Enhanced aeroelastic energy harvesting with a beam stiffener

In this article, we propose an easy but quite effective method to significantly enhance the power generation capability of an aeroelastic energy harvester. The method is to attach a beam stiffener to the substrate of the harvester, which works as an electromechanical coupling magnifier. It is shown to be effective for all three considered types of harvesters based on galloping, vortex-induced vibration and flutter, leading to a superior performance over the conventional designs without the beam stiffener, with dozens of times the increase in power and an almost 100% increase in the power extraction efficiency yet with comparable or even smaller transverse displacement. Choice guidelines of optimal types of energy harvesters are also suggested based on the given wind situations where the electronic device is located.

[1]  Amin Bibo,et al.  Investigation of Concurrent Energy Harvesting from Ambient Vibrations and Wind , 2013 .

[2]  Dewey H. Hodges,et al.  Introduction to Structural Dynamics and Aeroelasticity: Contents , 2002 .

[3]  Ephrahim Garcia,et al.  Toward efficient aeroelastic energy harvesting: device performance comparisons and improvements through synchronized switching , 2013, Smart Structures.

[4]  Lihua Tang,et al.  Enhanced piezoelectric galloping energy harvesting using 2 degree-of-freedom cut-out cantilever with magnetic interaction , 2014 .

[5]  Alper Erturk,et al.  Electroaeroelastic analysis of airfoil-based wind energy harvesting using piezoelectric transduction and electromagnetic induction , 2013 .

[6]  Andrew J. Kurdila,et al.  Identification and Control of Limit Cycle Oscillations in Aeroelastic Systems , 1999 .

[7]  Mohammed F. Daqaq,et al.  On the optimal performance and universal design curves of galloping energy harvesters , 2014 .

[8]  Hao Wu,et al.  Synchronized charge extraction for aeroelastic energy harvesting , 2014, Smart Structures.

[9]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[10]  Yaowen Yang,et al.  A nonlinear piezoelectric energy harvester with magnetic oscillator , 2012 .

[11]  Muhammad R. Hajj,et al.  Modeling and nonlinear analysis of piezoelectric energy harvesting from transverse galloping , 2013 .

[12]  Lihua Tang,et al.  Equivalent Circuit Representation and Analysis of Galloping-Based Wind Energy Harvesting , 2015, IEEE/ASME Transactions on Mechatronics.

[13]  Mustafa Arafa,et al.  Cantilevered Piezoelectric Energy Harvester With a Dynamic Magnifier , 2012 .

[14]  Daniel J. Inman,et al.  On the energy harvesting potential of piezoaeroelastic systems , 2010 .

[15]  T. Theodorsen.  General Theory of Aerodynamic Instability and the Mechanism of Flutter , 1934 .

[16]  Yaowen Yang,et al.  Comparative study of tip cross-sections for efficient galloping energy harvesting , 2013 .

[17]  Abdessattar Abdelkefi,et al.  Theoretical modeling and nonlinear analysis of piezoelectric energy harvesting from vortex-induced vibrations , 2014 .

[18]  Yiannis Andreopoulos,et al.  The performance of a self-excited fluidic energy harvester , 2012 .

[19]  Junyi Cao,et al.  Broadband tristable energy harvester: Modeling and experiment verification , 2014 .

[20]  E. de Langre,et al.  Coupling of Structure and Wake Oscillators in Vortex-Induced Vibrations , 2004 .

[21]  Matthew Bryant,et al.  Modeling and Testing of a Novel Aeroelastic Flutter Energy Harvester , 2011 .

[22]  Jayant Sirohi,et al.  Piezoelectric wind energy harvester for low-power sensors , 2011 .

[23]  Yaowen Yang,et al.  Comparison of modeling methods and parametric study for a piezoelectric wind energy harvester , 2013 .

[24]  A. Barrero-Gil,et al.  Energy harvesting from transverse galloping , 2010 .

[25]  Norbert Schwesinger,et al.  Generation of electrical energy using short piezoelectric cantilevers in flowing media , 2009, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[26]  Daniel J. Inman,et al.  A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters , 2008 .