Investigation of nematic liquid crystals as surface acoustic wave sensor coatings for discrimination between isomeric aromatic organic vapors

Abstract The use of thermotropic nematic liquid crystals (LC) as surface acoustic wave (SAW) vapor sensor coatings were investigated. Responses to four pairs of isomeric aromatic organic vapors were measured using two LC coatings and four isotropic polymer coatings. In most cases, the LC coatings showed higher sensitivity toward the more rod-like isomer within a pair due to the anisotropic nature of the deposited LC films. However, the importance of vapor-coating functional-group interactions as mediating factors in the sensor responses was evident in several cases. Incorporation of an LC coating into a four-sensor array improved the discrimination between isomers relative to an array employing only isotropic coatings. A persistent decline in the sensor baseline signal and vapor sensitivity observed over time with both LC coatings could be attributed to evaporative loss and/or changes in the elastic stiffness of the coatings.

[1]  T. Ikeda,et al.  Photochemical switching of polarization in ferroelectric liquid-crystal films , 1993, Nature.

[2]  M. Ward,et al.  In Situ Interfacial Mass Detection with Piezoelectric Transducers , 1990, Science.

[3]  Franz L. Dickert,et al.  The detection of halogenated hydrocarbons via host-guest chemistry―a mass-sensitive sensor study with QMB- and SAW-devices , 1991 .

[4]  Kenneth R. Beebe,et al.  Multicomponent analysis using an array of piezoelectric crystal sensors , 1987 .

[5]  A. Mierzwiński,et al.  Piezoelectric detectors coated with liquid-crystal materials. , 1987, Talanta.

[6]  P. Jurs,et al.  Detection of hazardous vapors including mixtures using pattern recognition analysis of responses from surface acoustic wave devices. , 1988, Analytical chemistry.

[7]  R. A. McGill,et al.  The predominant role of swelling-induced modulus changes of the sorbent phase in determining the responses of polymer-coated surface acoustic wave vapor sensors , 1992 .

[8]  J. Mccallum,et al.  Piezoelectric devices for mass and chemical measurements: an update. A review , 1989 .

[9]  E. Zellers,et al.  Characterization of polymeric surface acoustic wave sensor coatings and semiempirical models of sensor responses to organic vapors. , 1993, Analytical chemistry.

[10]  H. Wohltjen.  Mechanism of Operation and Design Considerations for Surface Acoustic Wave Device Vapor Sensors. , 1984 .

[11]  S. Wenzel,et al.  Computer modelling of polymer-coated ZnO/Si surface-acoustic-wave and lamb-wave chemical sensors , 1988 .

[12]  Effects of film morphology on the frequency and attenuation of a polymer-coated SAW device exposed to organic vapor , 1992 .

[13]  R. C. Weast.  CRC Handbook of Chemistry and Physics , 1973 .

[14]  J. Grate,et al.  Correlation of surface acoustic wave device coating responses with solubility properties and chemical structure using pattern recognition , 1986 .

[15]  Svante Wold,et al.  Pattern recognition by means of disjoint principal components models , 1976, Pattern Recognit..