An experimental study of vertical pneumatic conveying

Abstract This study uses a one-dimensional equation system and experimental techniques to provide a comprehensive description of vertical gas–solid two-phase flow. The results from non-accelerating flow experiments conducted with a riser tube of bore 192 mm and height 16.2 m using spherical glass beads of average diameter 64 μm are presented. The solids volume fraction, which was measured directly using quick-closing valves, was less than 0.01 in all cases. The frictional pressure drop was recognised to be an important component of the total pressure gradient in the riser. At low gas velocities, negative frictional pressure gradients occurred. The solids friction factor was found to be constant at high solids velocities and decrease to negative values as the solids velocity was reduced. The slip velocity was found to be always greater than the single-particle terminal velocity and to increase with decreasing gas velocity or increasing solids mass flux. This is different to that which has usually been reported in literature, and is thought to be due to the large diameter of riser used in this study. In addition, the slip velocity increased (independently of solids mass flux) with increasing solids concentration.

[1]  Shigeru Matsumoto,et al.  Solid particle velocity in vertical gaseous suspension flows , 1986 .

[2]  F. A. Zenz,et al.  Two-Phase Fluid-Solid Flow , 1949 .

[3]  D. Pei,et al.  Particle Dynamics in Solids-Gas Flows in Vertical Pipe , 1969 .

[4]  Shozaburo Saito,et al.  PNEUMATIC CONVEYING OF SOLIDS THROUGH STRAIGHT PIPES , 1969 .

[5]  J. Yerushalmi,et al.  Further studies of the regimes of fluidization , 1979 .

[6]  Y. Yousfi,et al.  Aerodynamique de l'ecoulement vertical de suspensions concentrees gaz—solide—II. Chute de pression et vitesse relative gaz—solide , 1974 .

[7]  O. H. Hariu,et al.  Pressure Drop in Vertical Tubes in Transport of Solids by Gases , 1949 .

[8]  Jam Hans Kuipers,et al.  An engineering model for dilute riser flow , 1997 .

[9]  U. Arena,et al.  HIGH VELOCITY FLUIDIZATION BEHAVIOR OF SOLIDS IN A LABORATORY SCALE CIRCULATING BED , 1986 .

[10]  S. Stemerding,et al.  The pneumatic transport of cracking catalyst in vertical risers , 1962 .

[11]  L. Fan,et al.  Pressure fluctuations and choking criterion for vertical pneumatic conveying of fine particles , 1985 .

[12]  S. Sankar,et al.  Slip velocities in pneumatic transport part II , 1986 .

[13]  Donald F. Othmer,et al.  Fluidization and fluid-particle systems , 1960 .

[14]  K. Nakamura,et al.  Vertical pneumatic conveying: An experimental study with particles in the intermediate and turbulent flow regimes , 1973 .

[15]  John M. Matsen,et al.  Mechanisms of choking and entrainment , 1982 .

[16]  W.P.M. van Swaaij,et al.  Shear stresses on the wall of a dense gas—solids riser , 1970 .

[17]  Pertti Sarkomaa,et al.  Solids friction factors in upward, lean gas-solids flows , 1998 .