct contact membrane distillation , 2010 .

[6]  M.H.V. Mulder,et al.  Wetting criteria for the applicability of membrane distillation , 1987 .

[7]  Peng Wang,et al.  Design and fabrication of lotus-root-like multi-bore hollow fiber membrane for direct contact membrane distillation , 2012 .

[8]  Mohamed Khayet,et al.  A framework for better understanding membrane distillation separation process , 2006 .

[9]  Anthony G. Fane,et al.  Effect of pore size distribution and air flux on mass transport in direct contact membrane distillation , 2003 .

[10]  M. Khayet,et al.  Self-sustained webs of polyvinylidene fluoride electrospun nanofibers at different electrospinning times: 1. Desalination by direct contact membrane distillation , 2013 .

[11]  Mohamed Khayet,et al.  Surface segregation of fluorinated modifying macromolecule for hydrophobic/hydrophilic membrane preparation and application in air gap and direct contact membrane distillation , 2012 .

[12]  Rong Wang,et al.  Factors affecting pore structure and performance of poly(vinylidene fluoride-co-hexafluoro propylene) asymmetric porous membrane , 2006 .

[13]  Jun-de Li,et al.  Identification of material and physical features of membrane distillation membranes for high performance desalination , 2010 .

[14]  Chunsheng Feng,et al.  Preliminary research on microporous membrane from F2.4 for membrane distillation , 2004 .

[15]  M. Tomaszewska,et al.  Preparation and properties of flat-sheet membranes from poly(vinylidene fluoride) for membrane distillation , 1996 .

[16]  Mohamed Khayet,et al.  A Monte Carlo simulation model for vacuum membrane distillation process , 2007 .

[17]  T. Matsuura,et al.  Surface characterization of hollow fiber membranes used in artificial kidney , 2006 .

[18]  Tai-Shung Chung,et al.  Development of hollow fiber membranes for water and salt recovery from highly concentrated brine via direct contact membrane distillation and crystallization , 2012 .

[19]  May May Teoh,et al.  Development of Novel Multichannel Rectangular Membranes with Grooved Outer Selective Surface for Membrane Distillation , 2011 .

[20]  S. Rajesh,et al.  Preparation, Morphology, Performance, and Hydrophilicity Studies of Poly(amide-imide) Incorporated Cellulose Acetate Ultrafiltration Membranes , 2011 .

[21]  Hongwei Fan,et al.  Preparation and characterization of hydrophobic PVDF membranes by vapor-induced phase separation and application in vacuum membrane distillation , 2013, Journal of Polymer Research.

[22]  Jun Wang,et al.  Preparation and properties of PVDF composite hollow fiber membranes for desalination through direct contact membrane distillation , 2012 .

[23]  Mark Voorneveld,et al.  Preparation , 2018, Games Econ. Behav..

[24]  M. Qtaishat,et al.  Preparation and characterization of novel hydrophobic/hydrophilic polyetherimide composite membranes for desalination by direct contact membrane distillation , 2009 .

[25]  Kai Yu Wang,et al.  Mixed Matrix PVDF Hollow Fiber Membranes with Nanoscale Pores for Desalination through Direct Contact Membrane Distillation , 2009 .

[26]  Mohamed Khayet,et al.  Experimental design and optimization of asymmetric flat-sheet membranes prepared for direct contact membrane distillation , 2010 .

[27]  M. Qtaishat,et al.  Novel porous composite hydrophobic/hydrophilic polysulfone membranes for desalination by direct contact membrane distillation , 2009 .

[28]  Tai‐Shung Chung,et al.  Membrane distillation with hydrophobic macrovoid-free PVDF–PTFE hollow fiber membranes , 2009 .

[29]  Hongjie Wang,et al.  Preparation and properties of PTFE hollow fiber membranes for desalination through vacuum membrane distillation , 2013 .

[30]  U. Kim,et al.  Structural study of microporous polypropylene hollow fiber membranes made by the melt-spinning and cold-stretching method , 1994 .

[31]  Rong Wang,et al.  Fabrication of lab-scale hollow fiber membrane modules with high packing density , 2004 .

[32]  Mohamed Khayet,et al.  Porous hydrophobic/hydrophilic composite membranes: Application in desalination using direct contact membrane distillation , 2005 .

[33]  Zhenya Gu,et al.  Preparation and properties of PVDF-fabric composite membrane for membrane distillation , 2009 .

[34]  T. Matsuura,et al.  Porous hydrophobic/hydrophilic composite membranes preparation and application in DCMD desalination at higher temperatures , 2006 .

[35]  Jun-de Li,et al.  Effect of applied pressure on performance of PTFE membrane in DCMD , 2011 .

[36]  Enrico Drioli,et al.  Preparation of hollow fibre membranes from PVDF/PVP blends and their application in VMD , 2010 .

[37]  Kang Li,et al.  Preparation of porous PVDF hollow fibre membrane via a phase inversion method using lithium perchlorate (LiClO4) as an additive , 2005 .

[38]  Marek Gryta,et al.  Influence of polypropylene membrane surface porosity on the performance of membrane distillation process , 2007 .