Delayed hydride cracking assessment of PWR spent fuel during dry storage

Abstract One of the possible degradation mechanisms of PWR spent fuel cladding is delayed hydride cracking (DHC), which can activate within a relatively low temperature range. Due to the high crack growth rate, it is essential to prevent DHC crack growth, but most of the existing DHC studies have focused on the crack growth rate. In this regard, the values and characteristics of the threshold stress intensity factor (SIF) for PWR Zircaloy-4 cladding were described as assessment criteria of DHC. Based on the limited existing test results and analyses, threshold SIF and applied SIF were evaluated. In addition, the possibilities of degradation by DHC were discussed during long-term dry storage. From the analysis with conservative approaches, DHC does not largely contribute to cladding failure. For a more reliable analysis, additional information on spent fuel is needed.

[1]  K. McCoy.  HYDRIDE-RELATED DEGRADATION OF SNF CLADDING UNDER REPOSITORY CONDITIONS , 2000 .

[2]  T. Kubo,et al.  Determination of fracture strength of δ-zirconium hydrides embedded in zirconium matrix at high temperatures , 2013 .

[3]  J. Chakravartty,et al.  DELAYED HYDRIDE CRACKING IN ZIRCALOY FUEL CLADDING - AN IAEA COORDINATED RESEARCH PROGRAMME , 2009 .

[4]  Mahesh D. Pandey,et al.  A probabilistic approach to update lower bound threshold stress intensity factor (KIH) for delayed hydride cracking , 2010 .

[5]  A. Zieliński,et al.  Hydrogen-enhanced degradation and oxide effects in zirconium alloys for nuclear applications , 2011 .

[6]  Y. Kim,et al.  The Effect of Microstructure on Delayed Hydride Cracking Behavior of Zircaloy-4 Fuel Cladding — An International Atomic Energy Agency Coordinated Research Program , 2010 .

[7]  K. Chan.  An assessment of delayed hydride cracking in zirconium alloy cladding tubes under stress transients , 2013 .

[8]  E. Siegmann.  Clad Degradation - FEPs Screening Arguments , 2004 .

[9]  S. Shi,et al.  Criteria for fracture initiation at hydrides in zirconium alloys I. Sharp crack tip , 1994 .

[10]  Ching-Kong Chao,et al.  Rupture of spent fuel Zircaloy cladding in dry storage due to delayed hydride cracking , 2008 .

[11]  P. Raynaud,et al.  Cladding stress during extended storage of high burnup spent nuclear fuel , 2015 .

[12]  Douglas A. Scarth,et al.  Flaw Evaluation Procedures and Acceptance Criteria for Nuclear Piping in ASME Code Section XI , 2003 .

[13]  S. Shi,et al.  Dependence of the threshold stress intensity factor on hydrogen concentration during delayed hydride cracking in zirconium alloys , 1995 .

[14]  Yutaka Matsuo,et al.  Thermal Creep of Zircaloy-4 Cladding under Internal Pressure , 1987 .

[15]  Y. Cheong,et al.  A model of the threshold stress intensity factor, KIH, for delayed hydride cracking of Zr–2.5Nb alloy , 2000 .

[16]  K. D. Seager,et al.  A method for determining the spent-fuel contribution to transport cask containment requirements , 1992 .

[17]  C. Chao,et al.  Hydride effect on crack instability of Zircaloy cladding , 2014 .

[18]  Fredric A. Simonen,et al.  Enhanced ASME Section XI Appendix L Flaw Tolerance Procedure , 2005 .