Product characterization of waste printed circuit board by pyrolysis

Abstract This paper is part of a project which studies pyrolysis as an alternative for recycling printed circuit board (PCB); the sample (2.0 cm × 2.0 cm) was pyrolyzed under nitrogen atmosphere, at 300, 400, 500, 600 and 700 °C in a tubular type oven, maintaining 30 min, and during the pyrolysis process the organic part is decomposed to pyro-oils and pyro-gases, which can be used as fuels or chemical material resources: the solid residues of about 75–80 wt.%, liquid yields of ∼9.0 wt.% and gas yields of 12–14 wt.%. No significant influence of temperature was observed over 500 °C, however, there was certainly influence under 500 °C in both volatile substance. The pyro-oils have fairly high gross calorific values (∼30 kJ/kg), mainly with aromatic and with oxygenated compounds. The pyro-gas is very rich in CO, CO2, H2, CH4 and in small part of O2; after being purged it can be combusted for the pyrolysis self-sustain. The tensile strength decreases about 35% at 773 K, while the impact and tear strength increases above 773 K, and then decreases along with the temperature increase. The strength changes can offer guidance for used as a replacement for virgin fibres in SMC manufacture. The residues are better laminated can be easily liberated for metals recovery.