Analysis of multi-crystalline silicon solar cells at low illumination levels using a modified two-diode model

Abstract Current–voltage characteristics of multi-crystalline silicon solar cells measured under several low illumination levels are analyzed. The fitting analysis is conducted using a modified two-diode equivalent circuit accounting for an additional ohmic series resistance in the vicinity of grain boundaries and allowing for variable diode ideality factors. Apart from the shunt resistance—a key factor at very low illumination levels—the model indicates two other current transport mechanisms at low illumination levels, both related to recombination, but each of them can be allocated to a different region in the cell: (1) recombination in the crystalline region and (2) recombination at grain boundaries. The role played by each mechanism is studied depending on illumination level.

[1]  Uwe Rau,et al.  Electronic properties of CuGaSe2-based heterojunction solar cells. Part I. Transport analysis , 2000 .

[2]  J. Werner,et al.  Method to extract diffusion length from solar cell parameters—Application to polycrystalline silicon , 2003 .

[3]  F. Pelanchon,et al.  Degradation of the diode ideality factor of silicon n–p junctions , 2000 .

[4]  O. Breitenstein,et al.  Defect induced non-ideal dark I–V characteristics of solar cells , 2009 .

[6]  Richard H. Bube,et al.  Fundamentals of solar cells , 1983 .

[7]  A. Kassis,et al.  Separation of solar cell current into its constituent parallel currents under illumination , 2009 .

[8]  Ralf B. Bergmann,et al.  The future of crystalline silicon films on foreign substrates , 2002 .

[9]  K. Taretto.  Modeling and characterization of polycrystalline silicon for solar cells and microelectronics , 2003 .

[10]  Alessandro Virtuani,et al.  Performance of Cu(In,Ga)Se2 solar cells under low irradiance , 2003 .

[11]  H. Bayhan,et al.  Study of CdS/Cu(In,Ga)Se2 interface by using n values extracted analytically from experimental data , 2009 .

[12]  R. Hall.  Electron-Hole Recombination in Germanium , 1952 .

[13]  M. Saad,et al.  Effect of interface recombination on solar cell parameters , 2003 .

[14]  A. S. Kavasoglu,et al.  Tunnelling enhanced recombination in polycrystalline CdS/CdTe and CdS/Cu(In,Ga)Se2 heterojunction solar cells , 2005 .

[15]  K. Akimoto,et al.  Semiconductor surface and interface passivation by cyanide treatment , 2004 .

[16]  Bernold Richerzhagen,et al.  Study on the edge isolation of industrial silicon solar cells with waterjet-guided laser , 2007 .

[17]  M. Wolf,et al.  Investigation of the double exponential in the current—Voltage characteristics of silicon solar cells , 1977, IEEE Transactions on Electron Devices.

[18]  A. Kassis,et al.  Thermally and light-activated current in ZnO/CdS/CuGaSe2 single crystal solar cells , 2008 .

[19]  T. Fuyuki,et al.  Analysis of multicrystalline silicon solar cells by modified 3-diode equivalent circuit model taking leakage current through periphery into consideration , 2007 .

[20]  W. Read,et al.  Statistics of the Recombinations of Holes and Electrons , 1952 .

[21]  H. Matsunami,et al.  New Two-Diode Model for Detailed Analysis of Multicrystalline Silicon Solar Cells , 2005 .

[22]  Ulrich Stutenbaeumer,et al.  Equivalent model of monocrystalline, polycrystalline and amorphous silicon solar cells , 1999 .

[23]  H. Dekkers,et al.  Determination of effective diffusion length and saturation current density in silicon solar cells , 2005 .

[24]  D. Chan,et al.  Analytical methods for the extraction of solar-cell single- and double-diode model parameters from I-V characteristics , 1987, IEEE Transactions on Electron Devices.