Lithographic fabrication of point contact with Al2O3 rear-surface-passivated and ultra-thin Cu(In,Ga)Se2 solar cells

Abstract Atomic layer deposition of Al2O3 was used to fabricate rear surface passivation with lithographed point contact Cu(In,Ga)Se2 (CIGS) solar cells. We successfully demonstrated the use of photolithography to fabricate point contact holes of small size and fine pitch. The efficiency of the Al2O3 rear-surface-passivated ultra-thin CIGS solar cells with absorber layers of 1.89 μm and with a 5-nm-thick Al2O3 rear surface passivation layer and local point contact holes with a pitch of 1 μm and a diameter of 500 nm was 19.3% (total area = 0.519 cm2). The efficiency of the Al2O3 rear-surface-passivated ultra-thin CIGS solar cells with absorber layers of 380 nm was 11.3% (active area = 0.514 cm2) when an antireflection layer was used. Compare with unpassivated CIGS solar cells, higher efficiencies were found for the Al2O3 rear-surface-passivated CIGS solar cells, mainly due to the reduced carrier recombination and enhanced rear internal light reflection.

[1]  A. Cuevas,et al.  Very low bulk and surface recombination in oxidized silicon wafers , 2002 .

[2]  M. Green,et al.  Characterization of 23-percent efficient silicon solar cells , 1990 .

[3]  Mark Kerr,et al.  Surface recombination velocity of phosphorus-diffused silicon solar cell emitters passivated with plasma enhanced chemical vapor deposited silicon nitride and thermal silicon oxide , 2001 .

[4]  Jonathan Joel,et al.  On the assessment of CIGS surface passivation by photoluminescence , 2015 .

[5]  Denis Flandre,et al.  Highly reflective rear surface passivation design for ultra-thin Cu(In,Ga)Se2 solar cells , 2015 .

[6]  Wmm Erwin Kessels,et al.  Ultralow surface recombination of c-Si substrates passivated by plasma-assisted atomic layer deposited Al2O3 , 2006 .

[7]  Rommel Noufi,et al.  HIGH-EFFICIENCY CUINXGA1-XSE2 SOLAR CELLS MADE FROM (INX,GA1-X)2SE3 PRECURSOR FILMS , 1994 .

[8]  Philip Jackson,et al.  Effects of heavy alkali elements in Cu(In,Ga)Se2 solar cells with efficiencies up to 22.6% , 2016 .

[9]  Christophe Ballif,et al.  Model for a-Si: H/c-Si interface recombination based on the amphoteric nature of silicon dangling bonds , 2007 .

[10]  Denis Flandre,et al.  Investigating the electronic properties of Al2O3/Cu(In,Ga)Se2 interface , 2015 .

[11]  P. Fons,et al.  In situ deposition rate monitoring during the three-stage-growth process of Cu(In,Ga)Se2 absorber films , 2003 .

[12]  Waqar Ahmed,et al.  Thermal annealing of flash evaporated Cu(In, Ga)Se2 thin films , 1998 .

[13]  S. Nishiwaki,et al.  Preparation of Cu(In,Ga)Se_2 thin films from In–Ga–Se precursors for high-efficiency solar cells , 1999 .

[14]  M. Young,et al.  The effect of Mo back contact on Na out-diffusion and device performance of Mo/Cu(In,Ga)Se/sub 2//CdS/ZnO solar cells , 2002, Conference Record of the Twenty-Ninth IEEE Photovoltaic Specialists Conference, 2002..

[15]  Marika Edoff,et al.  Improved Rear Surface Passivation of Cu(In,Ga)Se$_{\bf 2}$ Solar Cells: A Combination of an Al$_{\bf 2}$O $_{\bf 3}$ Rear Surface Passivation Layer and Nanosized Local Rear Point Contacts , 2014, IEEE Journal of Photovoltaics.

[16]  Characterization of Cu(InGa)Se2 Solar Cells using Etched Absorber Layers , 2006, 2006 IEEE 4th World Conference on Photovoltaic Energy Conference.

[17]  Robert Mertens,et al.  Approach for Al2O3 rear surface passivation of industrial p‐type Si PERC above 19% , 2012 .

[18]  S. Sung,et al.  Effects of annealing on structural and electrical properties of sub-micron thick CIGS films , 2013 .

[19]  Chih-Wen Liu,et al.  Surface passivation of Cu(In,Ga)Se2 using atomic layer deposited Al2O3 , 2012 .

[20]  M. Green,et al.  24% efficient PERL structure silicon solar cells , 1990, IEEE Conference on Photovoltaic Specialists.

[21]  D. Lincot,et al.  Thinning of CIGS solar cells: Part II: Cell characterizations , 2011 .

[22]  Marika Edoff,et al.  Development of rear surface passivated Cu(In,Ga)Se2 thin film solar cells with nano-sized local rear point contacts , 2013 .

[23]  Wmm Erwin Kessels,et al.  Status and prospects of Al2O3-based surface passivation schemes for silicon solar cells , 2012 .