Design of electronic systems based on functional capability

An important measure of design quality is the extent to which a circuit design is able to meets its specification in the presence of component parameter variations. Of equal importance is knowing how to improve this capability most effectively. This paper presents an analysis technique and visualization method which give the designer information about design quality and possible routes to improved quality. The paper introduces two new measures of functional capability, based on the process capability measure Cpk, and shows how these may be linked to the statistical variations in individual component parameters. It then shows how this information may be used to assess the effectiveness of altering the nominal value and variability in each of the component parameters in order to improve circuit performance capability. The analysis required is straightforward and the information is presented in a clear manner which can readily be interpreted by the designer. The effectiveness of the technique has been evaluated through analysis of a number of printed circuit board level analogue and mixed signal circuits and the results of a case study are shown. Copyright © 2007 John Wiley & Sons, Ltd.

[1]  S W Field,et al.  Effecting a Quality Change , 1996 .

[2]  D. H. Stamatis,et al.  Failure Mode and Effect Analysis (FMEA) , 2002 .

[3]  I. M. Bell,et al.  Circuit Design Optimization Based on Quality Cost Estimation , 2005 .

[4]  Sani R. Nassif,et al.  A Methodology for Worst-Case Analysis of Integrated Circuits , 1986, IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems.

[5]  Sammy G. Shina.  Six Sigma for Electronics Design and Manufacturing , 2002 .

[6]  P. J. Rankin,et al.  Efficient tolerance analysis using control variates , 1985 .

[7]  Douglas C. Montgomery,et al.  PROCESS CAPABILITY INDICES AND NON-NORMAL DISTRIBUTIONS , 1996 .

[8]  G. Hachtel.  The simplicial approximation approach to design centering , 1977 .

[9]  Nicholas R. Farnum,et al.  USING JOHNSON CURVES TO DESCRIBE NON-NORMAL ROCESS DATA , 1996 .

[10]  Don Clausing,et al.  Total Quality Development , 1993 .

[11]  D. H. Stamatis,et al.  Failure Mode and Effect Analysis , 1995 .

[12]  Ka-Ho Leung,et al.  Idealized statistical models for low-cost linear circuit yield analysis , 1977 .

[13]  R Batchelor,et al.  Conformability Analysis in Support of Design for Quality , 1996 .

[14]  Marco Lovera,et al.  Application of non-normal process capability indices to semiconductor quality control , 1998, ICMTS 1998.

[15]  K.-H. Leung,et al.  Efficient statistical circuit analysis , 1974 .

[16]  Ian M. Bell,et al.  Design, manufacture and test-quality cost estimation , 2002, Proceedings International Symposium on Quality Electronic Design.

[17]  Alan Mathewson,et al.  Relating statistical MOSFET model parameter variabilities to IC manufacturing process fluctuations enabling realistic worst case design , 1994 .

[18]  Robert Spence,et al.  Tolerance Design of Electronic Circuits , 1997 .