A 3D analysis of oxygen transfer in a low-cost micro-bioreactor for animal cell suspension culture

A 3D numerical model was developed to study the flow field and oxygen transport in a micro-bioreactor with a rotating magnetic bar on the bottom to mix the culture medium. The Reynolds number (Re) was kept in the range of 100-716 to ensure laminar environment for animal cell culture. The volumetric oxygen transfer coefficient (k(L)a) was determined from the oxygen concentration distribution. It was found that the effect of the cell consumption on k(L)a could be negligible. A correlation was proposed to predict the liquid-phase oxygen transfer coefficient (k(Lm)) as a function of Re. The overall oxygen transfer coefficient (k(L)) was obtained by the two-resistance model. Another correlation, within an error of 15%, was proposed to estimate the minimum oxygen concentration to avoid cell hypoxia. By combination of the correlations, the maximum cell density, which the present micro-bioreactor could support, was predicted to be in the order of 10(12) cells m(-3). The results are comparable with typical values reported for animal cell growth in mechanically stirred bioreactors.

[1]  J Tramper,et al.  Shear sensitivity of animal cells from a culture-medium perspective. , 1998, Trends in biotechnology.

[2]  A. B. Metzner,et al.  Flow patterns in agitated vessels , 1960 .

[3]  Jpk Seville,et al.  Fluid trajectories in a stirred vessel of non-newtonian liquid using positron emission particle tracking , 2000 .

[4]  A. B. Metzner.  Agitation of non‐Newtonian fluids , 1957 .

[5]  G. Versteeg,et al.  The effect of diffusivity on gas-liquid mass transfer in stirred vessels. Experiments at atmospheric and elevated pressures , 1987 .

[6]  Frank Kensy,et al.  Oxygen transfer phenomena in 48-well microtiter plates: determination by optical monitoring of sulfite oxidation and verification by real-time measurement during microbial growth. , 2005, Biotechnology and bioengineering.

[7]  Gary J. Lye,et al.  Modelling surface aeration rates in shaken microtitre plates using dimensionless groups , 2005 .

[8]  R. Ballica,et al.  Rheological properties of mammalian cell culture suspensions: Hybridoma and HeLa cell lines , 1993, Biotechnology and bioengineering.

[9]  Y. Zeng,et al.  Fluid Dynamics of a Micro-Bioreactor for Tissue Engineering , 2005 .

[10]  K. Nakanishi,et al.  ON THE SPECIFIC RESISTANCE OF CAKES OF MICROORGANISMS , 1987 .

[11]  Y. Chisti,et al.  Hydrodynamic Damage to Animal Cells , 2001, Critical reviews in biotechnology.

[12]  Zhiming Zheng,et al.  EFFECT OF FLUID RHEOLOGICAL PROPERTIES ON MASS-TRANSFER IN A BIOREACTOR , 1995 .

[13]  Jyeshtharaj B. Joshi,et al.  Role of hydrodynamic shear in the cultivation of animal, plant and microbial cells , 1996 .

[14]  Elmar Heinzle,et al.  On-line oxygen uptake rate and culture viability measurement of animal cell culture using microplates with integrated oxygen sensors , 2004, Biotechnology Letters.

[15]  T. Wick,et al.  Computational Fluid Dynamics Modeling of Steady‐State Momentum and Mass Transport in a Bioreactor for Cartilage Tissue Engineering , 2002, Biotechnology progress.

[16]  Hermann Katinger,et al.  Scale-up engineering in animal cell technology: Part II , 1988 .

[17]  M. P. Escudier,et al.  Observations of the flow produced in a cylindrical container by a rotating endwall , 1984 .

[18]  H. Hikita,et al.  Physical Absorption in Agitated Vessels with a Flat Gas-Liquid Interface , 1969 .

[19]  V. Linek,et al.  Chemical Engineering Use of Catalyzed Sulfite Oxidation Kinetics for the Determination of Mass Transfer Characteristics of Gas-Liquid Contactors , 1981 .

[20]  D Weuster-Botz,et al.  Development, parallelization, and automation of a gas-inducing milliliter-scale bioreactor for high-throughput bioprocess design (HTBD). , 2005, Biotechnology and bioengineering.

[21]  Xiufen Li,et al.  Effect of solution chemistry on membrane resistance and flux decline , 2002 .

[22]  A. Nienow,et al.  CFD Study of Homogenization with Dual Rushton Turbines—Comparison with Experimental Results: Part I: Initial Studies☆ , 2000 .

[23]  A H Emery,et al.  Plant cell suspension culture rheology , 1993, Biotechnology and bioengineering.

[24]  George Keith Batchelor,et al.  An Introduction to Fluid Dynamics. , 1969 .

[25]  Timothy J. Barth,et al.  The design and application of upwind schemes on unstructured meshes , 1989 .

[26]  S. Nagata.  Mixing: Principles and Applications , 1975 .

[27]  J. Büchs,et al.  Characterization of gas-liquid mass transfer phenomena in microtiter plates. , 2003, Biotechnology and bioengineering.

[28]  Jian-Jiang Zhong,et al.  Effect of mixing time on taxoid production using suspension cultures of Taxus chinensis in a centrifugal impeller bioreactor. , 2002, Journal of bioscience and bioengineering.

[29]  Alvin W. Nienow,et al.  CFD Study of Homogenization with Dual Rushton Turbines—Comparison with Experimental Results: Part II: The Multiple Reference Frame☆ , 2000 .

[30]  G. Rao,et al.  Low-cost microbioreactor for high-throughput bioprocessing. , 2001, Biotechnology and bioengineering.

[31]  W. J. Beek,et al.  The oxidation of aqueous sodium sulphite solutions , 1973 .

[32]  Ralf Pörtner,et al.  Determination of dissolved CO(2) concentration and CO(2) production rate of mammalian cell suspension culture based on off-gas measurement. , 2002, Journal of biotechnology.

[33]  Serafim D. Vlaev,et al.  A 3-D Analysis of Gas-Liquid Mixing, Mass Transfer and Bioreaction in a Stirred Bio-Reactor , 2001 .

[34]  Feng Chen,et al.  Mixotrophic and heterotrophic growth of Haematococcus lacustris and rheological behaviour of the cell suspensions , 1997 .

[35]  M. Toner,et al.  Analysis of Oxygen Transport to Hepatocytes in a Flat-Plate Microchannel Bioreactor , 2001, Annals of Biomedical Engineering.

[36]  J. P. V. Doormaal,et al.  ENHANCEMENTS OF THE SIMPLE METHOD FOR PREDICTING INCOMPRESSIBLE FLUID FLOWS , 1984 .

[37]  Alvin W. Nienow,et al.  On flow close to cavern boundaries in yield stress fluids , 1994 .

[38]  Hu Zhang,et al.  Computational‐fluid‐dynamics (CFD) analysis of mixing and gas–liquid mass transfer in shake flasks , 2005, Biotechnology and applied biochemistry.

[39]  Robert Hermann,et al.  Methods for Intense Aeration, Growth, Storage, and Replication of Bacterial Strains in Microtiter Plates , 2000, Applied and Environmental Microbiology.

[40]  A. Nienow.  Hydrodynamics of Stirred Bioreactors , 1998 .