Experimental assessment of copper oxide for liquid chemical looping for thermal energy storage

Abstract The potential of copper oxide for both thermal energy storage and oxygen production in a liquid chemical looping thermal energy storage system has been assessed with thermogravimetric analysis. Liquid chemical looping thermal energy storage is a recently proposed system with potential to enable both the storage of thermal energy (through sensible heating, phase change and thermochemical reactions) and oxygen production. The process of isothermal reduction and oxidation of molten copper oxide was verified experimentally by heating the material isobarically, reducing or oxidising it isothermally, and then cooling it again isobarically. The isothermal reduction and oxidation reactions were achieved by varying the partial pressure of oxygen through the change in the concentrations of nitrogen and oxygen. This confirmed that copper oxide can be reduced in the liquid state by changing the partial pressure of oxygen in the system. Nevertheless, the extent of reduction in the assessed range of oxygen partial pressure in the liquid phase is approximately 2%, while this value in solid phase is approximately 10%, which implies that the thermochemical storage is mainly occurred in the solid phase. The reduction and oxidation cycles were repeated for 10 cycles. Superimposed on the cyclical weight change was an additional weight loss that was attribute to a side reaction between the copper oxide and alumina crucible.

[1]  Abraham Kribus,et al.  The DIAPR: A High-Pressure, High-Temperature Solar Receiver , 1997 .

[2]  K. Ishizaki,et al.  Reactions of Copper and Copper Oxides with Nitride Ceramics (AlN, SIALON, Si3N4) and Their Oxide Additives , 1992 .

[3]  Christian Sattler,et al.  Exploitation of thermochemical cycles based on solid oxide redox systems for thermochemical storage of solar heat. Part 1: Testing of cobalt oxide-based powders , 2014 .

[4]  M. A. Pio,et al.  Kinetics of CuO/SiO2 and CuO/Al2O3 oxygen carriers for chemical looping combustion , 2018 .

[5]  Christian Sattler,et al.  Exploitation of thermochemical cycles based on solid oxide redox systems for thermochemical storage of solar heat. Part 4: Screening of oxides for use in cascaded thermochemical storage concepts , 2016 .

[6]  G. Nathan,et al.  High temperature solar thermochemical process for production of stored energy and oxygen based on CuO/Cu2O redox reactions , 2017 .

[7]  Bassam B. Dally,et al.  Solar thermal hybrids for combustion power plant: A growing opportunity , 2018 .

[8]  Martin Schmücker,et al.  Metal oxides for thermochemical energy storage: A comparison of several metal oxide systems , 2016 .

[9]  S. Decterov,et al.  Critical assessment and thermodynamic modeling of the Cu–O and Cu–O–S systems , 2012 .

[10]  Jemila Habainy,et al.  Oxidation of Pure Tungsten in the Temperature Interval 400° to 900°C , 2013 .

[11]  G. Nathan,et al.  Thermodynamic potential of molten copper oxide for high temperature solar energy storage and oxygen production , 2017 .

[12]  G. Nathan,et al.  Comparing the thermodynamic potential of alternative liquid metal oxides for the storage of solar thermal energy , 2017 .

[13]  Claudio A. Estrada,et al.  First experimental studies of solar redox reactions of copper oxides for thermochemical energy storage , 2015 .

[14]  Antonio Peretto,et al.  Gas Turbine Based Power Cycles - A State-of-the-Art Review , 2007 .

[15]  Elias K. Stefanakos,et al.  Thermal energy storage technologies and systems for concentrating solar power plants , 2013 .

[16]  Behdad Moghtaderi,et al.  A review on high-temperature thermochemical energy storage based on metal oxides redox cycle , 2018, Energy Conversion and Management.

[17]  Peter Weinberger,et al.  High-Temperature Energy Storage: Kinetic Investigations of the CuO/Cu2O Reaction Cycle , 2017 .

[18]  J. D. Ford,et al.  Energy storage using the BaO2BaO reaction cycle , 1983 .

[19]  C. Sattler,et al.  Exploitation of thermochemical cycles based on solid oxide redox systems for thermochemical storage of solar heat. Part 2: Redox oxide-coated porous ceramic structures as integrated thermochemical reactors/heat exchangers , 2015 .

[20]  J. S. Dennis,et al.  The interaction between CuO and Al2O3 and the reactivity of copper aluminates below 1000 °C and their implication on the use of the Cu–Al–O system for oxygen storage and production , 2016 .

[21]  J. P. Neumann,et al.  The Cu−O (Copper-Oxygen) system , 1984 .