Computer Simulations of End-Tapering Anchorages of EBR FRP-Strengthened Prestressed Concrete Slabs at Service Conditions

This article examines numerically the behavior of prestressed reinforced concrete slabs strengthened with externally bonded reinforcement (EBR) consisting of fiber-reinforced polymer (FRP) sheets. The non-linear finite element (FE) program Abaqus® is used to model EBR FRP-strengthened prestressed concrete slabs tested previously in four-point bending. After the calibration of the computational models, a parametric study is then conducted to assess the influence of the FRP axial stiffness (thickness and modulus of elasticity) on the interfacial normal and shear stresses. The numerical analysis results show that increasing the thickness or the elastic modulus of the FRP strengthening affects the efficiency of the FRP bonding and makes it susceptible to earlier debonding failures. A tapering technique is proposed in wet lay-up applications since multiple FRP layers are often required. It is shown that by gradually decreasing the thickness of the FRP strengthening, the concentration of stress along the plate end can be reduced, and thus, the overall strengthening performance is maximized. The tapering is successful in reducing the bond stress concentrations by up to 15%, which can be sufficient to prevent concrete rip-off and peel-off debonding failure modes. This article contributes towards a better understanding of the debonding phenomena in FRP-strengthened elements in flexure and towards the development of more efficient computational tools to analyze such structures.

[1]  Mand Askar,et al.  Flexural and shear strengthening of reinforced concrete beams using FRP composites: A state of the art , 2022, Case Studies in Construction Materials.

[2]  F. Greco,et al.  A cohesive fracture model for predicting crack spacing and crack width in reinforced concrete structures , 2022, Engineering Failure Analysis.

[3]  Fabio P. Figueiredo,et al.  Experimental and numerical investigation on low-strength RC beams strengthened with side or bottom near surface mounted FRP rods , 2022, Structure and Infrastructure Engineering.

[4]  F. Greco,et al.  An investigation about debonding mechanisms in FRP-strengthened RC structural elements by using a cohesive/volumetric modeling technique , 2021, Theoretical and Applied Fracture Mechanics.

[5]  O. Chaallal,et al.  Non-linear finite-element investigation of the parameters affecting externally-bonded FRP flexural-strengthened RC beams , 2020 .

[6]  Fabio P. Figueiredo,et al.  Strengthening of damaged low strength concrete beams using PTMS or NSM techniques , 2020, Case Studies in Construction Materials.

[7]  J. Červenka,et al.  Uncertainty of the smeared crack model applied to RC beams , 2020 .

[8]  K. Pilakoutas,et al.  Bend Strength of FRP Bars: Experimental Investigation and Bond Modeling , 2017 .

[9]  Kypros Pilakoutas,et al.  Bond strength of short lap splices in RC beams confined with steel stirrups or external CFRP , 2015 .

[10]  Kypros Pilakoutas,et al.  Bond behaviour of substandard splices in RC beams externally confined with CFRP , 2014 .

[11]  L. Sneed,et al.  Review of Anchorage Systems for Externally Bonded FRP Laminates , 2013 .

[12]  Michael G. Oliva,et al.  Nonlinear finite element modeling of cracking at ends of pretensioned bridge girders , 2012 .

[13]  Usama Ebead,et al.  Flexural Strengthening of RC Beams with Externally Bonded CFRP Systems: Test Results and 3D Nonlinear FE Analysis , 2008 .

[14]  G. Camata,et al.  Experimental and nonlinear finite element studies of RC beams strengthened with FRP plates , 2007 .

[15]  Feng Liu,et al.  An experimental and numerical study of the effect of thickness and length of CFRP on performance of repaired reinforced concrete beams , 2006 .

[16]  Weiliang Jin,et al.  Behavior of preloaded RC beams strengthened with CFRP laminates , 2006 .

[17]  Maria M. Lopez,et al.  Sensitivity analysis of reinforced concrete beams strengthened with FRP laminates , 2006 .

[18]  Thomas Olofsson,et al.  Numerical analysis of concrete beams strengthened with CFRP: a study of anchorage lengths , 2005 .

[19]  Riadh Al-Mahaidi,et al.  Experimental investigation into flexural retrofitting of reinforced concrete bridge beams using FRP composites , 2004 .

[20]  Ashraf F. Ashour,et al.  Flexural strengthening of RC continuous beams using CFRP laminates , 2004 .

[21]  Hsuan-Teh Hu,et al.  Nonlinear finite element analysis of reinforced concrete beams strengthened by fiber-reinforced plastics , 2004 .

[22]  Scott T Smith,et al.  Intermediate crack-induced debonding in RC beams and slabs , 2003 .

[23]  Kypros Pilakoutas,et al.  Concrete beams with externally bonded flexural FRP-reinforcement: analytical investigation of debonding failure , 2003 .

[24]  D. Proverbs,et al.  Finite element modelling of concrete cover separation failure in FRP plated RC beams , 2003 .

[25]  Scott T Smith,et al.  FRP-strengthened RC beams. I: review of debonding strength models , 2002 .

[26]  Scott T Smith,et al.  Interfacial stresses in reinforced concrete beams bonded with a soffit plate: a finite element study , 2002 .

[27]  Björn Täljsten,et al.  STRENGTHENING OF BEAMS BY PLATE BONDING , 1997 .

[28]  A. Nanni,et al.  Behavior of Precracked RC Beams Strengthened with Carbon FRP Sheets , 1997 .