Effects of gasoline reactivity and ethanol content on boosted premixed and partially stratified low-temperature gasoline combustion (LTGC)

Low-temperature gasoline combustion (LTGC), based on the compression ignition of a premixed or partially premixed dilute charge, can provide thermal efficiencies (TE) and maximum loads comparable to those of turbo-charged diesel engines, and ultra-low NOx and particulate emissions. Intake boosting is key to achieving high loads with dilute combustion, and it also enhances the fuel's autoignition reactivity, reducing the required intake heating or hot residuals. These effects have the advantages of increasing TE and charge density, allowing greater timing retard with good stability, and making the fuel ϕ- sensitive so that partial fuel stratification (PFS) can be applied for higher loads and further TE improvements. However, at high boost the autoignition reactivity enhancement can become excessive, and substantial amounts of EGR are required to prevent overly advanced combustion. Accordingly, an experimental investigation has been conducted to determine how the tradeoff between the effects of intake boost varies with fuel-type and its impact on load range and TE. Five fuels are investigated: a conventional AKI=87 petroleum-based gasoline (E0), and blends of 10 and 20% ethanol with this gasoline to reduce its reactivity enhancement with boost (E10 and E20). A second zero-ethanol gasoline with AKI=93 (matching that of E20) was also investigated (CF-E0), and some neat ethanol data are also reported. Results show that ethanol content has little effect on LTGC autoignition reactivity for naturally aspirated operation, but it produces a large effect for boosted operation, with the reactivity enhancement with boost being reduced by an amount that correlates with ethanol content. In contrast, CFE0 showed a reactivity enhancement with boost similar to E0. Related to this autoignition enhancement, the effect of fuel-type on the increase in ITHR with boost was also investigated since it correlates with the ability to retard CA50 with good stability for higher loads without knock and to apply PFS effectively. The study showed that by adding ethanol, less EGR is required with boost, leaving more oxygen available for combustion. As a result, the high-load limit could be increased from 16.3 to 18.1 to 20.0 bar IMEPg for E0, E10, and E20, respectively, and to 17.7 bar for the high-AKI gasoline. TE vs. load curves for the various fuels at typical boosted conditions are also presented and discussed. At boosted conditions, PFS was found to be very effective for increasing the TE, with the peak TE increasing from 47.8% for premixed fueling to 48.4% with PFS, and TE improvements up to 2.8 %-units were achieved at higher loads.

[1]  John E. Dec,et al.  Boosted HCCI - Controlling Pressure-Rise Rates for Performance Improvements using Partial Fuel Stratification with Conventional Gasoline , 2011 .

[2]  John E. Dec,et al.  An Investigation of Thermal Stratification in HCCI Engines Using Chemiluminescence Imaging , 2006 .

[3]  Roald N. Leif,et al.  Detailed HCCI Exhaust Speciation and the Sources of Hydrocarbon and Oxygenated Hydrocarbon Emissions. , 2008 .

[4]  John E. Dec,et al.  Comparing late-cycle autoignition stability for single- and two-stage ignition fuels in HCCI engines , 2007 .

[5]  Mani Sarathy,et al.  Detailed Kinetic Modeling of Conventional Gasoline at Highly Boosted Conditions and the Associated Intermediate Temperature Heat Release , 2012 .

[6]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[7]  Wai K. Cheng,et al.  On HCCI Engine Knock , 2007 .

[8]  John E. Dec,et al.  Thermodynamic and Chemical Effects of EGR and Its Constituents on HCCI Autoignition. , 2007 .

[9]  J. Dec,et al.  Fuel Stratification for Low-Load HCCI Combustion: Performance & Fuel-PLIF Measurements , 2007 .

[10]  John E. Dec,et al.  Tailoring HCCI heat-release rates with partial fuel stratification: Comparison of two-stage and single-stage-ignition fuels , 2011 .

[11]  John E. Dec,et al.  Boosted HCCI for high power without engine knock and with ultra-low NOx emissions - Using conventional gasoline , 2010 .

[12]  John E. Dec,et al.  Investigating the Development of Thermal Stratification from the Near-Wall Regions to the Bulk-Gas in an HCCI Engine with Planar Imaging Thermometry , 2012 .

[13]  John E. Dec,et al.  A Parametric Study of HCCI Combustion - the Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection , 2003 .

[14]  R. H. Thring,et al.  Homogeneous-Charge Compression-Ignition (HCCI) Engines , 1989 .

[15]  John E. Dec,et al.  Investigation of the Sources of Combustion Noise in HCCI Engines , 2014 .

[16]  Scott B. Fiveland,et al.  Compression Ratio Influence on Maximum Load of a Natural Gas Fueled HCCI Engine , 2002 .

[17]  Samveg Saxena,et al.  Intermediate temperature heat release in an HCCI engine fueled by ethanol/n-heptane mixtures: An experimental and modeling study , 2014 .

[18]  Yuzo Aoyagi,et al.  The effect of knock on heat loss in homogeneous charge compression ignition engines , 2002 .

[19]  John E. Dec,et al.  An Investigation of the Relationship Between Measured Intake Temperature, BDC Temperature, and Combustion Phasing for Premixed and DI HCCI Engines , 2004 .

[20]  Michael Howard Shelby,et al.  Octane Numbers of Ethanol-Gasoline Blends: Measurements and Novel Estimation Method from Molar Composition , 2012 .

[21]  Per Risberg,et al.  A method of defining the auto-ignition quality of gasoline-like fuels in HCCI engines , 2003 .

[22]  Hanho Yun,et al.  Development of Robust Gasoline HCCI Idle Operation Using Multiple Injection and Multiple Ignition (MIMI) Strategy , 2009 .

[23]  J. Eng,et al.  Characterization of Pressure Waves in HCCI Combustion , 2002 .

[24]  Gary Kirkpatrick,et al.  Controlled Combustion in an IC-Engine with a Fully Variable Valve Train , 2001 .

[25]  John E. Dec,et al.  An investigation into lowest acceptable combustion temperatures for hydrocarbon fuels in HCCI engines , 2005 .

[26]  John E. Dec,et al.  Smoothing HCCI Heat-Release Rates Using Partial Fuel Stratification with Two-Stage Ignition Fuels , 2006 .

[27]  Chunsheng Ji,et al.  Effect of Ignition Improvers on the Combustion Performance of Regular-Grade E10 Gasoline in an HCCI Engine , 2014 .

[28]  Dennis N. Assanis,et al.  Comparing Enhanced Natural Thermal Stratification Against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates , 2004 .

[29]  Bengt Johansson,et al.  The Effect of Piston Topland Geometry on Emissions of Unburned Hydrocarbons from a Homogeneous Charge Compression Ignition (HCCI) Engine , 2001 .

[30]  Taro Aoyama,et al.  An experimental study on premixed-charge compression ignition gasoline engine , 1995 .

[31]  Bengt Johansson,et al.  Homogeneous Charge Compression Ignition (HCCI) Using Isooctane, Ethanol and Natural Gas - A Comparison with Spark Ignition Operation , 1997 .

[32]  William Cannella,et al.  Partial Fuel Stratification to Control HCCI Heat Release Rates: Fuel Composition and Other Factors Affecting Pre-Ignition Reactions of Two-Stage Ignition Fuels , 2011 .

[33]  Samveg Saxena,et al.  Fundamental phenomena affecting low temperature combustion and HCCI engines, high load limits and strategies for extending these limits , 2013 .

[34]  John E. Dec,et al.  Influence of Fuel Autoignition Reactivity on the High-Load Limits of HCCI Engines , 2008 .

[35]  Bengt Johansson,et al.  Demonstrating the Multi Fuel Capability of a Homogeneous Charge Compression Ignition Engine with Variable Compression Ratio , 1999 .

[36]  Takeshi Morikawa,et al.  Expanding the HCCI Operation With the Charge Stratification , 2004 .

[37]  Fabian Mauss,et al.  Supercharged Homogeneous Charge Compression Ignition , 1998 .

[38]  Tanet Aroonsrisopon,et al.  An Investigation Into the Effect of Fuel Composition on HCCI Combustion Characteristics , 2002 .

[39]  William Cannella,et al.  Boosted HCCI Combustion Using Low-Octane Gasoline with Fully Premixed and Partially Stratified Charges , 2012 .

[40]  John E. Dec,et al.  Energy Distribution Analysis in Boosted HCCI-like / LTGC Engines - Understanding the Trade-Offs to Maximize the Thermal Efficiency , 2015 .

[41]  Nicholas P. Cernansky,et al.  Potential of Thermal Stratification and Combustion Retard for Reducing Pressure-Rise Rates in HCCI Engines, Based on Multi-Zone Modeling and Experiments , 2005 .

[42]  N. Wermuth,et al.  Enhancing Light Load HCCI Combustion in a Direct Injection Gasoline Engine by Fuel Reforming During Recompression , 2009 .

[43]  John E. Dec,et al.  Spectroscopic and chemical-kinetic analysis of the phases of HCCI autoignition and combustion for single- and two-stage ignition fuels , 2008 .