1.32 μm InAs/InGaAs/GaAs quantum dot lasers operating at room temperature with low threshold current density

We report on the growth and characterization of low threshold 1.32-μm quantum dots (QDs) laser diodes. The quantum dot active region was optimised to get the highest photoluminescence emission and the lowest Full Width at Half Maximum (FWHM). From samples containing multilayer QDs and using the Limited-Area Photoluminescence (LAPL) technique we have shown that the gain of an N-layer structure is higher than N times that of a single layer. This enhancement is attributed to the increase of the quantum dot density in the upper layers and also to the use of the high growth temperature spacer layer. Broad area laser diodes were processed from the grown samples containing three layers of InAs QDs grown directly on GaAs and capped with 4-nm-thick InxGa1-xAs layer. Than measurements were performed at room temperature under pulsed excitation. The laser diodes operate at room temperature and emit between 1.29 and 1.32-μm which is beyond the strategic telecommunication wavelength. The characteristic temperature is around 80 K and very stable in the hole range of the operating temperature (from 0 to 90 °C). The internal quantum efficiency is 53% and the modal gain per QD layer was estimated to be ~ 6 cm-1. For an infinite cavity length a threshold current density of 8 A/cm2 per QD layer was obtained. From the calculation of the optical confinement of QDs, we have estimated a material gain of 1979 cm-1.

[1]  Mikhail V. Maximov,et al.  High-power 1.3μm InAs/GaInAs/GaAs QD lasers grown in a multiwafer MBE production system , 2005 .

[2]  F. Kadlec,et al.  Optical two-photon absorption in GaAs measured by optical pump-terahertz probe spectroscopy , 2004, Infrared and Millimeter Waves, Conference Digest of the 2004 Joint 29th International Conference on 2004 and 12th International Conference on Terahertz Electronics, 2004..

[3]  Anders Larsson,et al.  Optimisation of MBE growth conditions for InAs quantum dots on (001) GaAs for 1.3 μm luminescence , 2001 .

[4]  Nikolai N. Ledentsov,et al.  High external differential efficiency and high optical gain of long-wavelength quantum dot diode laser , 2003 .

[5]  Kristian M. Groom,et al.  Improved performance of 1.3μm multilayer InAs quantum-dot lasers using a high-growth-temperature GaAs spacer layer , 2004 .

[6]  Nikolai N. Ledentsov,et al.  Gain characteristics of quantum dot injection lasers , 1999 .

[7]  M. Asada,et al.  Gain and the threshold of three-dimensional quantum-box lasers , 1986 .

[8]  Kristian M. Groom,et al.  Influences of the spacer layer growth temperature on multilayer InAs∕GaAs quantum dot structures , 2004 .

[9]  Nikolai N. Ledentsov,et al.  Quantum dot heterostructures , 1999 .

[10]  Mikhail V. Maximov,et al.  High power temperature-insensitive 1.3 µm InAs/InGaAs/GaAs quantum dot lasers , 2005 .

[11]  J. Lee,et al.  Dependence of the InAs size distribution on the stacked layer number for vertically stacked InAs/GaAs quantum dots , 2002 .

[12]  G. Guillot,et al.  MBE growth optimization and optical spectroscopy of InAs/GaAs quantum dots emitting at 1.3 μm in single and stacked layers , 2005 .

[13]  James L. Merz,et al.  Excited-state radiative lifetimes in self-assembled quantum dots obtained from state-filling spectroscopy , 1999 .

[14]  Dieter Bimberg,et al.  Many-body effects on the optical spectra of InAs/GaAs quantum dots , 2000 .

[15]  Ray Murray,et al.  Indium segregation during multilayer InAs/GaAs(001) quantum dot formation , 2005 .