A new single end wideband impedance based fault location scheme for distribution systems

Abstract This paper proposes an improved impedance based fault location scheme based on system analysis at non-fundamental frequencies. The fault is treated as a voltage source that injects high frequency components into the system and the analysis is carried out using these injected components. The proposed method only requires local measurements at the substation and therefore is classified as a single end method. The new contribution is that the proposed method uses the distributed parameter line model to account for inductive and capacitive effects of the line. It has been evaluated on the IEEE 34-bus feeder which is based on an actual distribution system which has the typical features such as non-homogeneous feeder sections, asymmetrical line configurations, unbalanced loads and single and three-phase laterals. The fault point, fault resistance and fault inception angle have been varied to check their influence on the accuracy of the method. The simulation results demonstrate the accuracy of the proposed method where for most cases, the error in fault location is less than 50 m.