Three-Dimensional Grid Strut-and-Tie Model Approach in Structural Concrete Design

[1]  Y. Yun,et al.  An Indeterminate Strut-Tie Model and Load Distribution Ratio for RC Deep Beams - (I) Model & Load Distribution Ratio , 2011 .

[2]  Young-Mook Yun.  Effective Strength of Concrete Strut in Strut-Tie Model (I) - Methods for Determining Effective Strength of Concrete Strut - , 2005 .

[3]  Brian Uy,et al.  Performance-Based Optimization for Strut-Tie Modeling of Structural Concrete , 2002 .

[4]  Young Mook Yun,et al.  STRENGTH OF STRUTS AND NODES IN STRUT-TIE MODEL , 1996 .

[5]  Byung Hun Kim,et al.  Two-Dimensional Grid Strut-Tie Model Approach for Structural Concrete , 2008 .

[6]  Hong,et al.  Effect of Diagonal Cracking on the Strength of Concrete Strut in RC Members , 2005 .

[7]  Shyh-Jiann Hwang,et al.  SHEAR STRENGTH PREDICTION FOR DEEP BEAMS , 2000 .

[8]  Liang-Jenq Leu,et al.  Strut-and-Tie Design Methodology for Three-Dimensional Reinforced Concrete Structures , 2006 .

[9]  S. Emerson,et al.  AASHTO (American Association of State Highway and Transportation Officials). 2001. A Policy on Geometric Design of Highways and Streets. Fourth Edition. Washington, D.C. , 2007 .

[10]  Young Mook Yun.  NONLINEAR STRUT-TIE MODEL APPROACH FOR STRUCTURAL CONCRETE , 2000 .

[11]  Young Mook Yun,et al.  Strength of Two-Dimensional Nodal Zones in Strut–Tie Models , 2006 .

[12]  Hyo-Gyoung Kwak,et al.  Determination of Strut-and-Tie Models using Evolutionary Structural Optimization , 2002 .

[13]  E. P. Warnke,et al.  CONSTITUTIVE MODEL FOR THE TRIAXIAL BEHAVIOR OF CONCRETE , 1975 .

[14]  Sung-Gul Hong.  Strut-and-Tie Models and Failure Mechanisms for Bar Development in Tension-Tension-Compression Nodal Zone , 2000 .

[15]  P. G. Bakir,et al.  Mechanical behaviour and non-linear analysis of short beams using softened truss and direct strut & tie models , 2005 .

[16]  Yi Min Xie,et al.  Generating optimal strut-and-tie models in prestressed concrete beams by performance-based optimization , 2001 .

[17]  Richard N. White,et al.  Automatic Generation of Truss Model for Optimal Design of Reinforced Concrete Structures , 1998 .

[18]  Stephen J. Foster,et al.  EXPERIMENTAL STUDIES ON HIGH-STRENGTH CONCRETE DEEP BEAMS , 1998 .

[19]  Daniel A. Kuchma,et al.  COMPUTER-BASED TOOLS FOR DESIGN BY STRUT-AND-TIE METHOD: ADVANCES AND CHALLENGES , 2002 .