Studies of the vapor-induced sensitivity of hybrid composites fabricated by filling polystyrene with carbon black and carbon nanofibers

Abstract A conductive composite with good gas sensitivity was fabricated by filling polystyrene (PS) with hybrid fillers composed of vapor grown carbon nanofiber (VGCNF) and carbon black (CB) introduced by solution mixing. The composite’s electrical and gas sensitive properties were tested. The combined effect of the VGCNF and CB enormously ameliorated the conductivity of the hybrid composites due to the formation of special conductive pathways in the matrix. The composite obtained showed good gas sensitivity in many organic vapors. The sensitivity was affected by the total amount and the ratio of VGCNF to CB in the matrix, and also by the thickness of the composite’s film. The gas sensitivity, upon exposure to vapors, of the composites containing the hybrid fillers is greater and more stable than that of the composites filled only with CB in vapors. These hybrid composites are very promising gas sensing materials and they can be used to make sensors to detect and discriminate many organic vapors.

[1]  M. Zhang,et al.  Two-Step Percolation in Polymer Blends Filled with Carbon Black , 1998 .

[2]  H. Toghiani,et al.  Nitric acid oxidation of vapor grown carbon nanofibers , 2004 .

[3]  Bin Zhang,et al.  Gas Sensing Materials from Carbon Black/Poly(Methyl Methacrylate) Composites , 2003 .

[4]  N. Tsubokawa,et al.  Responsibility of electric resistance of polyethyleneimine-grafted carbon black against alcohol vapor and humidity , 1997 .

[5]  Ming Wei Li,et al.  Gas sensitivity of carbon black/waterborne polyurethane composites , 2004 .

[6]  M. Zhang,et al.  Conductive polymer blends filled with carbon black: Positive temperature coefficient behavior , 1999 .

[7]  Masaru Yoshida,et al.  Novel vapor sensor from polymer-grafted carbon black: effects of heat-treatment and γ-ray radiation-treatment on the response of sensor material in cyclohexane vapor , 2002 .

[8]  Jack W. Judy,et al.  Micromachined polymer-based chemical gas sensor array , 2001 .

[9]  Charles U. Pittman,et al.  Ablation, mechanical and thermal conductivity properties of vapor grown carbon fiber/phenolic matrix composites , 2002 .

[10]  N. Tsubokawa,et al.  Novel gas sensor from polymer-grafted carbon black: Vapor response of electric resistance of conducting composites prepared from poly(ethylene-block-ethylene oxide)-grafted carbon black , 2000 .

[11]  Timothy D. Burchell,et al.  Carbon materials for advanced technologies , 1999 .

[12]  G. Tibbetts.  Carbon fibers produced by pyrolysis of natural gas in stainless steel tubes , 1983 .

[13]  M. Narkis,et al.  Sensors for liquids based on conductive immiscible polymer blends , 2000 .

[14]  N. Tsubokawa,et al.  Surface Grafting of Polyesters onto Carbon Nanofibers and Electric Properties of Conductive Composites Prepared from Polyester-grafted Carbon Nanofibers , 2004 .

[15]  M. Rong,et al.  Vapor-induced variation in electrical performance of carbon black/poly(methyl methacrylate) composites prepared by polymerization filling , 2003 .

[16]  N. Tsubokawa,et al.  A Novel Gas Sensor from Poly(ethylene glycol)-Grafted Carbon Black. Responsibility of Electric Resistance of Poly(ethylene glycol)- Grafted Carbon Black against Humidity and Solvent Vapor , 1999 .

[17]  N. Lewis,et al.  Use of compatible polymer blends to fabricate arrays of carbon black-polymer composite vapor detectors. , 1998, Analytical chemistry.

[18]  J. Ting,et al.  CHAPTER 5 – Vapor Grown Carbon Fiber Composites , 1999 .

[19]  Bin Zhang,et al.  Carbon black filled poly(2-ethylhexyl methacrylate) as a candidate for gas sensing material , 2003 .

[20]  M. Narkis,et al.  The role of a third component on the conductivity behavior of ternary epoxy/Ag conductive composites , 2002 .

[21]  M. Narkis,et al.  A preliminary investigation of conductive immiscible polymer blends as sensor materials , 2000 .

[22]  M. Narkis,et al.  Electrical and dielectric properties of segregated carbon black–polyethylene systems , 1990 .

[23]  H. Kroto,et al.  Pyrolytic carbon nanotubes from vapor-grown carbon fibers , 1995 .

[24]  Shannon E. Stitzel,et al.  Cross-reactive chemical sensor arrays. , 2000, Chemical reviews.

[25]  N. Tsubokawa,et al.  Electric Properties of Conducting Composite from Poly(ethylene oxide) and Poly(ethylene oxide)-Grafted Carbon Black in Solvent Vapor , 2000 .

[26]  Snyder,et al.  Geometrical percolation threshold of overlapping ellipsoids. , 1995, Physical review. E, Statistical physics, plasmas, fluids, and related interdisciplinary topics.

[27]  C. Carraher.  Seymour/Carraher's Polymer Chemistry, Seventh Edition , 2000 .

[28]  Danick Briand,et al.  A polymer gate FET sensor array for detecting organic vapours , 2001 .

[29]  Vijay K. Varadan,et al.  Carbon nanotube/PMMA composite thin films for gas-sensing applications , 2003 .

[30]  N S Lewis,et al.  Quantitative study of the resolving power of arrays of carbon black-polymer composites in various vapor-sensing tasks. , 1998, Analytical chemistry.

[31]  A. Oberlin,et al.  Filamentous growth of carbon through benzene decomposition , 1976 .