High-efficiency, high-step-up DC-DC convertor for fuel-cell generation system

Because of the electrochemical reaction, fuel cell has the power quality of low voltage and high current. However, a fuel-cell stack with high output voltage is difficult to fabricate and it may fail when any single cell is inactive. In addition, the output voltage is varied easily with respect to the load variation. To satisfy the requirement for a high voltage, a high-efficiency DC–DC convertor with high voltage gain is one of the essential mechanisms in fuel-cell applications. A newly designed high-step-up DC–DC convertor utilised in the proton-exchange-membrane fuel cell (PEMFC) system is constructed on the basis of voltage-clamped and soft-switching techniques for alleviating the switching and conduction losses, to increase further the conversion efficiency. Moreover, the closed-loop-control methodology is utilised in the proposed scheme to overcome the voltage-drift problem of the fuel cell under load variation. Some experimental results via a PEMFC power source of 250 W nominal rating are given to demonstrate the effectiveness of the proposed power-conversion strategy.

[1]  Ivo Barbi,et al.  Isolated DC-DC converters with high-output voltage for TWTA telecommunication satellite applications , 2003 .

[2]  Saifur Rahman,et al.  Two-loop controller for maximizing performance of a grid-connected photovoltaic-fuel cell hybrid power plant , 1998 .

[3]  B. Cook,et al.  Introduction to fuel cells and hydrogen technology , 2002 .

[4]  Daniel W. Hart,et al.  Introduction to Power Electronics , 1996 .

[5]  K. Y. Lee,et al.  An Explicit Dynamic Model for Direct Reforming Carbonate Fuel Cell Stack , 2001, IEEE Power Engineering Review.

[6]  Marcelo Godoy Simões,et al.  Simulation of fuel-cell stacks using a computer-controlled power rectifier with the purposes of actual high-power injection applications , 2003 .

[7]  Arthur F. Witulski,et al.  Introduction to modeling of transformers and coupled inductors , 1995 .

[8]  J. E. Harry,et al.  Electronic power supplies for high-density discharge (HID) lamps , 2000 .

[9]  A. Boudghene Stambouli,et al.  Fuel cells, an alternative to standard sources of energy , 2002 .

[10]  Fred C. Lee,et al.  High-efficiency, high step-up DC-DC converters , 2003 .

[11]  M. Matsumura,et al.  Development of an internal reforming molten carbonate fuel cell stack , 1995 .

[12]  Humberto Pinheiro,et al.  Zero-current and zero-voltage soft-transition commutation cell for PWM inverters , 2004 .

[13]  Milan M. Jovanovic,et al.  A new ZVS-PWM full-bridge converter , 2003 .

[14]  Ashoka K. S. Bhat,et al.  A zero-voltage transition boost converter using a zero-voltage switching auxiliary circuit , 2002 .

[15]  Kwang Y. Lee,et al.  Development of a stack simulation model for control study on direct reforming molten carbonate fuel cell power plant , 1999 .

[16]  J. C. Wilson,et al.  Future power sources for mobile communications , 2001 .

[17]  Douglas J. Nelson,et al.  Fuel cell systems: efficient, flexible energy conversion for the 21st century , 2001, Proc. IEEE.